這個考古題包含了實際考試中一切可能出現的問題。所以，只要你好好學習這個考古題，那麼通過350-401最新考證考試就不再是難題了。你現在正在為了尋找Cisco的350-401最新考證認證考試的優秀的資料而苦惱嗎？不用再擔心了，這裏就有你最想要的東西。 Goldmile-Infobiz Cisco的350-401最新考證考試培訓資料是所有的互聯網培訓資源裏最頂尖的培訓資料，我們的知名度度是很高的，這都是許多考生利用了Goldmile-Infobiz Cisco的350-401最新考證考試培訓資料所得到的成果，如果你也使用我們Goldmile-Infobiz Cisco的350-401最新考證考試培訓資料，我們可以給你100%成功的保障，若是沒有通過，我們將保證退還全部購買費用，為了廣大考生的切身利益，我們Goldmile-Infobiz絕對是信的過的。 这是经过很多人证明过的事实。
也有關於Cisco 350-401最新考證認證考試的考試練習題和答案。
我們為您提供PDF版本的和軟件版，還有在線測試引擎題庫，其中350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)最新考證軟件版本的題庫，可以模擬真實的考試環境，以滿足大家的需求，這是最優秀的350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)最新考證學習資料。 Goldmile-Infobiz的產品是為你們參加Cisco 新版 350-401 題庫認證考試而準備的。Goldmile-Infobiz提供的培訓資料不僅包括與Cisco 新版 350-401 題庫認證考試相關的資訊技術培訓資料，來鞏固專業知識，而且還有準確性很高的關於Cisco 新版 350-401 題庫的認證考試的相關考試練習題和答案。
Goldmile-Infobiz提供的培訓工具包含關於Cisco 350-401最新考證認證考試的學習資料及類比訓練題，更重要的是還會給出跟考試很接近的練習題和答案。選擇Goldmile-Infobiz可以保證你可以在短時間內學習及加強IT專業方面的知識，還可以以高分數通過Cisco 350-401最新考證的認證考試。
Cisco 350-401最新考證 - 如果你考試失敗，我們會全額退款給你。
作為IT相關認證考試大綱的主要供應商，Goldmile-Infobiz的IT專家一直不斷地提供品質較高的產品，不斷為客戶提供免費線上客戶服務，並以最快的速度更新考試大綱。
這樣花少量的時間和金錢換取如此好的結果，是值得的。快將Goldmile-Infobiz提供的培訓工具放入你的購物車中吧。
350-401 PDF DEMO:
QUESTION NO: 1
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
QUESTION NO: 2
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.
QUESTION NO: 3
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.
QUESTION NO: 4
What is the difference between a RIB and a FIB?
A. The FIB is populated based on RIB content
B. The RIB is used to make IP source prefix-based switching decisions
C. The RIB maintains a mirror image of the FIB
D. The FIB is where all IP routing information is stored
Answer: A
Explanation:
CEF uses a Forwarding Information Base (FIB) to make IP destination prefix-based switching decisions.
The FIB is conceptually similar to a routing table or information base. It maintains a mirror image of the forwarding information contained in the IP routing table. When routing or topology changes occur in the network, the IP routing table is updated, and those changes are reflected in the FIB. The
FIB maintains next-hop address information based on the information in the IP routing table. Because there is a one-to-one correlation between FIB entries and routing table entries, the FIB contains all known routes and eliminates the need for route cache maintenance that is associated with earlier switching paths such as fast switching and optimum switching.
Note: In order to view the Routing information base (RIB) table, use the "show ip route" command.
To view the Forwarding Information Base (FIB), use the "show ip cef" command. RIB is in Control plane while FIB is in Data plane.
QUESTION NO: 5
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.
我們的Cisco SAP C_BCBAI_2509 認證考試培訓資料很受客戶歡迎，這是Goldmile-Infobiz的專家團隊勤勞勞動的結果。 親愛的廣大考生，你有沒有想過參與任何Cisco的Microsoft MS-102-KR考試的培訓課程嗎？其實你可以採取措施一次通過認證，Goldmile-Infobiz Cisco的Microsoft MS-102-KR考試題培訓資料是個不錯的選擇，本站虛擬的網路集訓和使用課程包涵大量你們需要的考題集，完全可以讓你們順利通過認證。 ISTQB ISTQB-CTFL - 為了保證你的權益，Goldmile-Infobiz承諾一次不過，將退還購買費用。 Genesys GCP-GCX - 我們Goldmile-Infobiz網站的培訓資料是沒有網站可以與之比較的。 因為我們Goldmile-Infobiz提供給你配置最優質的類比Cisco的Microsoft PL-600的考試考古題，將你一步一步帶入考試準備之中，我們Goldmile-Infobiz提供我們的保證，我們Goldmile-Infobiz Cisco的Microsoft PL-600的考試試題及答案保證你成功。
Updated: May 28, 2022