比賽是這樣，同樣考試也是這樣的。有很多人因為沒有充分的時間準備考試從而放棄了參加IT認證考試。但是，如果使用了好的資料，即使只有很短的時間來準備，你也完全可以以高分通過考試。 想通過Cisco 350-401證照考試 認證考試考試嗎？快將Goldmile-Infobiz的Cisco 350-401證照考試認證考試的最新練習題及答案加入你的購物車吧！Goldmile-Infobiz已經在網站上為你免費提供部分Cisco 350-401證照考試 認證考試的練習題和答案，你可以免費下載作為嘗試。相信你對我們的產品會很滿意的。 但是，和考試的重要性一樣，這個考試也是非常難的。
CCNP Enterprise 350-401 所以，你很有必要選擇一個高效率的考試參考資料。
你已經看到Goldmile-Infobiz Cisco的350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)證照考試考試認證培訓資料，是時候做出選擇了，你甚至可以選擇其他的產品，不過你要知道我們Goldmile-Infobiz帶給你的無限大的利益，也只有Goldmile-Infobiz能給你100%保證成功，Goldmile-Infobiz能讓你有個美好的前程，讓你以後在IT行業有更寬廣的道路可以走，高效率的工作在資訊技術領域。 通過客戶的完全信任，我們為考生提供真實有效的訓練，幫助大家在第一次Cisco 350-401 權威考題考試中順利通過。Goldmile-Infobiz提供高品質的最佳學習資料，讓通過Cisco 350-401 權威考題考試從未如此快速、便宜、和簡單。
我們都知道，在互聯網普及的時代，需要什麼資訊那是非常簡單的事情，不過缺乏的是品質及適用性的問題。許多人在網路上搜尋Cisco的350-401證照考試考試認證培訓資料，卻不知道該如何去相信，在這裏，我向大家推薦Goldmile-Infobiz Cisco的350-401證照考試考試認證培訓資料，它在互聯網上點擊率購買率好評率都是最高的，Goldmile-Infobiz Cisco的350-401證照考試考試認證培訓資料有部分免費的試用考題及答案，你們可以先試用後決定買不買，這樣就知道Goldmile-Infobiz所有的是不是真實的。
Cisco 350-401證照考試 - 使用Goldmile-Infobiz你可以很快獲得你想要的證書。
Cisco的認證考試最近越來越受到大家的歡迎了。IT認證考試有很多種。你參加過哪一個考試呢？比如350-401證照考試等很多種考試。這些都是很重要的考試，你想參加哪一個呢？我們在這裏說一下350-401證照考試認證考試。如果你想參加這個考試，那麼Goldmile-Infobiz的350-401證照考試考古題可以幫助你輕鬆通過考試。
Goldmile-Infobiz是能確保你100%的通過Cisco 350-401證照考試的認證考試。Goldmile-Infobiz是個一直為你提供最新最準確的Cisco 350-401證照考試認證考試相關資料的網站。
350-401 PDF DEMO:
QUESTION NO: 1
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.
QUESTION NO: 2
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.
QUESTION NO: 3
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
QUESTION NO: 4
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.
QUESTION NO: 5
What is the difference between a RIB and a FIB?
A. The FIB is populated based on RIB content
B. The RIB is used to make IP source prefix-based switching decisions
C. The RIB maintains a mirror image of the FIB
D. The FIB is where all IP routing information is stored
Answer: A
Explanation:
CEF uses a Forwarding Information Base (FIB) to make IP destination prefix-based switching decisions.
The FIB is conceptually similar to a routing table or information base. It maintains a mirror image of the forwarding information contained in the IP routing table. When routing or topology changes occur in the network, the IP routing table is updated, and those changes are reflected in the FIB. The
FIB maintains next-hop address information based on the information in the IP routing table. Because there is a one-to-one correlation between FIB entries and routing table entries, the FIB contains all known routes and eliminates the need for route cache maintenance that is associated with earlier switching paths such as fast switching and optimum switching.
Note: In order to view the Routing information base (RIB) table, use the "show ip route" command.
To view the Forwarding Information Base (FIB), use the "show ip cef" command. RIB is in Control plane while FIB is in Data plane.
想參加SISA CSPAI認證考試嗎？想取得SISA CSPAI認證資格嗎？沒有充分準備考試的時間的你應該怎麼通過考試呢？其實也並不是沒有辦法，即使只有很短的準備考試的時間你也可以輕鬆通過考試。 Goldmile-Infobiz也會不斷提升更新我們提供的Cisco IIBA CPOA 認證考試資料，來滿足您的需求。 您可以隨時隨地在任何設備上使用Cisco CompTIA CAS-005題庫，簡單易操作，并且如果您購買我們的考古題，還將享受一年的免費更新服務。 你只需要獲得Goldmile-Infobiz提供的Cisco APICS CSCP認證考試的練習題和答案做模擬測試，您是可以順利通過Cisco APICS CSCP 認證考試的。 我們的IT團隊致力于提供真實的Cisco Ping Identity PAP-001題庫問題和答案，所有購買我們Ping Identity PAP-001題庫的客戶都將獲得長達一年的免費更新，確保考生有足夠的時間學習。
Updated: May 28, 2022