Besides, our 200-301 Pdf exam questions will help you pass the exam and get the certification for sure. You will face plenty of options in your whole lives. Sometimes, you must decisively abandon some trivial things, and then you can harvest happiness and fortunes. Goldmile-Infobiz provide you with 100% free up-dated 200-301 Pdf study material for 356 days after complete purchase. The 200-301 Pdf updated dumps reflects any changes related to the actual test. Besides, the exam practice questions and answers have wide coverage of the content of the examination and the correct rate is up to 100%.
CCNA 200-301 In every area, timing counts importantly.
CCNA 200-301 Pdf - Cisco Certified Network Associate Exam If you are an IT staff, it will be your indispensable training materials. Our experts check whether there is an update on the Cisco Certified Network Associate Exam exam questions every day, if an update system is sent to the customer automatically. If you have any question about our Braindumps 200-301 Torrent test guide, you can email or contact us online.
And don't worry about how to pass the test, Goldmile-Infobiz certification training will be with you. What is your dream? Don't you want to make a career? The answer must be ok. Then, you need to upgrade and develop yourself.
Our Cisco 200-301 Pdf exam guide are cost-effective.
The whole world of 200-301 Pdf preparation materials has changed so fast in the recent years because of the development of internet technology. We have benefited a lot from those changes. In order to keep pace with the development of the society, we also need to widen our knowledge. If you are a diligent person, we strongly advise you to try our 200-301 Pdf real test. You will be attracted greatly by our 200-301 Pdf practice engine. .
The 200-301 Pdf practice questions that are best for you will definitely make you feel more effective in less time. The cost of 200-301 Pdf studying materials is really very high.
200-301 PDF DEMO:
QUESTION NO: 1
Refer to the exhibit. C-router is to be used as a "router-on-a-stick" to route between the
VLANs.
All the interfaces have been properly configured and IP routing is operational. The hosts in the VLANs have been configured with the appropriate default gateway.
What is true about this configuration?
A. These commands need to be added to the configuration:
C-router(config)# router rip
C-router(config-router)# network 172.19.0.0
B. These commands need to be added to the configuration:
C-router(config)# router ospf 1
C-router(config-router)# network 172.19.0.0 0.0.3.255 area 0
C. These commands need to be added to the configuration:
C-router(config)# router eigrp 123
C-router(config-router)# network 172.19.0.0
D. No further routing configuration is required.
Answer: D
Explanation:
Since all the same router (C-router) is the default gateway for all three VLANs, all traffic destined to a different VLAN will be sent to the C-router. The C-router will have knowledge of all three networks since they will appear as directly connected in the routing table. Since the C-router already knows how to get to all three networks, no routing protocols need to be configured.
QUESTION NO: 2
Which statement about Link Aggregation when implemented on a Cisco Wireless LAN
Controller is true?
A. One functional physical port is needed to pass client traffic
B. The EtherChannel must be configured in "mode active"
C. When enabled the WLC bandwidth drops to 500 Mbps
D. To pass client traffic two or more ports must be configured.
Answer: A
Explanation:
Link aggregation (LAG) is a partial implementation of the 802.3ad port aggregation standard. It bundles all of the controller's distribution system ports into a single 802.3ad port channel.
Restriction for Link aggregation:
- LAG requires the EtherChannel to be configured for `mode on' on both the controller and the
Catalyst switch -> Answer B is not correct.
- If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller -> Answer A is not correct while answer D is correct.
Reference: https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/ b_cg75_chapter_0100010.html
QUESTION NO: 3
A router running EIGRP has learned the same route from two different paths. Which parameter does the router use to select the best path?
A. administrative distance
B. as-path
C. metric
D. cost
Answer: C
Explanation:
If a router learns two different paths for the same network from the same routing protocol, it has to decide which route is better and will be placed in the routing table. Metric is the measure used to decide which route is better (lower number is better). Each routing protocol uses its own metric.
For example, RIP uses hop counts as a metric, while OSPF uses cost.
https://study-ccna.com/administrative-distance-metric/
QUESTION NO: 4
Drag and Drop Question
Drag and drop the WLAN components from the left onto the correct descriptions on the right.
Answer:
Explanation:
The service port can be used management purposes, primarily for out-of-band management.
However, AP management traffic is not possible across the service port. In most cases, the service port is used as a "last resort" means of accessing the controller GUI for management purposes. For example, in the case where the system distribution ports on the controller are down or their communication to the wired network is otherwise degraded.
A dynamic interface with the Dynamic AP Management option enabled is used as the tunnel source for packets from the controller to the access point and as the destination for CAPWAP packets from the access point to the controller.
The virtual interface is used to support mobility management, Dynamic Host Configuration Protocol
(DHCP) relay, and embedded Layer 3 security such as guest web authentication. It also maintains the
DNS gateway host name used by Layer 3 security and mobility managers to verify the source of certificates when Layer 3 web authorization is enabled.
Reference: https://www.cisco.com/c/en/us/td/docs/wireless/controller/8-5/config- guide/b_cg85/ports_and_interfaces.html
QUESTION NO: 5
Which two tasks must be performed to configure NTP to a trusted server in client mode on a single network device? (Choose two)
A. Verify the time zone.
B. Disable NTP broadcasts
C. Set the NTP server private key
D. Specify the IP address of the NTP server
E. Enable NTP authentication.
Answer: D,E
Explanation:
To configure authentication, perform this task in privileged mode:
Step 1: Configure an authentication key pair for NTP and specify whether the key will be trusted or untrusted.
Step 2: Set the IP address of the NTP server and the public key.
Step 3: Enable NTP client mode.
Step 4: Enable NTP authentication.
Step 5: Verify the NTP configuration.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst4000/8-
2glx/configuration/guide/ ntp.html
Genesys GCP-GCX - You never know what you can get till you try. There is a lot of data to prove that our Cisco 350-501 practice guide has achieved great success. Moreover, we have experts to update Microsoft PL-400 quiz torrent in terms of theories and contents according to the changeable world on a daily basis, which can ensure that you are not falling behind of others by some slight knowledge gaps. Salesforce Salesforce-MuleSoft-Developer-I - Since the childhood, we seem to have been studying and learning seems to take part in different kinds of the purpose of the test, at the same time, we always habitually use a person's score to evaluate his ability. So many our customers have benefited form our SAP C-S4CPR-2508 preparation quiz, so will you!
Updated: May 28, 2022