Everyone has the potential to succeed, the key is what kind of choice you have. Only to find ways to success, do not make excuses for failure. To pass the Cisco 200-301 Plan exam, in fact, is not so difficult, the key is what method you use. In such a way, you can confirm that you get the convenience and fast. By studying with our 200-301 Plan real exam for 20 to 30 hours, we can claim that you can get ready to attend the 200-301 Planexam. Goldmile-Infobiz's Cisco 200-301 Plan exam training materials are absolutely trustworthy.
At present, Cisco 200-301 Plan exam is very popular.
The results of your 200-301 - Cisco Certified Network Associate Exam Plan exam will be analyzed and a statistics will be presented to you. As long as you master these questions and answers, you will sail through the exam you want to attend. Whatever exam you choose to take, Goldmile-Infobiz training dumps will be very helpful to you.
To better understand our 200-301 Plan preparation questions, you can also look at the details and the guarantee. So it is convenient for you to have a good understanding of our product before you decide to buy our 200-301 Plan training materials. Before the clients buy our 200-301 Plan guide prep they can have a free download and tryout.
Cisco 200-301 Plan - The talent is everywhere in modern society.
Customer first, service first is our principle of service. If you buy our 200-301 Plan study guide, you will find our after sale service is so considerate for you. We are glad to meet your all demands and answer your all question about our 200-301 Plan training materials. So do not hesitate and buy our 200-301 Plan study guide, we believe you will find surprise from our products. you should have the right to enjoy the perfect after sale service and the high quality products!
Goldmile-Infobiz pdf real questions and answers can prevent you from wasting lots of time and efforts on preparing for the exam and can help you sail through you exam with ease and high efficiency. But even you fail the exam, we assure we will give you FULL REFUND.
200-301 PDF DEMO:
QUESTION NO: 1
Which network allows devices to communicate without the need to access the Internet?
A. 209.165.201.0/24
B. 192.0.0.0/8
C. 172.28.0.0/16
D. 1729.0.0/16
Answer: C
Explanation:
This question asks about the private ranges of IPv4 addresses. The private ranges of each class of IPv4 are listed below:
Class A private IP address ranges from 10.0.0.0 to 10.255.255.255 Class B private IP address ranges from 172.16.0.0 to 172.31.255.255 Class C private IP address ranges from 192.168.0.0 to
192.168.255.255 Only the network 172.28.0.0/16 belongs to the private IP address (of class B).
QUESTION NO: 2
Which set of action satisfy the requirement for multi-factor authentication?
A. The user enters a user name and password and then re-enters the credentials on a second screen
B. The user swipes a key fob, then clicks through an email link
C. The user enters a user name and password, and then clicks a notification in an authentication app on a mobile device
D. The user enters a PIN into an RSA token, and then enters the displayed RSA key on a login screen
Answer: C
Explanation:
This is an example of how two-factor authentication (2FA) works:
1. The user logs in to the website or service with their username and password.
2. The password is validated by an authentication server and, if correct, the user becomes eligible for the second factor.
3. The authentication server sends a unique code to the user's second-factor method (such as a smartphone app).
4. The user confirms their identity by providing the additional authentication for their second-factor method.
QUESTION NO: 3
A router running EIGRP has learned the same route from two different paths. Which parameter does the router use to select the best path?
A. administrative distance
B. as-path
C. metric
D. cost
Answer: C
Explanation:
If a router learns two different paths for the same network from the same routing protocol, it has to decide which route is better and will be placed in the routing table. Metric is the measure used to decide which route is better (lower number is better). Each routing protocol uses its own metric.
For example, RIP uses hop counts as a metric, while OSPF uses cost.
https://study-ccna.com/administrative-distance-metric/
QUESTION NO: 4
Refer to the exhibit. C-router is to be used as a "router-on-a-stick" to route between the
VLANs.
All the interfaces have been properly configured and IP routing is operational. The hosts in the VLANs have been configured with the appropriate default gateway.
What is true about this configuration?
A. These commands need to be added to the configuration:
C-router(config)# router rip
C-router(config-router)# network 172.19.0.0
B. These commands need to be added to the configuration:
C-router(config)# router ospf 1
C-router(config-router)# network 172.19.0.0 0.0.3.255 area 0
C. These commands need to be added to the configuration:
C-router(config)# router eigrp 123
C-router(config-router)# network 172.19.0.0
D. No further routing configuration is required.
Answer: D
Explanation:
Since all the same router (C-router) is the default gateway for all three VLANs, all traffic destined to a different VLAN will be sent to the C-router. The C-router will have knowledge of all three networks since they will appear as directly connected in the routing table. Since the C-router already knows how to get to all three networks, no routing protocols need to be configured.
QUESTION NO: 5
Which statement about Link Aggregation when implemented on a Cisco Wireless LAN
Controller is true?
A. One functional physical port is needed to pass client traffic
B. The EtherChannel must be configured in "mode active"
C. When enabled the WLC bandwidth drops to 500 Mbps
D. To pass client traffic two or more ports must be configured.
Answer: A
Explanation:
Link aggregation (LAG) is a partial implementation of the 802.3ad port aggregation standard. It bundles all of the controller's distribution system ports into a single 802.3ad port channel.
Restriction for Link aggregation:
- LAG requires the EtherChannel to be configured for `mode on' on both the controller and the
Catalyst switch -> Answer B is not correct.
- If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller -> Answer A is not correct while answer D is correct.
Reference: https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/ b_cg75_chapter_0100010.html
There is no exaggeration that you can be confident about your coming exam just after studying with our Esri EGMP_2025 preparation materials for 20 to 30 hours. There will be one version right for you and help you quickly pass the Huawei H20-614_V1.0 with ease, so that you can obtain the most authoritative international recognition on your IT ability. We know that the standard for most workers become higher and higher; so we also set higher goal on our Salesforce MC-101 guide questions. All that we have done is just to help you easily pass the SAP C-THR81-2505 exam. If you want to have a better understanding of our Snowflake GES-C01 exam braindumps, just come and have a try!
Updated: May 28, 2022