Now just make up your mind and get your 200-301 Test Dumps exam dumps! You don't need to worry about wasting your precious time but failing to get the 200-301 Test Dumps certification. Many people have used our 200-301 Test Dumps study materials and the pass rate of the exam is 99%. Time is so important to everyone because we have to use our limited time to do many things. Especially for candidates to take the 200-301 Test Dumps exam, time is very precious. You can see the demos which are part of the all titles selected from the test bank and the forms of the questions and answers and know the form of our software on the website pages of our 200-301 Test Dumps study materials.
CCNA 200-301 While it is not truth.
Cisco 200-301 - Cisco Certified Network Associate Exam Test Dumps authentication certificate is the dream IT certificate of many people. About choosing the perfect 200-301 Valid Study Guide Questions study material, it may be reflected in matters like quality, prices, after-sale services and so on. 200-301 Valid Study Guide Questions exam simulation is accumulation of knowledge about the exam strictly based on the syllabus of the exam.
So Goldmile-Infobiz a website worthy of your trust. Please select Goldmile-Infobiz, you will be the next successful IT person. Goldmile-Infobiz will help you achieve your dream.
Cisco 200-301 Test Dumps - And you will find every version is charming.
Are you racking your brains for a method how to pass Cisco 200-301 Test Dumps exam? Cisco 200-301 Test Dumps certification test is one of the valuable certification in modern IT certification. Within the last few decades, IT got a lot of publicity and it has been a necessary and desirable part of modern life. Cisco certification has been well recognized by international community. So, most IT people want to improve their knowledge and their skills by Cisco certification exam. 200-301 Test Dumps test is one of the most important exams and the certificate will bring you benefits.
Perhaps you worry about the quality of our 200-301 Test Dumps exam questions. We can make solemn commitment that our 200-301 Test Dumps study materials have no mistakes.
200-301 PDF DEMO:
QUESTION NO: 1
Refer to the exhibit. C-router is to be used as a "router-on-a-stick" to route between the
VLANs.
All the interfaces have been properly configured and IP routing is operational. The hosts in the VLANs have been configured with the appropriate default gateway.
What is true about this configuration?
A. These commands need to be added to the configuration:
C-router(config)# router rip
C-router(config-router)# network 172.19.0.0
B. These commands need to be added to the configuration:
C-router(config)# router ospf 1
C-router(config-router)# network 172.19.0.0 0.0.3.255 area 0
C. These commands need to be added to the configuration:
C-router(config)# router eigrp 123
C-router(config-router)# network 172.19.0.0
D. No further routing configuration is required.
Answer: D
Explanation:
Since all the same router (C-router) is the default gateway for all three VLANs, all traffic destined to a different VLAN will be sent to the C-router. The C-router will have knowledge of all three networks since they will appear as directly connected in the routing table. Since the C-router already knows how to get to all three networks, no routing protocols need to be configured.
QUESTION NO: 2
Which statement about Link Aggregation when implemented on a Cisco Wireless LAN
Controller is true?
A. One functional physical port is needed to pass client traffic
B. The EtherChannel must be configured in "mode active"
C. When enabled the WLC bandwidth drops to 500 Mbps
D. To pass client traffic two or more ports must be configured.
Answer: A
Explanation:
Link aggregation (LAG) is a partial implementation of the 802.3ad port aggregation standard. It bundles all of the controller's distribution system ports into a single 802.3ad port channel.
Restriction for Link aggregation:
- LAG requires the EtherChannel to be configured for `mode on' on both the controller and the
Catalyst switch -> Answer B is not correct.
- If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller -> Answer A is not correct while answer D is correct.
Reference: https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/ b_cg75_chapter_0100010.html
QUESTION NO: 3
A router running EIGRP has learned the same route from two different paths. Which parameter does the router use to select the best path?
A. administrative distance
B. as-path
C. metric
D. cost
Answer: C
Explanation:
If a router learns two different paths for the same network from the same routing protocol, it has to decide which route is better and will be placed in the routing table. Metric is the measure used to decide which route is better (lower number is better). Each routing protocol uses its own metric.
For example, RIP uses hop counts as a metric, while OSPF uses cost.
https://study-ccna.com/administrative-distance-metric/
QUESTION NO: 4
Drag and Drop Question
Drag and drop the WLAN components from the left onto the correct descriptions on the right.
Answer:
Explanation:
The service port can be used management purposes, primarily for out-of-band management.
However, AP management traffic is not possible across the service port. In most cases, the service port is used as a "last resort" means of accessing the controller GUI for management purposes. For example, in the case where the system distribution ports on the controller are down or their communication to the wired network is otherwise degraded.
A dynamic interface with the Dynamic AP Management option enabled is used as the tunnel source for packets from the controller to the access point and as the destination for CAPWAP packets from the access point to the controller.
The virtual interface is used to support mobility management, Dynamic Host Configuration Protocol
(DHCP) relay, and embedded Layer 3 security such as guest web authentication. It also maintains the
DNS gateway host name used by Layer 3 security and mobility managers to verify the source of certificates when Layer 3 web authorization is enabled.
Reference: https://www.cisco.com/c/en/us/td/docs/wireless/controller/8-5/config- guide/b_cg85/ports_and_interfaces.html
QUESTION NO: 5
Which two tasks must be performed to configure NTP to a trusted server in client mode on a single network device? (Choose two)
A. Verify the time zone.
B. Disable NTP broadcasts
C. Set the NTP server private key
D. Specify the IP address of the NTP server
E. Enable NTP authentication.
Answer: D,E
Explanation:
To configure authentication, perform this task in privileged mode:
Step 1: Configure an authentication key pair for NTP and specify whether the key will be trusted or untrusted.
Step 2: Set the IP address of the NTP server and the public key.
Step 3: Enable NTP client mode.
Step 4: Enable NTP authentication.
Step 5: Verify the NTP configuration.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst4000/8-
2glx/configuration/guide/ ntp.html
Microsoft PL-400 - Goldmile-Infobiz is your best choice on the market today and is recognized by all candidates for a long time. Before you choose to end your practices of the SCDM CCDM study materials, the screen will display the questions you have done, which help you check again to ensure all questions of SCDM CCDM practice prep are well finished. ACAMS CAMS - The one is PDF version and another is SOFT version. HP HPE3-CL02 - In addition, the software version is not limited to the number of the computer. Our target is to reduce your pressure and improve your learning efficiency from preparing for Microsoft MS-700 exam.
Updated: May 28, 2022