350-401 Mock Exams - Cisco Valid Implementing Cisco Enterprise Network Core Technologies 350-401 Encor Test Duration - Goldmile-Infobiz

You will get your hands on the international 350-401 Mock Exams certificate you want. Perhaps you can ask the people around you that 350-401 Mock Exams study engine have really helped many people pass the exam. Of course, you can also experience it yourself. Although the 350-401 Mock Exams exam is an exam to test your mastery of the knowledge of 350-401 Mock Exams, but there are so many factor to influence the result. As long as you choose our 350-401 Mock Exams exam materials, you never have to worry about this problem. All 350-401 Mock Exams study materials you should know are written in them with three versions to choose from: the PDF, Software and APP online versions.

CCNP Enterprise 350-401 Sharp tools make good work.

You will have 100% confidence to participate in the exam and disposably pass Cisco certification 350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR) Mock Exams exam. Hope you can give our Reliable 350-401 Test Labs exam questions full trust, we will not disappoint you. And with our Reliable 350-401 Test Labs study materials, you are bound to pass the exam.

Goldmile-Infobiz's providing training material is very close to the content of the formal examination. Through our short-term special training You can quickly grasp IT professional knowledge, and then have a good preparation for your exam. We promise that we will do our best to help you pass the Cisco certification 350-401 Mock Exams exam.

Cisco 350-401 Mock Exams - As old saying goes, knowledge is wealth.

The community has a lot of talent, people constantly improve their own knowledge to reach a higher level. But the country's demand for high-end IT staff is still expanding, internationally as well. So many people want to pass Cisco 350-401 Mock Exams certification exam. But it is not easy to pass the exam. However, in fact, as long as you choose a good training materials to pass the exam is not impossible. We Goldmile-Infobiz Cisco 350-401 Mock Exams exam training materials in full possession of the ability to help you through the certification. Goldmile-Infobiz website training materials are proved by many candidates, and has been far ahead in the international arena. If you want to through Cisco 350-401 Mock Exams certification exam, add the Goldmile-Infobiz Cisco 350-401 Mock Exams exam training to Shopping Cart quickly!

If you are still hesitate to choose our Goldmile-Infobiz, you can try to free download part of Cisco 350-401 Mock Exams exam certification exam questions and answers provided in our Goldmile-Infobiz. So that you can know the high reliability of our Goldmile-Infobiz.

350-401 PDF DEMO:

QUESTION NO: 1
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.

QUESTION NO: 2
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.

QUESTION NO: 3
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D

QUESTION NO: 4
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.

QUESTION NO: 5
Which standard access control entry permits from odd-numbered hosts in the 10.0.0.0/24 subnet?
A. Permit 10.0.0.0.255.255.255.254
B. Permit 10.0.0.1.0.0.0.254
C. Permit 10.0.0.1.0.0.0.0
D. Permit 10.0.0.0.0.0.0.1
Answer: B
Explanation:
Remember, for the wildcard mask, 1's are I DON'T CARE, and 0's are I CARE. So now let's analyze a simple ACL:
access-list 1 permit 172.23.16.0 0.0.15.255
Two first octets are all 0's meaning that we care about the network 172.23.x.x. The third octet of the wildcard mask, 15 (0000 1111 in binary), means that we care about first 4 bits but don't care about last 4 bits so we allow the third octet in the form of 0001xxxx (minimum:00010000 = 16; maximum:
0001111 = 31).
The fourth octet is 255 (all 1 bits) that means I don't care.
Therefore network 172.23.16.0 0.0.15.255 ranges from 172.23.16.0 to 172.23.31.255.
Now let's consider the wildcard mask of 0.0.0.254 (four octet: 254 = 1111 1110) which means we only care the last bit. Therefore if the last bit of the IP address is a "1" (0000 0001) then only odd numbers are allowed. If the last bit of the IP address is a "0" (0000 0000) then only even numbers are allowed.
Note: In binary, odd numbers are always end with a "1" while even numbers are always end with a
"0".
Therefore in this question, only the statement "permit 10.0.0.1 0.0.0.254" will allow all odd- numbered hosts in the 10.0.0.0/24 subnet.

SAP C_S4CPB_2508 - One is PDF, and other is software, it is easy to download. You can free download part of practice questions and answers of Cisco certification Microsoft MD-102 exam online as a try. Amazon AWS-Developer-KR - I think that for me is nowhere in sight. Microsoft SC-100 - Many people think that passing some difficult IT certification exams needs to be proficient in much of IT expertise and only these IT personnels who grasp the comprehensive IT knowledge would be able to enroll in the exam. Microsoft DP-900-KR - Our training materials, including questions and answers, the pass rate can reach 100%.

Updated: May 28, 2022