For most users, access to the relevant qualifying examinations may be the first, so many of the course content related to qualifying examinations are complex and arcane. According to these ignorant beginners, the 350-401 Questions Fee exam questions set up a series of basic course, by easy to read, with corresponding examples to explain at the same time, the Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR) study question let the user to be able to find in real life and corresponds to the actual use of learned knowledge, deepened the understanding of the users and memory. Simple text messages, deserve to go up colorful stories and pictures beauty, make the 350-401 Questions Fee test guide better meet the zero basis for beginners, let them in the relaxed happy atmosphere to learn more useful knowledge, more good combined with practical, so as to achieve the state of unity. We have always been made rapid progress on our 350-401 Questions Fee training materials because of the merits of high-efficiency and perfect after-sales services online for 24 hours. Studying with our 350-401 Questions Fee actual exam, you can get the most professional information and achieve your dreaming scores by your first go. Therefore, getting the test 350-401 Questions Fee certification is of vital importance to our future employment.
CCNP Enterprise 350-401 As old saying goes, all roads lead to Rome.
Many people worry about buying electronic products on Internet, like our 350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR) Questions Fee preparation quiz, we must emphasize that our 350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR) Questions Fee simulating materials are absolutely safe without viruses, if there is any doubt about this after the pre-sale, we provide remote online guidance installation of our 350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR) Questions Fee exam practice. Then you can go to everywhere without carrying your computers. For it also supports the offline practice.
We will simplify the complex concepts by adding diagrams and examples during your study. By choosing our 350-401 Questions Fee test material, you will be able to use time more effectively than others and have the content of important information in the shortest time. Because our 350-401 Questions Fee exam torrent is delivered with fewer questions but answer the most important information to allow you to study comprehensively, easily and efficiently.
Cisco 350-401 Questions Fee - So there is no matter of course.
Do you want to get a better job or a higher income? If the answer is yes, then you should buy our 350-401 Questions Fee exam questions for our 350-401 Questions Fee study materials can help you get what you want. Go against the water and retreat if you fail to enter. The pressure of competition is so great now. If you are not working hard, you will lose a lot of opportunities! There is no time, quickly purchase 350-401 Questions Fee study materials, pass the exam! Come on!
In traditional views, 350-401 Questions Fee practice materials need you to spare a large amount of time on them to accumulate the useful knowledge may appearing in the real exam. However, our 350-401 Questions Fee learning questions are not doing that way.
350-401 PDF DEMO:
QUESTION NO: 1
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.
QUESTION NO: 2
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.
QUESTION NO: 3
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.
QUESTION NO: 4
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D
QUESTION NO: 5
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
Salesforce Analytics-Con-301 exam prep sincerely hopes that you can achieve your goals and realize your dreams. Amazon SAP-C02-KR - And we have become a famous brand for we have engaged in this career. The existence of our Microsoft SC-300 learning guide is regarded as in favor of your efficiency of passing the exam. The profession of our experts is expressed in our Microsoft MS-700-KR training prep thoroughly. Microsoft DP-600 - And we will send you the new updates if our experts make them freely.
Updated: May 28, 2022