You can use the questions and answers of Goldmile-Infobiz Cisco 350-401 Study Guide exam training materials to pass the exam. Goldmile-Infobiz Cisco 350-401 Study Guide exam materials contain the complete unrestricted dump. So with it you can easily pass the exam. You can imagine that you just need to pay a little money for our 350-401 Study Guide exam prep, what you acquire is priceless. So it equals that you have made a worthwhile investment. All the IT professionals are familiar with the Cisco 350-401 Study Guide exam.
350-401 Study Guide actual test guide is your best choice.
CCNP Enterprise 350-401 Study Guide - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR) If you are a person who desire to move ahead in the career with informed choice, then the Cisco training material is quite beneficial for you. 350-401 Exam Cram Questions training materials will definitely live up to your expectations. Not only our 350-401 Exam Cram Questions study materials contain the latest exam questions and answers, but also the pass rate is high as 98% to 100%.
Our website is here to lead you toward the way of success in 350-401 Study Guide certification exams and saves you from the unnecessary preparation materials. The latest 350-401 Study Guide dumps torrent are developed to facilitate our candidates and to improve their ability and expertise for the challenge of the actual test. We aimed to help our candidates get success in the 350-401 Study Guide practice test with less time and leas effort.
Cisco 350-401 Study Guide - So their perfection is unquestionable.
Our 350-401 Study Guide practice engine with passing rate up to 98 percent can build a surely system to elude any kind of loss of you and help you harvest success effortlessly. We are in dire to help you conquer any questions about 350-401 Study Guide training materials emerging during your review. If you want to be accepted as an indispensable member in your working condition, and obliterate opponents from a great distance, start by using our 350-401 Study Guide exam prep to pass the 350-401 Study Guide exam now.
You will never come across system crashes. The system we design has strong compatibility.
350-401 PDF DEMO:
QUESTION NO: 1
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
QUESTION NO: 2
What is the difference between a RIB and a FIB?
A. The FIB is populated based on RIB content
B. The RIB is used to make IP source prefix-based switching decisions
C. The RIB maintains a mirror image of the FIB
D. The FIB is where all IP routing information is stored
Answer: A
Explanation:
CEF uses a Forwarding Information Base (FIB) to make IP destination prefix-based switching decisions.
The FIB is conceptually similar to a routing table or information base. It maintains a mirror image of the forwarding information contained in the IP routing table. When routing or topology changes occur in the network, the IP routing table is updated, and those changes are reflected in the FIB. The
FIB maintains next-hop address information based on the information in the IP routing table. Because there is a one-to-one correlation between FIB entries and routing table entries, the FIB contains all known routes and eliminates the need for route cache maintenance that is associated with earlier switching paths such as fast switching and optimum switching.
Note: In order to view the Routing information base (RIB) table, use the "show ip route" command.
To view the Forwarding Information Base (FIB), use the "show ip cef" command. RIB is in Control plane while FIB is in Data plane.
QUESTION NO: 3
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.
QUESTION NO: 4
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.
QUESTION NO: 5
Which feature does Cisco TrustSec use to provide scalable, secure communication throughout a network?
A. security group tag number assigned to each user on a switch
B. security group tag ACL assigned to each router on a network
C. security group tag ACL assigned to each port on a switch
D. security group tag number assigned to each port on a network
Answer: D
Explanation:
Cisco TrustSec uses tags to represent logical group privilege. This tag, called a Security Group Tag
(SGT), is used in access policies. The SGT is understood and is used to enforce traffic by Cisco switches, routers and firewalls . Cisco TrustSec is defined in three phases: classification, propagation and enforcement.
When users and devices connect to a network, the network assigns a specific security group.
This process is called classification. Classification can be based on the results of the authentication or by associating the SGT with an IP, VLAN, or port-profile (-> Answer A and answer C are not correct as they say "assigned ... on a switch" only. Answer D is not correct either as it says "assigned to each router").
Just visualize the feeling of achieving success by using our Amazon MLA-C01-KR exam guide,so you can easily understand the importance of choosing a high quality and accuracy Amazon MLA-C01-KR training engine. Esri EGMP_2025 - Please check it carefully. Unlike some products priced heavily and too heavy to undertake, our Huawei H25-611_V1.0 practice materials are reasonable in price. Huawei H19-338-ENU - These professional knowledge will become a springboard for your career, help you get the favor of your boss, and make your career reach it is peak. We can make sure the short time on CompTIA 220-1102 training engine is enough for you to achieve the most outstanding result.
Updated: May 28, 2022