The best part of 200-301 Valid Dumps Sheet exam dumps are their relevance, comprehensiveness and precision. You need not to try any other source for200-301 Valid Dumps Sheet exam preparation. The innovatively crafted dumps will serve you the best; imparting you information in fewer number of questions and answers. This can be testified by our claim that after studying with our 200-301 Valid Dumps Sheet actual exam for 20 to 30 hours, you will be confident to take your 200-301 Valid Dumps Sheet exam and successfully pass it. Tens of thousands of our loyal customers relayed on our 200-301 Valid Dumps Sheet preparation materials and achieved their dreams. You will be much awarded with our 200-301 Valid Dumps Sheet learning engine.
CCNA 200-301 So your success is guaranteed.
Free renewal of our 200-301 - Cisco Certified Network Associate Exam Valid Dumps Sheet study prep in this respect is undoubtedly a large shining point. The relation comes from the excellence of our Latest 200-301 Dumps training materials. We never avoid our responsibility of offering help for exam candidates like you, so choosing our Latest 200-301 Dumps practice dumps means you choose success.
On one hand, all content can radically give you the best backup to make progress. On the other hand, our 200-301 Valid Dumps Sheet exam questions are classy and can broaden your preview potentially. Their efficiency has far beyond your expectation!
Cisco 200-301 Valid Dumps Sheet - This certification gives us more opportunities.
Many exam candidates feel hampered by the shortage of effective 200-301 Valid Dumps Sheet preparation quiz, and the thick books and similar materials causing burden for you. Serving as indispensable choices on your way of achieving success especially during this 200-301 Valid Dumps Sheet exam, more than 98 percent of candidates pass the exam with our 200-301 Valid Dumps Sheet training guide and all of former candidates made measurable advance and improvement.
Therefore, modern society is more and more pursuing efficient life, and our 200-301 Valid Dumps Sheet exam materials are the product of this era, which conforms to the development trend of the whole era. It seems that we have been in a state of study and examination since we can remember, and we have experienced countless tests, including the qualification examinations we now face.
200-301 PDF DEMO:
QUESTION NO: 1
Drag and Drop Question
Drag and drop the WLAN components from the left onto the correct descriptions on the right.
Answer:
Explanation:
The service port can be used management purposes, primarily for out-of-band management.
However, AP management traffic is not possible across the service port. In most cases, the service port is used as a "last resort" means of accessing the controller GUI for management purposes. For example, in the case where the system distribution ports on the controller are down or their communication to the wired network is otherwise degraded.
A dynamic interface with the Dynamic AP Management option enabled is used as the tunnel source for packets from the controller to the access point and as the destination for CAPWAP packets from the access point to the controller.
The virtual interface is used to support mobility management, Dynamic Host Configuration Protocol
(DHCP) relay, and embedded Layer 3 security such as guest web authentication. It also maintains the
DNS gateway host name used by Layer 3 security and mobility managers to verify the source of certificates when Layer 3 web authorization is enabled.
Reference: https://www.cisco.com/c/en/us/td/docs/wireless/controller/8-5/config- guide/b_cg85/ports_and_interfaces.html
QUESTION NO: 2
Which statement about Link Aggregation when implemented on a Cisco Wireless LAN
Controller is true?
A. One functional physical port is needed to pass client traffic
B. The EtherChannel must be configured in "mode active"
C. When enabled the WLC bandwidth drops to 500 Mbps
D. To pass client traffic two or more ports must be configured.
Answer: A
Explanation:
Link aggregation (LAG) is a partial implementation of the 802.3ad port aggregation standard. It bundles all of the controller's distribution system ports into a single 802.3ad port channel.
Restriction for Link aggregation:
- LAG requires the EtherChannel to be configured for `mode on' on both the controller and the
Catalyst switch -> Answer B is not correct.
- If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller -> Answer A is not correct while answer D is correct.
Reference: https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/ b_cg75_chapter_0100010.html
QUESTION NO: 3
Which two tasks must be performed to configure NTP to a trusted server in client mode on a single network device? (Choose two)
A. Verify the time zone.
B. Disable NTP broadcasts
C. Set the NTP server private key
D. Specify the IP address of the NTP server
E. Enable NTP authentication.
Answer: D,E
Explanation:
To configure authentication, perform this task in privileged mode:
Step 1: Configure an authentication key pair for NTP and specify whether the key will be trusted or untrusted.
Step 2: Set the IP address of the NTP server and the public key.
Step 3: Enable NTP client mode.
Step 4: Enable NTP authentication.
Step 5: Verify the NTP configuration.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst4000/8-
2glx/configuration/guide/ ntp.html
QUESTION NO: 4
Refer to the exhibit. C-router is to be used as a "router-on-a-stick" to route between the
VLANs.
All the interfaces have been properly configured and IP routing is operational. The hosts in the VLANs have been configured with the appropriate default gateway.
What is true about this configuration?
A. These commands need to be added to the configuration:
C-router(config)# router rip
C-router(config-router)# network 172.19.0.0
B. These commands need to be added to the configuration:
C-router(config)# router ospf 1
C-router(config-router)# network 172.19.0.0 0.0.3.255 area 0
C. These commands need to be added to the configuration:
C-router(config)# router eigrp 123
C-router(config-router)# network 172.19.0.0
D. No further routing configuration is required.
Answer: D
Explanation:
Since all the same router (C-router) is the default gateway for all three VLANs, all traffic destined to a different VLAN will be sent to the C-router. The C-router will have knowledge of all three networks since they will appear as directly connected in the routing table. Since the C-router already knows how to get to all three networks, no routing protocols need to be configured.
QUESTION NO: 5
Refer to the exhibit. After you apply the given configuration to arouter, the DHCP clients behind the device connot communicate with hosts outside of their subnet.
Which action is most likely to correct the problem?
A. configure the default gateway
B. Configure the dns server on the same subnet as the clients
C. Activate the dhcp pool
D. Correct the subnet mask
Answer: A
Cloud Security Alliance CCSK - If you use the APP online version, just download the application. CIPS L4M2 - If you make up your mind, choose us! Our Fortinet NSE7_SOC_AR-7.6 exam braindumps are the hard-won fruit of our experts with their unswerving efforts in designing products and choosing test questions. The staff of Juniper JN0-460 study guide is professionally trained. SAP C_ARSUM_2508 - In fact, all three versions contain the same questions and answers.
Updated: May 28, 2022