Usually you may take months to review a professional exam, but with 200-301 Valid Exam Blueprint exam guide, you only need to spend 20-30 hours to review before the exam, and with our 200-301 Valid Exam Blueprint study materials, you will no longer need any other review materials, because our learning dumps have already included all the important test points. At the same time, 200-301 Valid Exam Blueprint practice engine will give you a brand-new learning method to review - let you master the knowledge in the course of the doing exercise. We are well-known for our wonderful performance on pushing more and more candidates to pass their 200-301 Valid Exam Blueprint exams and achieve their dreaming certifications. There is no exaggeration to say that with our 200-301 Valid Exam Blueprint study materials for 20 to 30 hours, you will be ready to pass your 200-301 Valid Exam Blueprint exam. our company made our 200-301 Valid Exam Blueprint practice guide with accountability.
CCNA 200-301 Your life will be even more exciting.
CCNA 200-301 Valid Exam Blueprint - Cisco Certified Network Associate Exam After our practice materials were released ten years ago, they have been popular since then and never lose the position of number one in this area. The price of our 200-301 Valid Test Camp Free learning guide is among the range which you can afford and after you use our 200-301 Valid Test Camp Free study materials you will certainly feel that the value of the 200-301 Valid Test Camp Free exam questions far exceed the amount of the money you pay for the pass rate of our practice quiz is 98% to 100% which is unmarched in the market. Choosing our 200-301 Valid Test Camp Free study guide equals choosing the success and the perfect service.
Are you still satisfied with your present job? Do you still have the ability to deal with your job well? Do you think whether you have the competitive advantage when you are compared with people working in the same field? If your answer is no，you are a right place now. Because our 200-301 Valid Exam Blueprint exam torrent will be your good partner and you will have the chance to change your work which you are not satisfied with, and can enhance your ability by our 200-301 Valid Exam Blueprint guide questions, you will pass the exam and achieve your target.
There are many advantages of our Cisco 200-301 Valid Exam Blueprint study tool.
A minor mistake may result you to lose chance even losing out on your 200-301 Valid Exam Blueprint exam. So we hold responsible tents when compiling the 200-301 Valid Exam Blueprint learning guide. The principles of our 200-301 Valid Exam Blueprintpractice materials can be expressed in words like clarity, correction and completeness. Experts expressed their meaning with clarity by knowledgeable and understandable words which cannot be misunderstood.
Because the exam may put a heavy burden on your shoulder while our 200-301 Valid Exam Blueprint practice materials can relieve you of those troubles with time passing by. Just spent some time regularly on our 200-301 Valid Exam Blueprint exam simulation, your possibility of getting it will be improved greatly.
200-301 PDF DEMO:
QUESTION NO: 1
Which statement about Link Aggregation when implemented on a Cisco Wireless LAN
Controller is true?
A. One functional physical port is needed to pass client traffic
B. The EtherChannel must be configured in "mode active"
C. When enabled the WLC bandwidth drops to 500 Mbps
D. To pass client traffic two or more ports must be configured.
Answer: A
Explanation:
Link aggregation (LAG) is a partial implementation of the 802.3ad port aggregation standard. It bundles all of the controller's distribution system ports into a single 802.3ad port channel.
Restriction for Link aggregation:
- LAG requires the EtherChannel to be configured for `mode on' on both the controller and the
Catalyst switch -> Answer B is not correct.
- If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller -> Answer A is not correct while answer D is correct.
Reference: https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/ b_cg75_chapter_0100010.html
QUESTION NO: 2
Drag and Drop Question
Drag and drop the WLAN components from the left onto the correct descriptions on the right.
Answer:
Explanation:
The service port can be used management purposes, primarily for out-of-band management.
However, AP management traffic is not possible across the service port. In most cases, the service port is used as a "last resort" means of accessing the controller GUI for management purposes. For example, in the case where the system distribution ports on the controller are down or their communication to the wired network is otherwise degraded.
A dynamic interface with the Dynamic AP Management option enabled is used as the tunnel source for packets from the controller to the access point and as the destination for CAPWAP packets from the access point to the controller.
The virtual interface is used to support mobility management, Dynamic Host Configuration Protocol
(DHCP) relay, and embedded Layer 3 security such as guest web authentication. It also maintains the
DNS gateway host name used by Layer 3 security and mobility managers to verify the source of certificates when Layer 3 web authorization is enabled.
Reference: https://www.cisco.com/c/en/us/td/docs/wireless/controller/8-5/config- guide/b_cg85/ports_and_interfaces.html
QUESTION NO: 3
Refer to the exhibit. C-router is to be used as a "router-on-a-stick" to route between the
VLANs.
All the interfaces have been properly configured and IP routing is operational. The hosts in the VLANs have been configured with the appropriate default gateway.
What is true about this configuration?
A. These commands need to be added to the configuration:
C-router(config)# router rip
C-router(config-router)# network 172.19.0.0
B. These commands need to be added to the configuration:
C-router(config)# router ospf 1
C-router(config-router)# network 172.19.0.0 0.0.3.255 area 0
C. These commands need to be added to the configuration:
C-router(config)# router eigrp 123
C-router(config-router)# network 172.19.0.0
D. No further routing configuration is required.
Answer: D
Explanation:
Since all the same router (C-router) is the default gateway for all three VLANs, all traffic destined to a different VLAN will be sent to the C-router. The C-router will have knowledge of all three networks since they will appear as directly connected in the routing table. Since the C-router already knows how to get to all three networks, no routing protocols need to be configured.
QUESTION NO: 4
Which two tasks must be performed to configure NTP to a trusted server in client mode on a single network device? (Choose two)
A. Verify the time zone.
B. Disable NTP broadcasts
C. Set the NTP server private key
D. Specify the IP address of the NTP server
E. Enable NTP authentication.
Answer: D,E
Explanation:
To configure authentication, perform this task in privileged mode:
Step 1: Configure an authentication key pair for NTP and specify whether the key will be trusted or untrusted.
Step 2: Set the IP address of the NTP server and the public key.
Step 3: Enable NTP client mode.
Step 4: Enable NTP authentication.
Step 5: Verify the NTP configuration.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst4000/8-
2glx/configuration/guide/ ntp.html
QUESTION NO: 5
A router running EIGRP has learned the same route from two different paths. Which parameter does the router use to select the best path?
A. administrative distance
B. as-path
C. metric
D. cost
Answer: C
Explanation:
If a router learns two different paths for the same network from the same routing protocol, it has to decide which route is better and will be placed in the routing table. Metric is the measure used to decide which route is better (lower number is better). Each routing protocol uses its own metric.
For example, RIP uses hop counts as a metric, while OSPF uses cost.
https://study-ccna.com/administrative-distance-metric/
Microsoft AZ-204-KR - So you can choose them according to your personal preference. We are pleased to inform you that we have engaged in this business for over ten years with our IIA IIA-CIA-Part2 exam questions. Therefore, with our IBM S2000-025 study materials, you can easily find the key content of the exam and review it in a targeted manner so that you can successfully pass the IBM S2000-025 exam. Microsoft AI-900-KR exam practice is also equipped with a simulated examination system that simulates the real exam environment so that you can check your progress at any time. Our service staff will help you solve the problem about the SAP C_ARSUM_2508 training materials with the most professional knowledge and enthusiasm.
Updated: May 28, 2022