200-301参考書内容「Cisco Certified Network Associate Exam」はCiscoの一つ認証試験として、もしCisco認証試験に合格してIT業界にとても人気があってので、ますます多くの人が200-301参考書内容試験に申し込んで、200-301参考書内容試験は簡単ではなくて、時間とエネルギーがかかって用意しなければなりません。 数年以来の試験問題集を研究しています。現在あなたに提供するのは大切なCiscoの200-301参考書内容資料です。 しかし必ずしも大量の時間とエネルギーで復習しなくて、弊社が丹精にできあがった問題集を使って、試験なんて問題ではありません。
CCNA 200-301 例外がないです。
CCNA 200-301参考書内容 - Cisco Certified Network Associate Exam こうして、君は安心で試験の準備を行ってください。 そうしたら、試験からの緊張感を解消することができ、あなたは最大のメリットを取得できます。Goldmile-Infobizが提供する資料は比べものにならない資料です。
Goldmile-Infobizが提供したCiscoの200-301参考書内容「Cisco Certified Network Associate Exam」試験問題と解答が真実の試験の練習問題と解答は最高の相似性があり、一年の無料オンラインの更新のサービスがあり、100%のパス率を保証して、もし試験に合格しないと、弊社は全額で返金いたします。
Cisco 200-301参考書内容 - 」このように質問した人がいます。
Ciscoの200-301参考書内容認証試験の合格証は多くのIT者になる夢を持つ方がとりたいです。でも、その試験はITの専門知識と経験が必要なので、合格するために一般的にも大量の時間とエネルギーをかからなければならなくて、助簡単ではありません。Goldmile-Infobizは素早く君のCisco試験に関する知識を補充できて、君の時間とエネルギーが節約させるウェブサイトでございます。Goldmile-Infobizのことに興味があったらネットで提供した部分資料をダウンロードしてください。
もしIT認証の準備をしなかったら、あなたはのんびりできますか。もちろんです。
200-301 PDF DEMO:
QUESTION NO: 1
Which two tasks must be performed to configure NTP to a trusted server in client mode on a single network device? (Choose two)
A. Verify the time zone.
B. Disable NTP broadcasts
C. Set the NTP server private key
D. Specify the IP address of the NTP server
E. Enable NTP authentication.
Answer: D,E
Explanation:
To configure authentication, perform this task in privileged mode:
Step 1: Configure an authentication key pair for NTP and specify whether the key will be trusted or untrusted.
Step 2: Set the IP address of the NTP server and the public key.
Step 3: Enable NTP client mode.
Step 4: Enable NTP authentication.
Step 5: Verify the NTP configuration.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst4000/8-
2glx/configuration/guide/ ntp.html
QUESTION NO: 2
Drag and Drop Question
Drag and drop the WLAN components from the left onto the correct descriptions on the right.
Answer:
Explanation:
The service port can be used management purposes, primarily for out-of-band management.
However, AP management traffic is not possible across the service port. In most cases, the service port is used as a "last resort" means of accessing the controller GUI for management purposes. For example, in the case where the system distribution ports on the controller are down or their communication to the wired network is otherwise degraded.
A dynamic interface with the Dynamic AP Management option enabled is used as the tunnel source for packets from the controller to the access point and as the destination for CAPWAP packets from the access point to the controller.
The virtual interface is used to support mobility management, Dynamic Host Configuration Protocol
(DHCP) relay, and embedded Layer 3 security such as guest web authentication. It also maintains the
DNS gateway host name used by Layer 3 security and mobility managers to verify the source of certificates when Layer 3 web authorization is enabled.
Reference: https://www.cisco.com/c/en/us/td/docs/wireless/controller/8-5/config- guide/b_cg85/ports_and_interfaces.html
QUESTION NO: 3
Which statement about Link Aggregation when implemented on a Cisco Wireless LAN
Controller is true?
A. One functional physical port is needed to pass client traffic
B. The EtherChannel must be configured in "mode active"
C. When enabled the WLC bandwidth drops to 500 Mbps
D. To pass client traffic two or more ports must be configured.
Answer: A
Explanation:
Link aggregation (LAG) is a partial implementation of the 802.3ad port aggregation standard. It bundles all of the controller's distribution system ports into a single 802.3ad port channel.
Restriction for Link aggregation:
- LAG requires the EtherChannel to be configured for `mode on' on both the controller and the
Catalyst switch -> Answer B is not correct.
- If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller -> Answer A is not correct while answer D is correct.
Reference: https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/ b_cg75_chapter_0100010.html
QUESTION NO: 4
Refer to the exhibit. After you apply the given configuration to arouter, the DHCP clients behind the device connot communicate with hosts outside of their subnet.
Which action is most likely to correct the problem?
A. configure the default gateway
B. Configure the dns server on the same subnet as the clients
C. Activate the dhcp pool
D. Correct the subnet mask
Answer: A
QUESTION NO: 5
Refer to the exhibit. C-router is to be used as a "router-on-a-stick" to route between the
VLANs.
All the interfaces have been properly configured and IP routing is operational. The hosts in the VLANs have been configured with the appropriate default gateway.
What is true about this configuration?
A. These commands need to be added to the configuration:
C-router(config)# router rip
C-router(config-router)# network 172.19.0.0
B. These commands need to be added to the configuration:
C-router(config)# router ospf 1
C-router(config-router)# network 172.19.0.0 0.0.3.255 area 0
C. These commands need to be added to the configuration:
C-router(config)# router eigrp 123
C-router(config-router)# network 172.19.0.0
D. No further routing configuration is required.
Answer: D
Explanation:
Since all the same router (C-router) is the default gateway for all three VLANs, all traffic destined to a different VLAN will be sent to the C-router. The C-router will have knowledge of all three networks since they will appear as directly connected in the routing table. Since the C-router already knows how to get to all three networks, no routing protocols need to be configured.
Goldmile-Infobizは異なるトレーニングツールと資源を提供してあなたのCiscoのHITRUST CCSFPの認証試験の準備にヘルプを差し上げます。 ASQ CSSBB - これもあなたの意志が強いことを表示する方法です。 CompTIA CV0-004 - しかも、サイトでテストデータの一部は無料です。 Huawei H19-338 - この問題集は実際試験に出る可能性があるすべての問題を含んでいます。 CiscoのBICSI INST1-V8試験は挑戦がある認定試験です。
Updated: May 28, 2022