Goldmile-InfobizはCiscoの200-301対応内容「Cisco Certified Network Associate Exam」試験に向けて問題集を提供する専門できなサイトで、君の専門知識を向上させるだけでなく、一回に試験に合格するのを目標にして、君がいい仕事がさがせるのを一生懸命頑張ったウェブサイトでございます。 本当に助かりました。先月、200-301対応内容試験に参加しました。 Goldmile-Infobiz を選択して１００％の合格率を確保することができて、もし試験に失敗したら、Goldmile-Infobizが全額で返金いたします。
CCNA 200-301 弊社はあなた１００％合格率を保証いたします。
CCNA 200-301対応内容 - Cisco Certified Network Associate Exam 弊社の商品は試験の範囲を広くカバーすることが他のサイトがなかなか及ばならないです。 Goldmile-InfobizはCiscoの200-301 合格率認定試験「Cisco Certified Network Associate Exam」に向けてもっともよい問題集を研究しています。もしほかのホームページに弊社みたいな問題集を見れば、あとでみ続けて、弊社の商品を盗作することとよくわかります。
弊社が提供した問題集がほかのインターネットに比べて問題のカーバ範囲がもっと広くて対応性が強い長所があります。Goldmile-Infobizが持つべきなIT問題集を提供するサイトでございます。
Cisco 200-301対応内容 - Goldmile-Infobizの問題集は最大のお得だね！
Goldmile-Infobizを選択したら、成功が遠くではありません。Goldmile-Infobizが提供するCiscoの200-301対応内容認証試験問題集が君の試験に合格させます。テストの時に有効なツルが必要でございます。
きっと試験に合格しますよ。あなたはまだ何を待っているのですか。
200-301 PDF DEMO:
QUESTION NO: 1
Refer to Exhibit. Which action do the switches take on the trunk link?
A. The trunk does not form and the ports go into an err-disabled status.
B. The trunk forms but VLAN 99 and VLAN 999 are in a shutdown state.
C. The trunk does not form, but VLAN 99 and VLAN 999 are allowed to traverse the link.
D. The trunk forms but the mismatched native VLANs are merged into a single broadcast domain.
Answer: D
Explanation:
The trunk still forms with mismatched native VLANs and the traffic can actually flow between mismatched switches. But it is absolutely necessary that the native VLANs on both ends of a trunk link match; otherwise a native VLAN mismatch occurs, causing the two VLANs to effectively merge.
For example with the above configuration, SW1 would send untagged frames for VLAN
999. SW2 receives them but would think they are for VLAN 99 so we can say these two VLANs are merged.
QUESTION NO: 2
Which command automatically generates an IPv6 address from a specified IPv6 prefix and
MAC address of an interface?
A. ipv6 address autoconfig
B. ipv6 address dhcp
C. ipv6 address 2001:DB8:5:112::2/64 link-local
D. ipv6 address 2001:DB8:5:112::/64 eui-64
Answer: A
Explanation:
The "ipv6 address autoconfig" command causes the device to perform IPv6 stateless address auto- configuration to discover prefixes on the link and then to add the EUI-64 based addresses to the interface.
Addresses are configured depending on the prefixes received in Router Advertisement (RA) messages.
The device will listen for RA messages which are transmitted periodically from the router (DHCP
Server).
This RA message allows a host to create a global IPv6 address from:
+ Its interface identifier (EUI-64 address)
+ Link Prefix (obtained via RA)
Note: Global address is the combination of Link Prefix and EUI-64 address
QUESTION NO: 3
Which two statements about eBGP neighbor relationships are true? (Choose two)
A. Neighbors must be specifically declared in the configuration of each device
B. They can be created dynamically after the network statement is configured.
C. The two devices must reside in the same autonomous system
D. The two devices must have matching timer settings
E. The two devices must reside in different autonomous systems
Answer: A,E
QUESTION NO: 4
Refer to the exhibit. After you apply the given configuration to arouter, the DHCP clients behind the device connot communicate with hosts outside of their subnet.
Which action is most likely to correct the problem?
A. configure the default gateway
B. Configure the dns server on the same subnet as the clients
C. Activate the dhcp pool
D. Correct the subnet mask
Answer: A
QUESTION NO: 5
Which two tasks must be performed to configure NTP to a trusted server in client mode on a single network device? (Choose two)
A. Verify the time zone.
B. Disable NTP broadcasts
C. Set the NTP server private key
D. Specify the IP address of the NTP server
E. Enable NTP authentication.
Answer: D,E
Explanation:
To configure authentication, perform this task in privileged mode:
Step 1: Configure an authentication key pair for NTP and specify whether the key will be trusted or untrusted.
Step 2: Set the IP address of the NTP server and the public key.
Step 3: Enable NTP client mode.
Step 4: Enable NTP authentication.
Step 5: Verify the NTP configuration.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst4000/8-
2glx/configuration/guide/ ntp.html
CiscoのHP HPE6-A87認定試験を受けることを決めたら、Goldmile-Infobizがそばにいて差し上げますよ。 Goldmile-InfobizのCiscoのAmazon SAA-C03-KR勉強資料は問題と解答を含めています。 しかし、Goldmile-InfobizのCiscoのMicrosoft AZ-800トレーニング資料を利用してから、その落ち着かない心はなくなった人がたくさんいます。 Goldmile-InfobizのCiscoのSAP C-TS4FI-2023試験トレーニング資料はあなたに最も適用して、あなたのニーズを満たす資料です。 Adobe AD0-E117 - Goldmile-Infobizのトレーニング資料は実践の検証に合格すたもので、多くの受験生に証明された１００パーセントの成功率を持っている資料です。
Updated: May 28, 2022