そうすると、受験するとき、あなたは試験を容易に対処することができます。Goldmile-Infobizの200-301最新対策問題問題集には、PDF版およびソフトウェア版のバージョンがあります。それはあなたに最大の利便性を与えることができます。 弊社のCiscoの200-301最新対策問題真題によって、資格認定証明書を受け取れて、仕事の昇進を実現できます。Ciscoの200-301最新対策問題資格認定証明書を持つ人は会社のリーダーからご格別のお引き立てを賜ったり、仕事の昇進をたやすくなったりしています。 これは試験の一発合格を保証できる問題集ですから。
CCNA 200-301 もちろんです。
CCNA 200-301最新対策問題 - Cisco Certified Network Associate Exam 実には、正確の方法と資料を探すなら、すべては問題ではりません。 もっと大切なのは、あなたもより多くの仕事のスキルをマスターしたことを証明することができます。では、はやくCiscoの200-301 真実試験認定試験を受験しましょう。
素晴らしい試験参考書です。200-301最新対策問題認定試験の難しさで近年、資格認定試験に合格した受験生はますます少なくなっていたと良く知られます。だから、我々社のIT専門家は長年にわたりCisco 200-301最新対策問題認定資格試験問題集作成に取り組んで、有効な200-301最新対策問題試験問題集を書きました。
Cisco 200-301最新対策問題 - 信じられなら利用してみてください。
弊社は強力な教師チームがあって、彼たちは正確ではやくて例年のCisco 200-301最新対策問題認定試験の資料を整理して、直ちにもっとも最新の資料を集めて、弊社は全会一緻で認められています。Cisco 200-301最新対策問題試験認証に合格確率はとても小さいですが、Goldmile-Infobizはその合格確率を高めることが信じてくだい。
Goldmile-Infobizの問題集は100％の合格率を持っています。Goldmile-Infobizの200-301最新対策問題問題集は多くのIT専門家の数年の経験の結晶で、高い価値を持っています。
200-301 PDF DEMO:
QUESTION NO: 1
Which two tasks must be performed to configure NTP to a trusted server in client mode on a single network device? (Choose two)
A. Verify the time zone.
B. Disable NTP broadcasts
C. Set the NTP server private key
D. Specify the IP address of the NTP server
E. Enable NTP authentication.
Answer: D,E
Explanation:
To configure authentication, perform this task in privileged mode:
Step 1: Configure an authentication key pair for NTP and specify whether the key will be trusted or untrusted.
Step 2: Set the IP address of the NTP server and the public key.
Step 3: Enable NTP client mode.
Step 4: Enable NTP authentication.
Step 5: Verify the NTP configuration.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst4000/8-
2glx/configuration/guide/ ntp.html
QUESTION NO: 2
Drag and Drop Question
Drag and drop the WLAN components from the left onto the correct descriptions on the right.
Answer:
Explanation:
The service port can be used management purposes, primarily for out-of-band management.
However, AP management traffic is not possible across the service port. In most cases, the service port is used as a "last resort" means of accessing the controller GUI for management purposes. For example, in the case where the system distribution ports on the controller are down or their communication to the wired network is otherwise degraded.
A dynamic interface with the Dynamic AP Management option enabled is used as the tunnel source for packets from the controller to the access point and as the destination for CAPWAP packets from the access point to the controller.
The virtual interface is used to support mobility management, Dynamic Host Configuration Protocol
(DHCP) relay, and embedded Layer 3 security such as guest web authentication. It also maintains the
DNS gateway host name used by Layer 3 security and mobility managers to verify the source of certificates when Layer 3 web authorization is enabled.
Reference: https://www.cisco.com/c/en/us/td/docs/wireless/controller/8-5/config- guide/b_cg85/ports_and_interfaces.html
QUESTION NO: 3
Refer to the exhibit. After you apply the given configuration to arouter, the DHCP clients behind the device connot communicate with hosts outside of their subnet.
Which action is most likely to correct the problem?
A. configure the default gateway
B. Configure the dns server on the same subnet as the clients
C. Activate the dhcp pool
D. Correct the subnet mask
Answer: A
QUESTION NO: 4
Which statement about Link Aggregation when implemented on a Cisco Wireless LAN
Controller is true?
A. One functional physical port is needed to pass client traffic
B. The EtherChannel must be configured in "mode active"
C. When enabled the WLC bandwidth drops to 500 Mbps
D. To pass client traffic two or more ports must be configured.
Answer: A
Explanation:
Link aggregation (LAG) is a partial implementation of the 802.3ad port aggregation standard. It bundles all of the controller's distribution system ports into a single 802.3ad port channel.
Restriction for Link aggregation:
- LAG requires the EtherChannel to be configured for `mode on' on both the controller and the
Catalyst switch -> Answer B is not correct.
- If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller -> Answer A is not correct while answer D is correct.
Reference: https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/ b_cg75_chapter_0100010.html
QUESTION NO: 5
Refer to the exhibit. C-router is to be used as a "router-on-a-stick" to route between the
VLANs.
All the interfaces have been properly configured and IP routing is operational. The hosts in the VLANs have been configured with the appropriate default gateway.
What is true about this configuration?
A. These commands need to be added to the configuration:
C-router(config)# router rip
C-router(config-router)# network 172.19.0.0
B. These commands need to be added to the configuration:
C-router(config)# router ospf 1
C-router(config-router)# network 172.19.0.0 0.0.3.255 area 0
C. These commands need to be added to the configuration:
C-router(config)# router eigrp 123
C-router(config-router)# network 172.19.0.0
D. No further routing configuration is required.
Answer: D
Explanation:
Since all the same router (C-router) is the default gateway for all three VLANs, all traffic destined to a different VLAN will be sent to the C-router. The C-router will have knowledge of all three networks since they will appear as directly connected in the routing table. Since the C-router already knows how to get to all three networks, no routing protocols need to be configured.
EXIN PR2F - Goldmile-Infobizが提供した資料は最も全面的で、しかも更新の最も速いです。 Huawei H31-311_V2.5 - Goldmile-Infobizはあなたと一緒に君のITの夢を叶えるために頑張ります。 Goldmile-Infobizが提供した教材を勉強ツルとしてCiscoのIIA IIA-CIA-Part2-KR認定試験に合格するのはとても簡単です。 あなたはCiscoのSAP C-BCBTM-2502試験に失敗したら、弊社は原因に関わらずあなたの経済の損失を減少するためにもらった費用を全額で返しています。 CiscoのOracle 1z1-809-JPNは専門知識と情報技術の検査として認証試験で、Goldmile-Infobizはあなたに一日早くCiscoの認証試験に合格させて、多くの人が大量の時間とエネルギーを費やしても無駄になりました。
Updated: May 28, 2022