あなたはGoldmile-Infobizの学習教材を購入した後、私たちは一年間で無料更新サービスを提供することができます。Goldmile-InfobizのCiscoの200-301資料的中率試験トレーニング資料はCiscoの200-301資料的中率認定試験を準備するのリーダーです。Goldmile-Infobizの Ciscoの200-301資料的中率試験トレーニング資料は高度に認証されたIT領域の専門家の経験と創造を含めているものです。 Goldmile-Infobizが提供するCiscoの200-301資料的中率認証試験問題集が君の試験に合格させます。テストの時に有効なツルが必要でございます。 オンライン係員は全日であなたにサービスを提供します。
CCNA 200-301 皆さんからいろいろな好評をもらいました。
あなたは200-301 - Cisco Certified Network Associate Exam資料的中率練習問題を選ばれば、試験に合格できますよ！ うちのCiscoの200-301 最新日本語版参考書問題集を購入したら、私たちは一年間で無料更新サービスを提供することができます。もし学習教材は問題があれば、或いは試験に不合格になる場合は、全額返金することを保証いたします。
だから、200-301資料的中率試験参考書に関連して、何か質問がありましたら、遠慮無く私たちとご連絡致します。私たちのサービスは２４時間で、短い時間で回答できます。私たちの200-301資料的中率試験参考書は、あなたが200-301資料的中率試験に合格する前に最高のサービスを提供することを保証します。
Cisco 200-301資料的中率 - ふさわしい方式を選ぶのは一番重要なのです。
200-301資料的中率「Cisco Certified Network Associate Exam」はCiscoの一つ認証試験として、もしCisco認証試験に合格してIT業界にとても人気があってので、ますます多くの人が200-301資料的中率試験に申し込んで、200-301資料的中率試験は簡単ではなくて、時間とエネルギーがかかって用意しなければなりません。
あなたの購入してから、我々はあなたにCiscoの200-301資料的中率資料の更新情況をつど提供します。このサービスは無料なのです。
200-301 PDF DEMO:
QUESTION NO: 1
Which statement about Link Aggregation when implemented on a Cisco Wireless LAN
Controller is true?
A. One functional physical port is needed to pass client traffic
B. The EtherChannel must be configured in "mode active"
C. When enabled the WLC bandwidth drops to 500 Mbps
D. To pass client traffic two or more ports must be configured.
Answer: A
Explanation:
Link aggregation (LAG) is a partial implementation of the 802.3ad port aggregation standard. It bundles all of the controller's distribution system ports into a single 802.3ad port channel.
Restriction for Link aggregation:
- LAG requires the EtherChannel to be configured for `mode on' on both the controller and the
Catalyst switch -> Answer B is not correct.
- If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller -> Answer A is not correct while answer D is correct.
Reference: https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/ b_cg75_chapter_0100010.html
QUESTION NO: 2
Refer to the exhibit. C-router is to be used as a "router-on-a-stick" to route between the
VLANs.
All the interfaces have been properly configured and IP routing is operational. The hosts in the VLANs have been configured with the appropriate default gateway.
What is true about this configuration?
A. These commands need to be added to the configuration:
C-router(config)# router rip
C-router(config-router)# network 172.19.0.0
B. These commands need to be added to the configuration:
C-router(config)# router ospf 1
C-router(config-router)# network 172.19.0.0 0.0.3.255 area 0
C. These commands need to be added to the configuration:
C-router(config)# router eigrp 123
C-router(config-router)# network 172.19.0.0
D. No further routing configuration is required.
Answer: D
Explanation:
Since all the same router (C-router) is the default gateway for all three VLANs, all traffic destined to a different VLAN will be sent to the C-router. The C-router will have knowledge of all three networks since they will appear as directly connected in the routing table. Since the C-router already knows how to get to all three networks, no routing protocols need to be configured.
QUESTION NO: 3
Drag and Drop Question
Drag and drop the WLAN components from the left onto the correct descriptions on the right.
Answer:
Explanation:
The service port can be used management purposes, primarily for out-of-band management.
However, AP management traffic is not possible across the service port. In most cases, the service port is used as a "last resort" means of accessing the controller GUI for management purposes. For example, in the case where the system distribution ports on the controller are down or their communication to the wired network is otherwise degraded.
A dynamic interface with the Dynamic AP Management option enabled is used as the tunnel source for packets from the controller to the access point and as the destination for CAPWAP packets from the access point to the controller.
The virtual interface is used to support mobility management, Dynamic Host Configuration Protocol
(DHCP) relay, and embedded Layer 3 security such as guest web authentication. It also maintains the
DNS gateway host name used by Layer 3 security and mobility managers to verify the source of certificates when Layer 3 web authorization is enabled.
Reference: https://www.cisco.com/c/en/us/td/docs/wireless/controller/8-5/config- guide/b_cg85/ports_and_interfaces.html
QUESTION NO: 4
A router running EIGRP has learned the same route from two different paths. Which parameter does the router use to select the best path?
A. administrative distance
B. as-path
C. metric
D. cost
Answer: C
Explanation:
If a router learns two different paths for the same network from the same routing protocol, it has to decide which route is better and will be placed in the routing table. Metric is the measure used to decide which route is better (lower number is better). Each routing protocol uses its own metric.
For example, RIP uses hop counts as a metric, while OSPF uses cost.
https://study-ccna.com/administrative-distance-metric/
QUESTION NO: 5
Which two tasks must be performed to configure NTP to a trusted server in client mode on a single network device? (Choose two)
A. Verify the time zone.
B. Disable NTP broadcasts
C. Set the NTP server private key
D. Specify the IP address of the NTP server
E. Enable NTP authentication.
Answer: D,E
Explanation:
To configure authentication, perform this task in privileged mode:
Step 1: Configure an authentication key pair for NTP and specify whether the key will be trusted or untrusted.
Step 2: Set the IP address of the NTP server and the public key.
Step 3: Enable NTP client mode.
Step 4: Enable NTP authentication.
Step 5: Verify the NTP configuration.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst4000/8-
2glx/configuration/guide/ ntp.html
SAP C-S4CPB-2508 - しかし必ずしも大量の時間とエネルギーで復習しなくて、弊社が丹精にできあがった問題集を使って、試験なんて問題ではありません。 弊社のCiscoのAmazon AWS-Developer真題によって、資格認定証明書を受け取れて、仕事の昇進を実現できます。 CiscoのHuawei H13-624_V5.5認定試験は競争が激しい今のIT業界中でいよいよ人気があって、受験者が増え一方で難度が低くなくて結局専門知識と情報技術能力の要求が高い試験なので、普通の人がCisco認証試験に合格するのが必要な時間とエネルギーをかからなければなりません。 どのようにCisco Microsoft MB-500試験に準備すると悩んでいますか。 DSCI DCPLA - 良い対応性の訓練が必要で、Goldmile-Infobiz の問題集をお勧めます。
Updated: May 28, 2022