現在、多くの外資系会社はCiscoの350-401勉強資料試験認定を持つ職員に奨励を与えます。それに、350-401勉強資料試験に合格しない人々は大変なことであるでしょうか？我々のCiscoの350-401勉強資料問題集は試験に準備する受験生にヘルプを与えます。もしあなたはCiscoの350-401勉強資料試験に準備しているなら、弊社Goldmile-Infobizの350-401勉強資料問題集を使ってください。 うちのCiscoの350-401勉強資料問題集を購入したら、私たちは一年間で無料更新サービスを提供することができます。もし学習教材は問題があれば、或いは試験に不合格になる場合は、全額返金することを保証いたします。 Cisco 350-401勉強資料試験はIT業界での人にとって、とても重要な能力証明である一方で、大変難しいことです。
CCNP Enterprise 350-401 ふさわしい方式を選ぶのは一番重要なのです。
また、時間を節約でき、短い時間で勉強したら、350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)勉強資料試験に参加できます。 あなたの購入してから、我々はあなたにCiscoの350-401 参考書資料の更新情況をつど提供します。このサービスは無料なのです。
Goldmile-Infobizは正確な選択を与えて、君の悩みを減らして、もし早くてCisco 350-401勉強資料認証をとりたければ、早くてGoldmile-Infobizをショッピングカートに入れましょう。あなたにとても良い指導を確保できて、試験に合格するのを助けって、Goldmile-Infobizからすぐにあなたの通行証をとります。
Cisco 350-401勉強資料 - こうして、君は安心で試験の準備を行ってください。
ITテストと認定は当面の競争が激しい世界でこれまで以上に重要になりました。それは異なる世界の未来を意味しています。Ciscoの350-401勉強資料「Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)」の試験はあなたの職場生涯で重要な画期的な出来事になり、新しいチャンスを発見するかもしれません。ところが、Ciscoの350-401勉強資料の試験にどうやって合格しますか。心配することはないですよ、ヘルプがあなたの手元にありますから。Goldmile-Infobizを利用したら恐いことはないです。Goldmile-InfobizのCiscoの350-401勉強資料「Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)」の試験問題と解答は試験準備のパイオニアですから。
Goldmile-Infobizが提供したCiscoの350-401勉強資料「Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)」試験問題と解答が真実の試験の練習問題と解答は最高の相似性があり、一年の無料オンラインの更新のサービスがあり、100%のパス率を保証して、もし試験に合格しないと、弊社は全額で返金いたします。
350-401 PDF DEMO:
QUESTION NO: 1
Which description of an SD-Access wireless network infrastructure deployment is true?
A. The wireless client is part of the fabric overlay.
B. The access point is part of the fabric underlay.
C. The WLC is part of the fabric underlay.
D. The access point is part the fabric overlay.
Answer: B
QUESTION NO: 2
Which statement about a fabric access point is true?
A. It is in local mode an must connected directly to the fabric edge switch.
B. It is in FlexConnect mode and must be connected directly to the fabric edge switch.
C. It is in FlexConnect mode and must be connected directly to the fabric border node.
D. It is in local mode an must be connected directly to the fabric border node.
Answer: A
Explanation:
Fabric mode APs continue to support the same wireless media services that traditional APs support; apply AVC, quality of service (QoS), and other wireless policies; and establish the CAPWAP control plane to the fabric WLC. Fabric APs join as local-mode APs and must be directly connected to the fabric edge node switch to enable fabric registration events, including RLOC assignment via the fabric
WLC. The fabric edge nodes use CDP to recognize APs as special wired hosts, applying special port configurations and assigning the APs to a unique overlay network within a common EID space across a fabric. The assignment allows management simplification by using a single subnet to cover the AP infrastructure at a fabric site.
Reference: https://www.cisco.com/c/en/us/td/docs/solutions/CVD/Campus/sda-sdg-2019oct.html
QUESTION NO: 3
Which feature does Cisco TrustSec use to provide scalable, secure communication throughout a network?
A. security group tag number assigned to each user on a switch
B. security group tag ACL assigned to each router on a network
C. security group tag ACL assigned to each port on a switch
D. security group tag number assigned to each port on a network
Answer: D
Explanation:
Cisco TrustSec uses tags to represent logical group privilege. This tag, called a Security Group Tag
(SGT), is used in access policies. The SGT is understood and is used to enforce traffic by Cisco switches, routers and firewalls . Cisco TrustSec is defined in three phases: classification, propagation and enforcement.
When users and devices connect to a network, the network assigns a specific security group.
This process is called classification. Classification can be based on the results of the authentication or by associating the SGT with an IP, VLAN, or port-profile (-> Answer A and answer C are not correct as they say "assigned ... on a switch" only. Answer D is not correct either as it says "assigned to each router").
QUESTION NO: 4
What is the difference between a RIB and a FIB?
A. The FIB is populated based on RIB content
B. The RIB is used to make IP source prefix-based switching decisions
C. The RIB maintains a mirror image of the FIB
D. The FIB is where all IP routing information is stored
Answer: A
Explanation:
CEF uses a Forwarding Information Base (FIB) to make IP destination prefix-based switching decisions.
The FIB is conceptually similar to a routing table or information base. It maintains a mirror image of the forwarding information contained in the IP routing table. When routing or topology changes occur in the network, the IP routing table is updated, and those changes are reflected in the FIB. The
FIB maintains next-hop address information based on the information in the IP routing table. Because there is a one-to-one correlation between FIB entries and routing table entries, the FIB contains all known routes and eliminates the need for route cache maintenance that is associated with earlier switching paths such as fast switching and optimum switching.
Note: In order to view the Routing information base (RIB) table, use the "show ip route" command.
To view the Forwarding Information Base (FIB), use the "show ip cef" command. RIB is in Control plane while FIB is in Data plane.
QUESTION NO: 5
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
Goldmile-Infobiz CiscoのSalesforce Agentforce-Specialist試験問題集はあなたに問題と解答に含まれている大量なテストガイドを提供しています。 PRINCE2 PRINCE2Foundation-JPN - Goldmile-Infobizは素早く君のCisco試験に関する知識を補充できて、君の時間とエネルギーが節約させるウェブサイトでございます。 Goldmile-Infobiz CiscoのServiceNow CIS-SPM-JPN試験トレーニング資料に含まれている問題と解答を利用して、CiscoのServiceNow CIS-SPM-JPN認定試験に合格することができます。 Goldmile-Infobizは異なるトレーニングツールと資源を提供してあなたのCiscoのSalesforce Marketing-Cloud-Administratorの認証試験の準備にヘルプを差し上げます。 最近のわずかの数年間で、CiscoのPECB ISO-9001-Lead-Auditor認定試験は日常生活でますます大きな影響をもたらすようになりました。
Updated: May 28, 2022