私たちは君のIT技能を増強させられますし、君の簡単にCiscoの350-401参考書内容認定試験に合格することができます。Goldmile-Infobizは長年の努力を通じて、Ciscoの350-401参考書内容認定試験の合格率が１００パーセントになっていました。Goldmile-Infobizを選ぶなら、輝い未来を選ぶのに等しいです。 世界は変化している、我々はできるだけそのペースを維持する必要があります。我々Goldmile-InfobizはCiscoの350-401参考書内容試験の変化を注目しています。 もしうちの学習教材を購入した後、試験に不合格になる場合は、私たちが全額返金することを保証いたします。
Ciscoの350-401参考書内容試験に合格したいんですか。
弊社の350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)参考書内容ソフト版問題集はかねてより多くのIT事業をしている人々は順調にCisco 350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)参考書内容資格認定を取得させます。 Goldmile-Infobizはあなたの信頼を得る足ります。何の努力と時間もなくてCiscoの350-401 資格関連題試験に合格するのは不可能です。
あなたは350-401参考書内容練習問題を選ばれば、試験に合格できますよ！ローマは一日に建てられませんでした。多くの人にとって、短い時間で350-401参考書内容試験に合格できることは難しいです。
Cisco 350-401参考書内容 - 逆境は人をテストすることができます。
弊社は君の試験に合格させるとともにまた一年の無料の更新のサービスも提供し、もし試験に失敗したら全額で返金いたします。しかしその可能性はほとんどありません。弊社は100%合格率を保証し、購入前にネットでダウンロードしてください。
自分のレベルを高めたいですか。では、仕事に役に立つスキルをもっと身に付けましょう。
350-401 PDF DEMO:
QUESTION NO: 1
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.
QUESTION NO: 2
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.
QUESTION NO: 3
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D
QUESTION NO: 4
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.
QUESTION NO: 5
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
Microsoft SC-900 - この情報の時代には、IT業界にとても注目され、この強い情報技術業界にIT人材が得難いです。 利用したらMicrosoft PL-600J問題集の品質がわかるようになるので、まず問題集の無料なサンプルを試しましょう。 CiscoのSalesforce Analytics-Admn-201認証試験に関する訓練は対応性のテストで君を助けることができて、試験の前に十分の準備をさしあげます。 Microsoft DP-300J - Goldmile-Infobizの問題集は100％の合格率を持っています。 CiscoのMicrosoft AZ-305J「Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)」の認証試験はあなたがIT分野のプロフェッショナルになることにヘルプを差し上げます。
Updated: May 28, 2022