Goldmile-InfobizのCiscoの350-401受験資料更新版「Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)」試験トレーニング資料はPDFぼ形式とソフトウェアの形式で提供して、Goldmile-InfobizのCiscoの350-401受験資料更新版試験問題と解答に含まれています。350-401受験資料更新版認定試験の真実の問題に会うかもしれません。そんな問題はパーフェクトと称するに足って、効果的な方法がありますから、どちらのCiscoの350-401受験資料更新版試験に成功を取ることができます。 それで、不必要な損失を避けできます。ご客様は350-401受験資料更新版問題集を購入してから、勉強中で何の質問があると、行き届いたサービスを得られています。 人々は自分が将来何か成績を作るようにずっと努力しています。
CCNP Enterprise 350-401 Goldmile-Infobizを信頼してください。
今競争の激しいIT業界で地位を固めたいですが、Cisco 350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)受験資料更新版認証試験に合格しなければなりません。 それに、Goldmile-Infobizの教材を購入すれば、Goldmile-Infobizは一年間の無料アップデート・サービスを提供してあげます。問題が更新される限り、Goldmile-Infobizは直ちに最新版の350-401 過去問題資料を送ってあげます。
Goldmile-Infobizは受験者に向かって試験について問題を解決する受験資源を提供するサービスのサイトで、さまざまな受験生によって別のトレーニングコースを提供いたします。受験者はGoldmile-Infobizを通って順調に試験に合格する人がとても多くなのでGoldmile-InfobizがIT業界の中で高い名声を得ました。
Cisco 350-401受験資料更新版 - それに、あなたに極大な便利と快適をもたらせます。
Goldmile-Infobizは受験生の皆様により良くて、より便利なサービスを提供するために、一生懸命に頑張ります。長年の努力を通じて、Goldmile-InfobizのCiscoの350-401受験資料更新版認定試験の合格率が１００パーセントになっていました。あなたはGoldmile-InfobizのCiscoの350-401受験資料更新版問題集を購入した後、私たちは一年間で無料更新サービスを提供することができます。さあ、Goldmile-InfobizのCiscoの350-401受験資料更新版問題集を買いに行きましょう。
Ciscoの350-401受験資料更新版試験はIT業種に欠くことができない認証ですから、試験に合格することに困っている人々はたくさんいます。ここで皆様に良い方法を教えてあげますよ。
350-401 PDF DEMO:
QUESTION NO: 1
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.
QUESTION NO: 2
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.
QUESTION NO: 3
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.
QUESTION NO: 4
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D
QUESTION NO: 5
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
IBM C1000-200 - 我々係員は全日24時間で待っていますから、何か疑問があれば、お問い合わせを期待しています。 ITIL ITIL-4-Specialist-Create-Deliver-and-Support-JPN - もし失敗だったら、我々は全額で返金します。 あなたはこの重要な試験を準備するのは時間とお金がかかると聞いたことがあるかもしれませんが、それは我々提供するCiscoのSAP C_S4PM2_2507ソフトを利用しなかったからです。 Goldmile-InfobizのCiscoのAmazon CLF-C02「Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)」試験トレーニング資料はIT職員としてのあなたがIT試験に受かる不可欠なトレーニング資料です。 改善されているソフトはあなたのCiscoのPMI CAPM試験の復習の効率を高めることができます。
Updated: May 28, 2022