空想は人間が素晴らしいアイデアをたくさん思い付くことができますが、行動しなければ何の役に立たないのです。Ciscoの350-401学習関連題認定試験に合格のにどうしたらいいかと困っているより、パソコンを起動して、Goldmile-Infobizをクリックしたほうがいいです。Goldmile-Infobizのトレーニング資料は１００パーセントの合格率を保証しますから、あなたのニーズを満たすことができます。 そうすれば、実際の350-401学習関連題試験を受けるときに緊張をすることはないです。ですから、心のリラックスした状態で試験に出る問題を対応することができ、あなたの正常なレベルをプレイすることもできます。 しかし、難しいといっても、高い点数を取って楽に試験に合格できないというわけではないです。
CCNP Enterprise 350-401 あなたの気に入る版を選ぶことができます。
他の人はあちこちでCisco 350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)学習関連題試験資料を探しているとき、あなたはすでに勉強中で、準備階段でライバルに先立ちます。 試験が更新されているうちに、我々はCiscoの350-401 資格講座試験の資料を更新し続けています。できるだけ100％の通過率を保証使用にしています。
だから、弊社の350-401学習関連題練習資料を早く購入しましょう！私たちは、このキャリアの中で、10年以上にわたりプロとして350-401学習関連題練習資料を作りました。350-401学習関連題練習資料が最も全面的な参考書です。
あなたにCiscoのCisco 350-401学習関連題試験に自信を持たせます。
今競争の激しいIT業界で地位を固めたいですが、Cisco 350-401学習関連題認証試験に合格しなければなりません。IT業界ではさらに強くなるために強い専門知識が必要です。Cisco 350-401学習関連題認証試験に合格することが簡単ではなくて、Cisco 350-401学習関連題証明書は君にとってはIT業界に入るの一つの手づるになるかもしれません。しかし必ずしも大量の時間とエネルギーで復習しなくて、弊社が丹精にできあがった問題集を使って、試験なんて問題ではありません。
成功を受けたいあなたはすぐに行動しませんでしょうか？350-401学習関連題試験に興味があると、我々社Goldmile-Infobizをご覧になってください。古くから成功は準備のできる人のためにあると聞こえます。
350-401 PDF DEMO:
QUESTION NO: 1
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.
QUESTION NO: 2
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.
QUESTION NO: 3
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D
QUESTION NO: 4
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.
QUESTION NO: 5
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
Microsoft PL-300-KR - Goldmile-Infobizは受験者に向かって試験について問題を解決する受験資源を提供するサービスのサイトで、さまざまな受験生によって別のトレーニングコースを提供いたします。 Linux Foundation KCSA - 弊社の量豊かの備考資料はあなたを驚かさせます。 がCiscoのEMC D-VXR-DS-00「Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)」認定試験の合格書を取ったら仕事の上で大きな変化をもたらします。 我々社のCisco Microsoft SC-401J問題集とサーブすが多くの人々に認められます。 Google Professional-Data-Engineer-JPN - 最新の資源と最新の動態が第一時間にお客様に知らせいたします。
Updated: May 28, 2022