Goldmile-Infobizは全面的な認証基準のトレーニング方法を追求している。Goldmile-InfobizのCiscoの350-401日本語対策問題集を利用した大勢の人々によると、Ciscoの350-401日本語対策問題集試験の合格率は１００パーセントに達したのです。もし君が試験に関する問題があれば、私たちは最も早い時間で、解答します。 Goldmile-Infobizが提供するCiscoの350-401日本語対策問題集認証試験問題集が君の試験に合格させます。テストの時に有効なツルが必要でございます。 あなたはうちのCiscoの350-401日本語対策問題集問題集を購入する前に、一部分のフリーな試験問題と解答をダンロードして、試用してみることができます。
CCNP Enterprise 350-401 資料の整理に悩んでいますか。
CCNP Enterprise 350-401日本語対策問題集 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR) Goldmile-Infobizのトレーニング資料は実践の検証に合格すたもので、多くの受験生に証明された１００パーセントの成功率を持っている資料です。 成功の喜びは大きいです。我々は弊社のソフトを通してあなたにCiscoの350-401 模擬解説集試験に合格する喜びを感じさせると希望しています。
ショートカットは一つしかないです。それはGoldmile-InfobizのCiscoの350-401日本語対策問題集試験トレーニング資料を利用することです。これは全てのIT認証試験を受ける受験生のアドバイスです。
Cisco 350-401日本語対策問題集 - 自分の幸せは自分で作るものだと思われます。
Goldmile-Infobizは長年にわたってずっとIT認定試験に関連する350-401日本語対策問題集参考書を提供しています。これは受験生の皆さんに検証されたウェブサイトで、一番優秀な試験350-401日本語対策問題集問題集を提供することができます。Goldmile-Infobizは全面的に受験生の利益を保証します。皆さんからいろいろな好評をもらいました。しかも、Goldmile-Infobizは当面の市場で皆さんが一番信頼できるサイトです。
もしあなたはCiscoの350-401日本語対策問題集試験に準備しているなら、弊社Goldmile-Infobizの350-401日本語対策問題集問題集を使ってください。現在、多くの外資系会社はCiscoの350-401日本語対策問題集試験認定を持つ職員に奨励を与えます。
350-401 PDF DEMO:
QUESTION NO: 1
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.
QUESTION NO: 2
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.
QUESTION NO: 3
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.
QUESTION NO: 4
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
QUESTION NO: 5
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D
うちのCiscoのMicrosoft AI-102問題集を購入したら、私たちは一年間で無料更新サービスを提供することができます。 Cisco Microsoft AZ-305試験はIT業界での人にとって、とても重要な能力証明である一方で、大変難しいことです。 Goldmile-Infobizの CiscoのOracle 1z0-1057-25試験トレーニング資料はGoldmile-Infobizの実力と豊富な経験を持っているIT専門家が研究したもので、本物のCiscoのOracle 1z0-1057-25試験問題とほぼ同じです。 近年Cisco HP HPE0-S59-JPN認定試験の難度で大方の受験生は試験に合格しなかったのに面して、勇者のようにこのチャレンジをやってますか。 Cyber AB CMMC-CCP - ふさわしい方式を選ぶのは一番重要なのです。
Updated: May 28, 2022