我々Goldmile-InfobizはCiscoの350-401日本語版試験問題集をリリースする以降、多くのお客様の好評を博したのは弊社にとって、大変な名誉なことです。また、我々はさらに認可を受けられるために、皆様の一切の要求を満足できて喜ぶ気持ちでずっと協力し、完備かつ精確の350-401日本語版試験問題集を開発するのに準備します。 現在、書籍の以外にインターネットは知識の宝庫として見られています。Goldmile-Infobiz で、あなたにあなたの宝庫を見つけられます。 あなたは弊社の商品を使用した後、一回でCisco 350-401日本語版試験に合格できなかったら、弊社は全額返金することを承諾します。
CCNP Enterprise 350-401 逆境は人をテストすることができます。
Cisco 350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)日本語版試験の困難度なので、試験の準備をやめます。 自分のレベルを高めたいですか。では、仕事に役に立つスキルをもっと身に付けましょう。
素晴らしい試験参考書です。350-401日本語版認定試験の難しさで近年、資格認定試験に合格した受験生はますます少なくなっていたと良く知られます。だから、我々社のIT専門家は長年にわたりCisco 350-401日本語版認定資格試験問題集作成に取り組んで、有効な350-401日本語版試験問題集を書きました。
Cisco 350-401日本語版 - Goldmile-Infobizを選択したら、成功をとりましょう。
今の社会はますます激しく変化しているから、私たちはいつまでも危機意識を強化します。キャンパース内のIT知識を学ぶ学生なり、IT職人なり、350-401日本語版試験資格認証証明書を取得して、社会需要に応じて自分の能力を高めます。我々社は最高のCisco 350-401日本語版試験問題集を開発し提供して、一番なさービスを与えて努力しています。業界で有名なCisco 350-401日本語版問題集販売会社として、購入意向があると、我々の商品を選んでくださいませんか。
350-401日本語版 勉強資料は公式Ciscoの350-401日本語版試験トレーニング授業 、Ciscoの350-401日本語版 自習ガイド、Ciscoの350-401日本語版 の試験と実践やCiscoの350-401日本語版オンラインテストなどに含まれています。Goldmile-Infobiz がデザインしたCiscoの350-401日本語版模擬トレーニングパッケージはあなたが楽に試験に合格することを助けます。
350-401 PDF DEMO:
QUESTION NO: 1
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D
QUESTION NO: 2
Which standard access control entry permits from odd-numbered hosts in the 10.0.0.0/24 subnet?
A. Permit 10.0.0.0.255.255.255.254
B. Permit 10.0.0.1.0.0.0.254
C. Permit 10.0.0.1.0.0.0.0
D. Permit 10.0.0.0.0.0.0.1
Answer: B
Explanation:
Remember, for the wildcard mask, 1's are I DON'T CARE, and 0's are I CARE. So now let's analyze a simple ACL:
access-list 1 permit 172.23.16.0 0.0.15.255
Two first octets are all 0's meaning that we care about the network 172.23.x.x. The third octet of the wildcard mask, 15 (0000 1111 in binary), means that we care about first 4 bits but don't care about last 4 bits so we allow the third octet in the form of 0001xxxx (minimum:00010000 = 16; maximum:
0001111 = 31).
The fourth octet is 255 (all 1 bits) that means I don't care.
Therefore network 172.23.16.0 0.0.15.255 ranges from 172.23.16.0 to 172.23.31.255.
Now let's consider the wildcard mask of 0.0.0.254 (four octet: 254 = 1111 1110) which means we only care the last bit. Therefore if the last bit of the IP address is a "1" (0000 0001) then only odd numbers are allowed. If the last bit of the IP address is a "0" (0000 0000) then only even numbers are allowed.
Note: In binary, odd numbers are always end with a "1" while even numbers are always end with a
"0".
Therefore in this question, only the statement "permit 10.0.0.1 0.0.0.254" will allow all odd- numbered hosts in the 10.0.0.0/24 subnet.
QUESTION NO: 3
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.
QUESTION NO: 4
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.
QUESTION NO: 5
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.
Cisco BICSI INST1-V8資格認定はIT技術領域に従事する人に必要があります。 VMware 250-612 - それに、あなたに美しい未来を作ることに助けを差し上げられます。 そうしたら、お客様はCisco 200-301問題集を購入する前にデモをダウンロードしてやってみることができます。 Microsoft AZ-500 - 現在の時代で高効率は避けられない話題ですから、速いスピードと高効率が我々の目標です。 Cisco SAP C_THR70_2505認証試験について研究の資料がもっとも大部分になって、Goldmile-Infobizは早くてCisco SAP C_THR70_2505認証試験の資料を集めることができます。
Updated: May 28, 2022