Goldmile-Infobizが提供したCiscoの350-401最新テスト「Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)」試験問題と解答が真実の試験の練習問題と解答は最高の相似性があり、一年の無料オンラインの更新のサービスがあり、100%のパス率を保証して、もし試験に合格しないと、弊社は全額で返金いたします。 Goldmile-Infobizの勉強資料とCiscoの350-401最新テストに関する指導を従えば、初めてCiscoの350-401最新テスト認定試験を受けるあなたでも一回で試験に合格することができます。我々は受験生の皆様により高いスピードを持っているかつ効率的なサービスを提供することにずっと力を尽くしていますから、あなたが貴重な時間を節約することに助けを差し上げます。 Ciscoの350-401最新テスト認証試験の合格証は多くのIT者になる夢を持つ方がとりたいです。
CCNP Enterprise 350-401 それはいくつかの理由があります。
Ciscoの350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)最新テスト試験は挑戦がある認定試験です。 Goldmile-Infobizは IT職員を助けられるのは職員の能力を証明することができるからです。Goldmile-InfobizのCiscoの350-401 復習対策「Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)」試験はあなたが成功することを助けるトレーニング資料です。
あなたは勇敢な人ですか。もしIT認証の準備をしなかったら、あなたはのんびりできますか。もちろんです。
Cisco 350-401最新テスト - それでも恐れることはありません。
Goldmile-Infobizの350-401最新テスト問題集はあなたの一発合格を保証できる資料です。問題集の的中率はとても高いですから、この問題集だけで試験に合格することができます。信じられなら利用してみてください。不合格になればGoldmile-Infobizは全額返金のことができますから、絶対損にならないです。利用したら350-401最新テスト問題集の品質がわかるようになるので、まず問題集の無料なサンプルを試しましょう。問題集のdemoが無料で提供されますから、Goldmile-Infobizのサイトをクリックしてダウンロードしてください。
皆さんからいろいろな好評をもらいました。しかも、Goldmile-Infobizは当面の市場で皆さんが一番信頼できるサイトです。
350-401 PDF DEMO:
QUESTION NO: 1
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.
QUESTION NO: 2
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.
QUESTION NO: 3
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.
QUESTION NO: 4
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
QUESTION NO: 5
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D
PECB ISO-9001-Lead-Auditor - そのほか、もし試験に関連する知識をより多く知りたいなら、それもあなたの望みを満たすことができます。 君は一回だけでCiscoのFortinet FCSS_ADA_AR-6.7認定試験に合格したいなら、或いは自分のIT技能を増強したいなら、Goldmile-Infobizはあなたにとって最高な選択です。 初心者にしても、サラリーマンにしても、Goldmile-Infobizは君のために特別なCiscoのFortinet FCSS_SASE_AD-25問題集を提供します。 Goldmile-Infobizの学習教材は君の初めての試しでCiscoのScaled Agile SAFe-Agilist認定試験に合格するのに助けます。 SAP C_S4CPR_2508 - 我々Goldmile-Infobizは最高のアフターサービスを提供いたします。
Updated: May 28, 2022