350-401試験問題解説集問題集を購入する前に、Goldmile-Infobizに行ってより多くの情報を読んでください。このサイトを深く知ったほうがいいですよ。それに、試験に失敗すれば全額返金のポリシーについて、事前に調べたほうがいいです。 逆境は人をテストすることができます。困難に直面するとき、勇敢な人だけはのんびりできます。 Goldmile-Infobizはあなたが必要とするすべての350-401試験問題解説集参考資料を持っていますから、きっとあなたのニーズを満たすことができます。
CCNP Enterprise 350-401 自分のレベルを高めたいですか。
CCNP Enterprise 350-401試験問題解説集 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR) Goldmile-Infobizを選び、成功を選ぶのに等しいです。 利用したら350-401 無料模擬試験問題集の品質がわかるようになるので、まず問題集の無料なサンプルを試しましょう。問題集のdemoが無料で提供されますから、Goldmile-Infobizのサイトをクリックしてダウンロードしてください。
Goldmile-Infobizの Ciscoの350-401試験問題解説集試験トレーニング資料を手に入れるなら、あなたは最も新しいCiscoの350-401試験問題解説集学習教材を手に入れられます。Goldmile-Infobizの 学習教材の高い正確性は君がCiscoの350-401試験問題解説集認定試験に合格するのを保証します。もしうちの学習教材を購入した後、商品は問題があれば、或いは試験に不合格になる場合は、私たちが全額返金することを保証いたします。
Cisco 350-401試験問題解説集 - 成功を祈ります。
Ciscoの350-401試験問題解説集のオンラインサービスのスタディガイドを買いたかったら、Goldmile-Infobizを買うのを薦めています。Goldmile-Infobizは同じ作用がある多くのサイトでリーダーとしているサイトで、最も良い品質と最新のトレーニング資料を提供しています。弊社が提供したすべての勉強資料と他のトレーニング資料はコスト効率の良い製品で、サイトが一年間の無料更新サービスを提供します。ですから、弊社のトレーニング製品はあなたが試験に合格することを助けにならなかったら、全額で返金することを保証します。
Ciscoの350-401試験問題解説集認定試験「Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)」によい準備ができて、試験に穏やかな心情をもって扱うことができます。Goldmile-Infobizの専門家が研究された問題集を利用してください。
350-401 PDF DEMO:
QUESTION NO: 1
What is the difference between a RIB and a FIB?
A. The FIB is populated based on RIB content
B. The RIB is used to make IP source prefix-based switching decisions
C. The RIB maintains a mirror image of the FIB
D. The FIB is where all IP routing information is stored
Answer: A
Explanation:
CEF uses a Forwarding Information Base (FIB) to make IP destination prefix-based switching decisions.
The FIB is conceptually similar to a routing table or information base. It maintains a mirror image of the forwarding information contained in the IP routing table. When routing or topology changes occur in the network, the IP routing table is updated, and those changes are reflected in the FIB. The
FIB maintains next-hop address information based on the information in the IP routing table. Because there is a one-to-one correlation between FIB entries and routing table entries, the FIB contains all known routes and eliminates the need for route cache maintenance that is associated with earlier switching paths such as fast switching and optimum switching.
Note: In order to view the Routing information base (RIB) table, use the "show ip route" command.
To view the Forwarding Information Base (FIB), use the "show ip cef" command. RIB is in Control plane while FIB is in Data plane.
QUESTION NO: 2
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
QUESTION NO: 3
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.
QUESTION NO: 4
Which feature does Cisco TrustSec use to provide scalable, secure communication throughout a network?
A. security group tag number assigned to each user on a switch
B. security group tag ACL assigned to each router on a network
C. security group tag ACL assigned to each port on a switch
D. security group tag number assigned to each port on a network
Answer: D
Explanation:
Cisco TrustSec uses tags to represent logical group privilege. This tag, called a Security Group Tag
(SGT), is used in access policies. The SGT is understood and is used to enforce traffic by Cisco switches, routers and firewalls . Cisco TrustSec is defined in three phases: classification, propagation and enforcement.
When users and devices connect to a network, the network assigns a specific security group.
This process is called classification. Classification can be based on the results of the authentication or by associating the SGT with an IP, VLAN, or port-profile (-> Answer A and answer C are not correct as they say "assigned ... on a switch" only. Answer D is not correct either as it says "assigned to each router").
QUESTION NO: 5
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.
CiscoのSAP C_ARSUM_2508認定試験に受かったら、あなたの仕事はより良い保証を得て、将来のキャリアで、少なくともIT領域であなたの技能と知識は国際的に認知され、受け入れられるです。 CiscoのASQ CMQ-OEの認定試験はIT情報技術領域の欠くことができない一部ですから、IT領域の人々はこの試験認証に合格することを通じて自分自身の知識を増加して、他の分野で突破します。 でも、試験に合格するために大量な時間とエネルギーを費やすことはなく、Goldmile-InfobizのCiscoのHP HPE7-A08試験トレーニング資料を選んだらいいです。 PECB ISO-45001-Lead-Auditor - Goldmile-Infobizの仮想ネットワークトレーニングと授業は大量の問題集に含まれていますから、ぜひあなたが気楽に試験に合格することを約束します。 Linux Foundation CGOA - 神様は私を実力を持っている人間にして、美しい人形ではないです。
Updated: May 28, 2022