これは間違いなくあなたが350-401試験感想認定試験に合格することを保証できる問題集です。Goldmile-Infobizは試験に失敗すれば全額返金を保証します。このような保証があれば、Goldmile-Infobizの350-401試験感想問題集を購入しようか購入するまいかと躊躇する必要は全くないです。 我々Goldmile-Infobizにあなたを助けさせてください。我々はあなたのCiscoの350-401試験感想試験への成功を確保しているだけでなく、楽な準備過程と行き届いたアフターサービスを承諾しています。 なぜかと言うと、もちろん350-401試験感想認定試験がとても大切な試験ですから。
CCNP Enterprise 350-401 いろいろな受験生に通用します。
CCNP Enterprise 350-401試験感想 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR) ここでは、あなたは一番質高い資料と行き届いたサービスを楽しみしています。 Ciscoの350-401 勉強ガイドソフトを使用するすべての人を有効にするために最も快適なレビュープロセスを得ることができ、我々は、Ciscoの350-401 勉強ガイドの資料を提供し、PDF、オンラインバージョン、およびソフトバージョンを含んでいます。あなたの愛用する版を利用して、あなたは簡単に最短時間を使用してCiscoの350-401 勉強ガイド試験に合格することができ、あなたのIT機能を最も権威の国際的な認識を得ます！
人生はさまざまな試しがある、人生の頂点にかからないけど、刺激のない生活に変化をもたらします。あなたは我々社の提供する質高いCisco 350-401試験感想問題集を使用して、試験に参加します。もし無事に350-401試験感想試験に合格したら、あなたはもっと自信になって、更なる勇気でやりたいことをしています。
Cisco 350-401試験感想 - 無事試験に合格しました。
多くの受験者にとって、350-401試験感想試験資格証明書を取得することは簡単ではないです。350-401試験感想試験に合格するには、たくさん時間と精力が必要です。しかし、Cisco 350-401試験感想試験参考書を選ばれば、試験に合格するだけでなく、時間を節約できます。だから、Cisco 350-401試験感想試験参考書を早く購入しましょう！
我々Goldmile-InfobizのCisco 350-401試験感想試験問題と試験解答の正確さは、あなたの試験準備をより簡単にし、あなたが試験に高いポイントを得ることを保証します。Cisco 350-401試験感想資格試験に参加する意向があれば、当社のGoldmile-Infobizから自分に相応しい受験対策解説集を選らんで、認定試験の学習教材として勉強します。
350-401 PDF DEMO:
QUESTION NO: 1
What is the difference between a RIB and a FIB?
A. The FIB is populated based on RIB content
B. The RIB is used to make IP source prefix-based switching decisions
C. The RIB maintains a mirror image of the FIB
D. The FIB is where all IP routing information is stored
Answer: A
Explanation:
CEF uses a Forwarding Information Base (FIB) to make IP destination prefix-based switching decisions.
The FIB is conceptually similar to a routing table or information base. It maintains a mirror image of the forwarding information contained in the IP routing table. When routing or topology changes occur in the network, the IP routing table is updated, and those changes are reflected in the FIB. The
FIB maintains next-hop address information based on the information in the IP routing table. Because there is a one-to-one correlation between FIB entries and routing table entries, the FIB contains all known routes and eliminates the need for route cache maintenance that is associated with earlier switching paths such as fast switching and optimum switching.
Note: In order to view the Routing information base (RIB) table, use the "show ip route" command.
To view the Forwarding Information Base (FIB), use the "show ip cef" command. RIB is in Control plane while FIB is in Data plane.
QUESTION NO: 2
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
QUESTION NO: 3
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.
QUESTION NO: 4
Which feature does Cisco TrustSec use to provide scalable, secure communication throughout a network?
A. security group tag number assigned to each user on a switch
B. security group tag ACL assigned to each router on a network
C. security group tag ACL assigned to each port on a switch
D. security group tag number assigned to each port on a network
Answer: D
Explanation:
Cisco TrustSec uses tags to represent logical group privilege. This tag, called a Security Group Tag
(SGT), is used in access policies. The SGT is understood and is used to enforce traffic by Cisco switches, routers and firewalls . Cisco TrustSec is defined in three phases: classification, propagation and enforcement.
When users and devices connect to a network, the network assigns a specific security group.
This process is called classification. Classification can be based on the results of the authentication or by associating the SGT with an IP, VLAN, or port-profile (-> Answer A and answer C are not correct as they say "assigned ... on a switch" only. Answer D is not correct either as it says "assigned to each router").
QUESTION NO: 5
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.
Goldmile-InfobizはCiscoのVMware 2V0-17.25「Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)」試験に向けて問題集を提供する専門できなサイトで、君の専門知識を向上させるだけでなく、一回に試験に合格するのを目標にして、君がいい仕事がさがせるのを一生懸命頑張ったウェブサイトでございます。 Amazon AWS-Developer-KR試験は難しいです。 Microsoft AI-102J - Goldmile-Infobiz を選択して１００％の合格率を確保することができて、もし試験に失敗したら、Goldmile-Infobizが全額で返金いたします。 Cisco SAP C_ARCIG_2508試験の合格のために、Goldmile-Infobizを選択してください。 SAP C-BCBAI-2509 - あなたは弊社の商品を買ったら一年間に無料でアップサービスが提供された認定試験に合格するまで利用しても喜んでいます。
Updated: May 28, 2022