これも多くの人々がISQIのCTAL-TM_Syll2012難易度認定試験を選ぶ理由の一つです。その理由でこの試験はますます重視されるになります。Goldmile-Infobiz ISQIのCTAL-TM_Syll2012難易度試験トレーニング資料はあなたが上記の念願を実現することを助けられるのです。 Goldmile-Infobizを選ぶのは成功に導く鍵を選ぶのに等しいです。長年の努力を通じて、Goldmile-InfobizのISQIのCTAL-TM_Syll2012難易度認定試験の合格率が１００パーセントになっていました。 でも、試験に合格するために大量な時間とエネルギーを費やすことはなく、Goldmile-InfobizのISQIのCTAL-TM_Syll2012難易度試験トレーニング資料を選んだらいいです。
ISQI Certifications CTAL-TM_Syll2012 そうであれば、あなたは夢がある人だと思います。
ISQI Certifications CTAL-TM_Syll2012難易度 - ISTQB Certified Tester Advanced Level - Test Manager [Syllabus 2012] ここにはあなたが最も欲しいものがありますから。 我々Goldmile-InfobizのITエリートと我々のISQIのCTAL-TM_Syll2012 日本語版テキスト内容試験のソフトに満足するお客様は我々に自信を持たせます。あなたのISQIのCTAL-TM_Syll2012 日本語版テキスト内容試験を準備する圧力を減少するのは我々の責任で、あなたにISQIのCTAL-TM_Syll2012 日本語版テキスト内容試験に合格させるのは我々の目標です。
そうすれば、実際のCTAL-TM_Syll2012難易度試験を受けるときに緊張をすることはないです。ですから、心のリラックスした状態で試験に出る問題を対応することができ、あなたの正常なレベルをプレイすることもできます。Goldmile-InfobizのCTAL-TM_Syll2012難易度問題集はあなたを楽に試験の準備をやらせます。
その他、ISQI CTAL-TM_Syll2012難易度問題集の更新版を無料に提供します。
ISQIのCTAL-TM_Syll2012難易度の認定試験に合格すれば、就職機会が多くなります。この試験に合格すれば君の専門知識がとても強いを証明し得ます。ISQIのCTAL-TM_Syll2012難易度の認定試験は君の実力を考察するテストでございます。
この悩みに対して、我々社Goldmile-InfobizはISQIのCTAL-TM_Syll2012難易度試験に準備するあなたに専門的なヘルプを与えられます。弊社のISQIのCTAL-TM_Syll2012難易度練習問題を利用したら、あなたは気楽に勉強するだけではなく、順調に試験に合格します。
CTAL-TM_Syll2012 PDF DEMO:
QUESTION NO: 1
Consider an information system of a Pay-Tv company based on a SOA architecture.
The integrated system currently consists of three core systems:
-a CRM (Customer Relationship Management) system
-a BRM (Billing and Revenue Management) system
-a CAS (Conditional Access System) system all of them communicating with SOA Middleware.
You have been asked to manage the testing activities for the integration of two additional off-theshelf systems from two different vendors: a SMS (Short Message Service) server and an IVR
(Interactive Voice Response) system.
Assume that there is a high likelihood that the two off-the-shelf systems will be low-quality and that you have a clear proof that the testing performed by the two vendors on their systems has been unsystematic and unprofessional. This obviously leads to higher quality risk for the overall integrated system.
You are the Test Manager of this project. Your main goal is to plan for testing activities to mitigate this risk.
Which of the following answers best describes the test activities (assuming it is possible to perform all of them) you should plan for?
K4 3 credits
A. You should plan for an informal and minimal acceptance test of the two off-the-shelf systems and then a single end-to-end test of the overall integrated system
B. You should directly plan for a single end-to-end test focused on end-to-end tests of the overall integrated system without an acceptance test of the two off-the-shelf systems
C. You should plan for two levels: a system integration test and an end-to-end test of the overall integrated system
D. You should plan for adequate re-testing of both the systems followed by a system integration test and an end-to-end test of the overall integrated system
Answer: D
QUESTION NO: 2
The following are the exit criteria described in the test plan of a software product:
EX1. The test suite for the product must ensure that at least each quality risk item is covered by at least one test case (a quality risk item can be covered by more test cases).
EX2. All test cases in the test suite must be run during the execution phase.
EX3. Defects are classified into two categories: "C" (critical defect) and "NC" (non-critical defect). No known C defects shall exist in the product at the end of the test execution phase.
Which of the following information is useless when the specified exit criteria is evaluated?
K2 1 credit
A. A traceability matrix showing the relationships between the product risk items and the test cases
B. A list of all the open defects with the associated classification information extracted from the defect tracking system
C. A chart, showing the trend in the lag time from defect reporting to resolution, extracted from the defect tracking system
D. The execution status of all the test cases extracted from the test management tool
Answer: C
QUESTION NO: 3
Which of the following is an example of the test closure activity indicated as "lessons learned"?
K2 1 credit
A. Archive all the test results of the acceptance testing phase
B. Deliver a list of the open defects of a software product released into production to the service desk team
C. Participate in a meeting at the end of a project aimed at better managing the events and problems of future projects
D. Deliver an automated regression test suite, used during the system test phase of a software product released into production, to the team responsible for maintenance testing
Answer: C
QUESTION NO: 4
Assume you are the Test Manager for a new software release of an e-commerce application.
The server farm consists of six servers providing different capabilities. Each capability is provided through a set of web services.
The requirements specification document contains several SLAs
(Service Level Agreements) like the following:
SLA-001: 99.5 percent of all transactions shall have a response time less than five seconds under a load of up-to 5000 concurrent users
The main objective is to assure that all the SLAs specified in the requirements specification document will be met before system release. You decide to apply a risk-based testing strategy and an early risk analysis confirms that performance is high risk. You can count on a well-written requirements specification and on a model of the system behavior under various load levels produced by the system architect.
Which of the following test activities would you expect to be the less important ones to achieve the test objectives in this scenario?
K4 3 credits
A. Perform unit performance testing for each single web service
B. Monitor the SLAs after the system has been released into the production environment
C. Perform system performance testing, consisting of several performance testing sessions, to verify if all the SLAs have been met
D. Perform static performance testing by reviewing the architectural model of the system under various load levels
Answer: B
QUESTION NO: 5
You are the Test Manager for a project to develop a client-server application that allows wine vendors to order custom-assorted packages of wines of several winemakers to sell special packages in their wine shops.
You decide to apply a blended risk-based and reactive testing strategy. Below the exit criteria for the system testinG. EXCR1- Each "critical" quality risk item must be covered by at least one test condition EXCR2- Each "critical" requirement must be covered by at least one test condition
The following are the "critical" requirements of the application:
REQ-SEL-1. The application shall allow the user to order only one package at a time
REQ-SEL-2. The application shall allow the user to select between four different packages (2bottles,
6-bottles, 12-bottles, 15-bottles)
REQ-SEL-3. The application shall allow the user to order a package containing at least 1 bottle and no more bottles than the package size. No error messages shall be displayed if the user selects a valid number of bottles (at least 1 bottle and no more than the package size)
REQ-SEL-4. The application shall display an error message "Invalid number of bottles" if an invalid number of bottles is selected by the user (zero bottles or a number higher than the package size)
REQ-PAY-1. The application shall allow the user to pay with the three accepted credit cards (Visa,
MasterCard, American Express)
REQ-PAY-2. The application shall display an error message "Invalid credit card" if invalid credit card data are given by the user
QUSTION NO: 11 The following is the unique "critical" quality risk item that has been identified:
CR-RSK-1. The GUI of the application might accept non-integer values for the input field designed to get the number of bottles from the user
Test analysis for system testing has just begun and the following test conditions have been identifieD.
TC-SEL-2. Test the selection of the package sizes
TC-SEL-4. Test wrong numbers of bottles for an order TC-CR-RSK-1. Test the accepted values from the input field designed to get the number of bottles from the user
Assume that you have used traceability to determine the logical test cases that cover all the requirements and the single risk item identified in that scenario.
Which of the following is a positive logical test that is complete and correct, and covers the
REQSEL-4 requirement?
K3 2 credits
A. Select a 6-bottles package, then try to insert 5 bottles; verify that no error messages are displayed
B. Select a 6-bottles package, then try to insert 7 bottles; verify that no error messages are displayed
C. Select a 6-bottles package, then try to insert 7 bottles; verify that the "Invalid number of bottles" message is displayed
D. Select a 6-bottles package, then try to insert 7 bottles
Answer: C
IASP SPP - 彼らはGoldmile-Infobizの問題集が有効なこと確認しました。 Microsoft GH-300 - 勉強中で、何の質問があると、メールで我々はあなたのためにすぐ解決します。 Goldmile-Infobizは専門家チームが自分の知識と経験をを利用してISQIのITIL ITIL-4-Foundation「ISTQB Certified Tester Advanced Level - Test Manager [Syllabus 2012]」認証試験の問題集を研究したものでございます。 私たちは、このキャリアの中で、10年以上にわたりプロとしてMicrosoft GH-300-JPN練習資料を作りました。 Amazon AWS-Certified-Developer-Associate-JP - Goldmile-Infobiz はIT業界に認定試験大綱の主要なサプライヤーとして、専門家は一緻して品質の高い商品を開発し続けています。
Updated: May 28, 2022