200-301최신시험 - 200-301시험대비 & Cisco Certified Network Associate Exam - Goldmile-Infobiz

Goldmile-Infobiz의Cisco인증 200-301최신시험시험준비를 하시고 시험패스하여 자격증을 취득하세요. 국제승인 자격증이라 고객님의 경쟁율을 업그레이드 시켜드립니다. 인재가 넘치는 IT업계에서 자기의 자리를 지켜나가려면 학력보다 능력이 더욱 중요합니다.고객님의 능력을 증명해주는 수단은 국제적으로 승인받은 IT인증자격증이 아니겠습니까? Cisco인증 200-301최신시험시험이 어렵다고 하여 두려워 하지 마세요. Cisco인증 200-301최신시험시험덤프의 인기는 이 시험과목이 얼마나 중요한지를 증명해줍니다. Goldmile-Infobiz의 Cisco인증 200-301최신시험덤프로 이 중요한 IT인증시험을 준비하시면 우수한 성적으로 시험을 통과하여 인정받는 IT전문가로 될것입니다. Goldmile-Infobiz는 여러분이Cisco 인증200-301최신시험인증시험 패스와 추후사업에 모두 도움이 되겠습니다.

인기가 높은 만큼Cisco 200-301최신시험시험을 패스하여 취득하게 되는 자격증의 가치가 높습니다.

Goldmile-Infobiz의 Cisco인증 200-301 - Cisco Certified Network Associate Exam최신시험덤프는 가장 최신시험에 대비하여 만들어진 공부자료로서 시험패스는 한방에 끝내줍니다. Goldmile-Infobiz는 고객님께서Cisco 200-301 최신버전자료첫번째 시험에서 패스할수 있도록 최선을 다하고 있습니다. 만일 어떤 이유로 인해 고객님이Cisco 200-301 최신버전자료시험에서 실패를 한다면 Goldmile-Infobiz는Cisco 200-301 최신버전자료덤프비용 전액을 환불 해드립니다.

Cisco인증 200-301최신시험시험취득 의향이 있는 분이 이 글을 보게 될것이라 믿고Goldmile-Infobiz에서 출시한 Cisco인증 200-301최신시험덤프를 강추합니다. Goldmile-Infobiz의Cisco인증 200-301최신시험덤프는 최강 적중율을 자랑하고 있어 시험패스율이 가장 높은 덤프자료로서 뜨거운 인기를 누리고 있습니다. IT인증시험을 패스하여 자격증을 취득하려는 분은Goldmile-Infobiz제품에 주목해주세요.

Goldmile-Infobiz에는Cisco Cisco 200-301최신시험인증시험의 특별한 합습가이드가 있습니다.

아직도Cisco 200-301최신시험 인증시험을 어떻게 패스할지 고민하시고 계십니까? Goldmile-Infobiz는 여러분이Cisco 200-301최신시험덤프자료로Cisco 200-301최신시험 인증시험에 응시하여 안전하게 자격증을 취득할 수 있도록 도와드립니다. Cisco 200-301최신시험 시험가이드를 사용해보지 않으실래요? Goldmile-Infobiz는 여러분께Cisco 200-301최신시험시험패스의 편리를 드릴 수 있다고 굳게 믿고 있습니다.

Cisco 인증200-301최신시험덤프 무료샘플을 다운받아 체험해보세요. Goldmile-Infobiz에서는 소프트웨어버전과 PDF버전 두가지버전으로 덤프를 제공해드립니다.PDF버전은 구매사이트에서 무료샘플을 다움받아 체험가능합니다.

200-301 PDF DEMO:

QUESTION NO: 1
Drag and Drop Question
Drag and drop the WLAN components from the left onto the correct descriptions on the right.
Answer:
Explanation:
The service port can be used management purposes, primarily for out-of-band management.
However, AP management traffic is not possible across the service port. In most cases, the service port is used as a "last resort" means of accessing the controller GUI for management purposes. For example, in the case where the system distribution ports on the controller are down or their communication to the wired network is otherwise degraded.
A dynamic interface with the Dynamic AP Management option enabled is used as the tunnel source for packets from the controller to the access point and as the destination for CAPWAP packets from the access point to the controller.
The virtual interface is used to support mobility management, Dynamic Host Configuration Protocol
(DHCP) relay, and embedded Layer 3 security such as guest web authentication. It also maintains the
DNS gateway host name used by Layer 3 security and mobility managers to verify the source of certificates when Layer 3 web authorization is enabled.
Reference: https://www.cisco.com/c/en/us/td/docs/wireless/controller/8-5/config- guide/b_cg85/ports_and_interfaces.html

QUESTION NO: 2
Which statement about Link Aggregation when implemented on a Cisco Wireless LAN
Controller is true?
A. One functional physical port is needed to pass client traffic
B. The EtherChannel must be configured in "mode active"
C. When enabled the WLC bandwidth drops to 500 Mbps
D. To pass client traffic two or more ports must be configured.
Answer: A
Explanation:
Link aggregation (LAG) is a partial implementation of the 802.3ad port aggregation standard. It bundles all of the controller's distribution system ports into a single 802.3ad port channel.
Restriction for Link aggregation:
- LAG requires the EtherChannel to be configured for `mode on' on both the controller and the
Catalyst switch -> Answer B is not correct.
- If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller -> Answer A is not correct while answer D is correct.
Reference: https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/ b_cg75_chapter_0100010.html

QUESTION NO: 3
Refer to the exhibit. C-router is to be used as a "router-on-a-stick" to route between the
VLANs.
All the interfaces have been properly configured and IP routing is operational. The hosts in the VLANs have been configured with the appropriate default gateway.
What is true about this configuration?
A. These commands need to be added to the configuration:
C-router(config)# router rip
C-router(config-router)# network 172.19.0.0
B. These commands need to be added to the configuration:
C-router(config)# router ospf 1
C-router(config-router)# network 172.19.0.0 0.0.3.255 area 0
C. These commands need to be added to the configuration:
C-router(config)# router eigrp 123
C-router(config-router)# network 172.19.0.0
D. No further routing configuration is required.
Answer: D
Explanation:
Since all the same router (C-router) is the default gateway for all three VLANs, all traffic destined to a different VLAN will be sent to the C-router. The C-router will have knowledge of all three networks since they will appear as directly connected in the routing table. Since the C-router already knows how to get to all three networks, no routing protocols need to be configured.

QUESTION NO: 4
Which two tasks must be performed to configure NTP to a trusted server in client mode on a single network device? (Choose two)
A. Verify the time zone.
B. Disable NTP broadcasts
C. Set the NTP server private key
D. Specify the IP address of the NTP server
E. Enable NTP authentication.
Answer: D,E
Explanation:
To configure authentication, perform this task in privileged mode:
Step 1: Configure an authentication key pair for NTP and specify whether the key will be trusted or untrusted.
Step 2: Set the IP address of the NTP server and the public key.
Step 3: Enable NTP client mode.
Step 4: Enable NTP authentication.
Step 5: Verify the NTP configuration.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst4000/8-
2glx/configuration/guide/ ntp.html

QUESTION NO: 5
A router running EIGRP has learned the same route from two different paths. Which parameter does the router use to select the best path?
A. administrative distance
B. as-path
C. metric
D. cost
Answer: C
Explanation:
If a router learns two different paths for the same network from the same routing protocol, it has to decide which route is better and will be placed in the routing table. Metric is the measure used to decide which route is better (lower number is better). Each routing protocol uses its own metric.
For example, RIP uses hop counts as a metric, while OSPF uses cost.
https://study-ccna.com/administrative-distance-metric/

Goldmile-Infobiz의Cisco Scrum SAFe-Practitioner 인증시험덤프는 자주 업데이트 되고, 오래 되고 더 이상 사용 하지 않는 문제들은 바로 삭제해버리며 새로운 최신 문제들을 추가 합니다. VMware 2V0-16.25 - 공부하는 시간도 적어지고 다른 공부자료에 투자하는 돈도 줄어듭니다. Goldmile-Infobiz는 여러분들한테 최고의Cisco Microsoft AI-102-KR문제와 답을 제공함으로 100%로의 보장 도를 자랑합니다, 여러분은Cisco Microsoft AI-102-KR인증시험의 패스로 IT업계여서도 또 직장에서도 한층 업그레이드되실 수 있습니다. Cisco인증 CompTIA CV0-004시험을 패스하여 자격증을 취득하시면 찬란한 미래가 찾아올것입니다. Pass4Tes의 자료들은 모두 우리의 전문가들이 연구와 노력 하에 만들어진 것이며.그들은 자기만의 지식과 몇 년간의 연구 경험으로 퍼펙트하게 만들었습니다.우리 덤프들은 품질은 보장하며 갱신 또한 아주 빠릅니다.우리의 덤프는 모두 실제시험과 유사하거나 혹은 같은 문제들임을 약속합니다.Goldmile-Infobiz는 100% 한번에 꼭 고난의도인Cisco인증Python Institute PCAP-31-03시험을 패스하여 여러분의 사업에 많은 도움을 드리겠습니다.

Updated: May 28, 2022