Goldmile-Infobiz는 여러분의 요구를 만족시켜드리는 사이트입니다. 많은 분들이 우리사이트의 it인증덤프를 사용함으로 관련it시험을 안전하게 패스를 하였습니다. 이니 우리 Goldmile-Infobiz사이트의 단골이 되었죠. Goldmile-Infobiz는 아주 믿을만하고 서비스 또한 만족스러운 사이트입니다. 만약 시험실패 시 우리는 100% 덤프비용 전액환불 해드립니다.그리고 시험을 패스하여도 우리는 일 년 동안 무료업뎃을 제공합니다. Cisco 인증200-301 It덤프시험출제경향을 퍼펙트하게 연구하여Goldmile-Infobiz에서는Cisco 인증200-301 It덤프시험대비덤프를 출시하였습니다.
CCNA 200-301 Goldmile-Infobiz을 선택함으로 100%인증시험을 패스하실 수 있습니다.
Cisco인증 200-301 - Cisco Certified Network Associate Exam It덤프시험패스는 고객님의 IT업계종사자로서의 전환점이 될수 있습니다.자격증을 취득하여 승진 혹은 연봉협상 방면에서 자신만의 위치를 지키고 더욱 멋진 IT인사로 거듭날수 있도록 고고싱할수 있습니다. 응시 전Cisco 200-301 덤프내용인증시험덤프로 최고의 시험대비준비를 하시기 바랍니다. Goldmile-Infobiz의 경험이 풍부한 전문가들이Cisco 200-301 덤프내용인증시험관련자료들을 계획적으로 페펙트하게 만들었습니다.Cisco 200-301 덤프내용인증시험응시에는 딱 좋은 자료들입니다.
Goldmile-Infobiz 덤프를 구매하시면 이제 그런 고민은 끝입니다. 덤프에 있는 내용만 공부하시면 IT인증자격증 취득은 한방에 가능합니다. IT업계에 종사하는 분이 점점 많아지고 있는 지금 IT인증자격증은 필수품으로 되었습니다.
Cisco 200-301 It덤프 - Goldmile-Infobiz 덤프를 구매하시면 이제 그런 고민은 끝입니다.
학원다니면서 많은 지식을 장악한후Cisco 200-301 It덤프시험보시는것도 좋지만 회사다니느랴 야근하랴 시간이 부족한 분들은Cisco 200-301 It덤프덤프만 있으면 엄청난 학원수강료 필요없이 20~30시간의 독학만으로도Cisco 200-301 It덤프시험패스가 충분합니다. 또한 취업생분들은 우선 자격증으로 취업문을 두드리고 일하면서 실무를 익혀가는방법도 좋지 않을가 생각됩니다.
Cisco인증 200-301 It덤프시험패스가 힘들다한들Goldmile-Infobiz덤프만 있으면 어려운 시험도 쉬워질수 밖에 없습니다. Cisco인증 200-301 It덤프덤프에 있는 문제만 잘 이해하고 습득하신다면Cisco인증 200-301 It덤프시험을 패스하여 자격증을 취득해 자신의 경쟁율을 업그레이드하여 경쟁시대에서 안전감을 보유할수 있습니다.
200-301 PDF DEMO:
QUESTION NO: 1
Which statement about Link Aggregation when implemented on a Cisco Wireless LAN
Controller is true?
A. One functional physical port is needed to pass client traffic
B. The EtherChannel must be configured in "mode active"
C. When enabled the WLC bandwidth drops to 500 Mbps
D. To pass client traffic two or more ports must be configured.
Answer: A
Explanation:
Link aggregation (LAG) is a partial implementation of the 802.3ad port aggregation standard. It bundles all of the controller's distribution system ports into a single 802.3ad port channel.
Restriction for Link aggregation:
- LAG requires the EtherChannel to be configured for `mode on' on both the controller and the
Catalyst switch -> Answer B is not correct.
- If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller -> Answer A is not correct while answer D is correct.
Reference: https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/ b_cg75_chapter_0100010.html
QUESTION NO: 2
Refer to the exhibit. C-router is to be used as a "router-on-a-stick" to route between the
VLANs.
All the interfaces have been properly configured and IP routing is operational. The hosts in the VLANs have been configured with the appropriate default gateway.
What is true about this configuration?
A. These commands need to be added to the configuration:
C-router(config)# router rip
C-router(config-router)# network 172.19.0.0
B. These commands need to be added to the configuration:
C-router(config)# router ospf 1
C-router(config-router)# network 172.19.0.0 0.0.3.255 area 0
C. These commands need to be added to the configuration:
C-router(config)# router eigrp 123
C-router(config-router)# network 172.19.0.0
D. No further routing configuration is required.
Answer: D
Explanation:
Since all the same router (C-router) is the default gateway for all three VLANs, all traffic destined to a different VLAN will be sent to the C-router. The C-router will have knowledge of all three networks since they will appear as directly connected in the routing table. Since the C-router already knows how to get to all three networks, no routing protocols need to be configured.
QUESTION NO: 3
Drag and Drop Question
Drag and drop the WLAN components from the left onto the correct descriptions on the right.
Answer:
Explanation:
The service port can be used management purposes, primarily for out-of-band management.
However, AP management traffic is not possible across the service port. In most cases, the service port is used as a "last resort" means of accessing the controller GUI for management purposes. For example, in the case where the system distribution ports on the controller are down or their communication to the wired network is otherwise degraded.
A dynamic interface with the Dynamic AP Management option enabled is used as the tunnel source for packets from the controller to the access point and as the destination for CAPWAP packets from the access point to the controller.
The virtual interface is used to support mobility management, Dynamic Host Configuration Protocol
(DHCP) relay, and embedded Layer 3 security such as guest web authentication. It also maintains the
DNS gateway host name used by Layer 3 security and mobility managers to verify the source of certificates when Layer 3 web authorization is enabled.
Reference: https://www.cisco.com/c/en/us/td/docs/wireless/controller/8-5/config- guide/b_cg85/ports_and_interfaces.html
QUESTION NO: 4
A router running EIGRP has learned the same route from two different paths. Which parameter does the router use to select the best path?
A. administrative distance
B. as-path
C. metric
D. cost
Answer: C
Explanation:
If a router learns two different paths for the same network from the same routing protocol, it has to decide which route is better and will be placed in the routing table. Metric is the measure used to decide which route is better (lower number is better). Each routing protocol uses its own metric.
For example, RIP uses hop counts as a metric, while OSPF uses cost.
https://study-ccna.com/administrative-distance-metric/
QUESTION NO: 5
Which two tasks must be performed to configure NTP to a trusted server in client mode on a single network device? (Choose two)
A. Verify the time zone.
B. Disable NTP broadcasts
C. Set the NTP server private key
D. Specify the IP address of the NTP server
E. Enable NTP authentication.
Answer: D,E
Explanation:
To configure authentication, perform this task in privileged mode:
Step 1: Configure an authentication key pair for NTP and specify whether the key will be trusted or untrusted.
Step 2: Set the IP address of the NTP server and the public key.
Step 3: Enable NTP client mode.
Step 4: Enable NTP authentication.
Step 5: Verify the NTP configuration.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst4000/8-
2glx/configuration/guide/ ntp.html
Goldmile-Infobiz는 자격증 응시자에게Cisco SAP C-ARSUM-2508 시험 준비를 위한 현재 그리고 가장 최근의 자료들을 제공하는 이 산업 영역의 리더입니다. SAP C_THR70_2505 - 하루 빨리 덤프를 마련하여 시험을 준비하시면 자격증 취득이 빨라집니다. 여러분은Cisco Cisco 350-501인증시험을 패스함으로 IT업계관련 직업을 찿고자하는 분들에게는 아주 큰 가산점이 될수 있으며, 성덩한 IT업계사업자와 한걸음 가까와 집니다. Cisco Microsoft MS-900-KR덤프에는 가장 최신시험문제의 기출문제가 포함되어있어 높은 적주율을 자랑하고 있습니다. 지금 사회에 능력자들은 아주 많습니다.it인재들도 더욱더 많아지고 있습니다.많은 it인사들은 모두 관연 it인증시험에 참가하여 자격증취득을 합니다.자기만의 자리를 확실히 지키고 더 높은 자리에 오르자면 필요한 스펙이니까요.Juniper JN0-650시험은Cisco인증의 중요한 시험이고 또 많은 it인사들은Cisco자격증을 취득하려고 노력하고 있습니다.
Updated: May 28, 2022