왜냐면 우리 Goldmile-Infobiz에는 베터랑의 전문가들로 이루어진 연구팀이 잇습니다, 그들은 it지식과 풍부한 경험으로 여러 가지 여러분이Cisco인증350-401시험유효덤프시험을 패스할 수 있을 자료 등을 만들었습니다 여러분이Cisco인증350-401시험유효덤프시험에 많은 도움이Cisco 350-401시험유효덤프될 것입니다. Goldmile-Infobiz 가 제공하는350-401시험유효덤프테스트버전과 문제집은 모두Cisco 350-401시험유효덤프인증시험에 대하여 충분한 연구 끝에 만든 것이기에 무조건 한번에Cisco 350-401시험유효덤프시험을 패스하실 수 있습니다. 때문에Cisco 350-401시험유효덤프덤프의 인기는 당연히 짱 입니다. Goldmile-Infobiz에서는350-401시험유효덤프관련 자료도 제공함으로 여러분처럼 IT 인증시험에 관심이 많은 분들한테 아주 유용한 자료이자 학습가이드입니다. Goldmile-Infobiz는 또 여러분이 원하도 필요로 하는 최신 최고버전의350-401시험유효덤프문제와 답을 제공합니다. Cisco 350-401시험유효덤프인증시험에 응시하고 싶으시다면 좋은 학습자료와 학습 가이드가 필요합니다.Cisco 350-401시험유효덤프시험은 it업계에서도 아주 중요한 인증입니다.
여러분이 안전하게 간단하게Cisco인증350-401시험유효덤프시험을 응시할 수 있는 자료입니다.
인테넷에 검색하면 Cisco 350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)시험유효덤프시험덤프공부자료가 헤아릴수 없을 정도로 많이 검색됩니다. 여러분은 그러한Cisco 350-401 시험문제집데모들을 보시고 다시 우리의 덤프와 비교하시면, 우리의 덤프는 다른 사이트덤프와 차원이 다른 덤프임을 아사될 것 입니다. 우리 Goldmile-Infobiz사이트에서 제공되는Cisco인증350-401 시험문제집시험덤프의 일부분인 데모 즉 문제와 답을 다운받으셔서 체험해보면 우리Goldmile-Infobiz에 믿음이 갈 것입니다.
Goldmile-Infobiz의 Cisco인증 350-401시험유효덤프덤프의 무료샘플을 이미 체험해보셨죠? Goldmile-Infobiz의 Cisco인증 350-401시험유효덤프덤프에 단번에 신뢰가 생겨 남은 문제도 공부해보고 싶지 않나요? Goldmile-Infobiz는 고객님들의 시험부담을 덜어드리기 위해 가벼운 가격으로 덤프를 제공해드립니다. Goldmile-Infobiz의 Cisco인증 350-401시험유효덤프로 시험패스하다 더욱 넓고 좋은곳으로 고고싱 하세요.
Goldmile-Infobiz의 믿음직한 Cisco인증 Cisco 350-401시험유효덤프덤프를 공부해보세요.
IT업계에 종사하고 계신 분은Cisco 350-401시험유효덤프 시험을 패스하여 자격증을 취득하려고 검색하다 저희 블로그를 보게 되시고 저희 사이트까지 방문하게 될것입니다. 방문하는 순간 Cisco 350-401시험유효덤프시험에 대한 두려움이 사라질것입니다. 완벽한 구매후 서비스까지 겸비하고 있어 자격증을 취득하는데서의 믿음직스러운 동반자로 되어드릴게요.
Goldmile-Infobiz 의 덤프는 모두 엘리트한 전문가들이 만들어낸 만큼 시험문제의 적중률은 아주 높습니다. 거의 100%의 정확도를 자랑하고 있습니다.
350-401 PDF DEMO:
QUESTION NO: 1
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
QUESTION NO: 2
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.
QUESTION NO: 3
What is the difference between a RIB and a FIB?
A. The FIB is populated based on RIB content
B. The RIB is used to make IP source prefix-based switching decisions
C. The RIB maintains a mirror image of the FIB
D. The FIB is where all IP routing information is stored
Answer: A
Explanation:
CEF uses a Forwarding Information Base (FIB) to make IP destination prefix-based switching decisions.
The FIB is conceptually similar to a routing table or information base. It maintains a mirror image of the forwarding information contained in the IP routing table. When routing or topology changes occur in the network, the IP routing table is updated, and those changes are reflected in the FIB. The
FIB maintains next-hop address information based on the information in the IP routing table. Because there is a one-to-one correlation between FIB entries and routing table entries, the FIB contains all known routes and eliminates the need for route cache maintenance that is associated with earlier switching paths such as fast switching and optimum switching.
Note: In order to view the Routing information base (RIB) table, use the "show ip route" command.
To view the Forwarding Information Base (FIB), use the "show ip cef" command. RIB is in Control plane while FIB is in Data plane.
QUESTION NO: 4
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.
QUESTION NO: 5
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.
Microsoft SC-100 - 더는 고민고민 하지마시고 덤프 받아가세요. Goldmile-Infobiz의Cisco인증 SCDM CCDM덤프를 공부하여 자격증을 땁시다. 만약 아직도Cisco IBM C1000-205인증시험 위하여 많은 시간과 정력을 소모하며 열심히 공부하고 있습니까? 아직도 어덯게하면Cisco IBM C1000-205인증시험을 빠르게 취득할 수 있는 방법을 못찿고 계십니까? 지금Goldmile-Infobiz에서Cisco IBM C1000-205인증시험을 안전하게 넘을 수 있도록 대책을 내드리겠습니다. Goldmile-Infobiz의Cisco인증 CFA Institute Sustainable-Investing덤프는 100% 패스보장 가능한 덤프자료입니다.한번만 믿어주시고Goldmile-Infobiz제품으로 가면 시험패스는 식은 죽 먹기처럼 간단합니다. Goldmile-Infobiz를 선택함으로, Goldmile-Infobiz는 여러분Cisco인증Cisco 200-201시험을 패스할 수 있도록 보장하고,만약 시험실패시 Goldmile-Infobiz에서는 덤프비용전액환불을 약속합니다.
Updated: May 28, 2022