350-401시험응시료 & 350-401 It인증시험 - Cisco 350-401인증문제 - Goldmile-Infobiz

우리 Goldmile-Infobiz 의 문제집들은 모두 100%보장 도를 자랑하며 만약 우리Goldmile-Infobiz의 제품을 구매하였다면Cisco관련 시험패스와 자격증취득은 근심하지 않으셔도 됩니다. 여러분은 IT업계에서 또 한층 업그레이드 될것입니다. 일반적으로Cisco인증시험은 IT업계전문가들이 끊임없는 노력과 지금까지의 경험으로 연구하여 만들어낸 제일 정확한 시험문제와 답들이니. Cisco 350-401시험응시료인증시험에 응시하고 싶으시다면 좋은 학습자료와 학습 가이드가 필요합니다.Cisco 350-401시험응시료시험은 it업계에서도 아주 중요한 인증입니다. 시험패스를 원하신다면 충분한 시험준비는 필수입니다. Goldmile-Infobiz는 아주 믿을만하고 서비스 또한 만족스러운 사이트입니다.

Cisco인증 350-401시험응시료시험을 패스하여 자격증을 취득하면 소원이 이루어집니다.

인터넷에는Cisco인증 350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)시험응시료시험대비공부자료가 헤아릴수 없을 정도로 많습니다.이렇게 많은Cisco인증 350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)시험응시료공부자료중 대부분 분들께서 저희Goldmile-Infobiz를 선택하는 이유는 덤프 업데이트가 다른 사이트보다 빠르다는 것이 제일 큰 이유가 아닐가 싶습니다. 시험합격하면 좋은 소식 전해주세요. Cisco인증 350-401 예상문제시험은 IT인증자격증중 가장 인기있는 자격증을 취득하는 필수시험 과목입니다.

아무런 노력을 하지 않고 승진이나 연봉인상을 꿈꾸고 있는 분이라면 이 글을 검색해낼수 없었을것입니다. 승진이나 연봉인상을 꿈꾸면 승진과 연봉인상을 시켜주는 회사에 능력을 과시해야 합니다. IT인증시험은 국제적으로 승인해주는 자격증을 취득하는 시험입니다.

Cisco 350-401시험응시료 - 자격증 많이 취득하면 더욱 여유롭게 직장생활을 즐길수 있습니다.

Goldmile-Infobiz 는 아주 우수한 IT인증자료사이트입니다. 우리Goldmile-Infobiz에서 여러분은Cisco 350-401시험응시료인증시험관련 스킬과시험자료를 얻을수 있습니다. 여러분은 우리Goldmile-Infobiz 사이트에서 제공하는Cisco 350-401시험응시료관련자료의 일부분문제와답등 샘플을 무료로 다운받아 체험해볼 수 있습니다. 그리고Goldmile-Infobiz에서는Cisco 350-401시험응시료자료구매 후 추후 업데이트되는 동시에 최신버전을 무료로 발송해드립니다. 우리는Cisco 350-401시험응시료인증시험관련 모든 자료를 여러분들에서 제공할 것입니다. 우리의 IT전문 팀은 부단한 업계경험과 연구를 이용하여 정확하고 디테일 한 시험문제와 답으로 여러분을 어시스트 해드리겠습니다.

우리의350-401시험응시료시험마스터방법은 바로IT전문가들이제공한 시험관련 최신연구자료들입니다. 우리Goldmile-Infobiz 여러분은350-401시험응시료시험관련 최신버전자료들을 얻을 수 있습니다.

350-401 PDF DEMO:

QUESTION NO: 1
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.

QUESTION NO: 2
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html

QUESTION NO: 3
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.

QUESTION NO: 4
What is the difference between a RIB and a FIB?
A. The FIB is populated based on RIB content
B. The RIB is used to make IP source prefix-based switching decisions
C. The RIB maintains a mirror image of the FIB
D. The FIB is where all IP routing information is stored
Answer: A
Explanation:
CEF uses a Forwarding Information Base (FIB) to make IP destination prefix-based switching decisions.
The FIB is conceptually similar to a routing table or information base. It maintains a mirror image of the forwarding information contained in the IP routing table. When routing or topology changes occur in the network, the IP routing table is updated, and those changes are reflected in the FIB. The
FIB maintains next-hop address information based on the information in the IP routing table. Because there is a one-to-one correlation between FIB entries and routing table entries, the FIB contains all known routes and eliminates the need for route cache maintenance that is associated with earlier switching paths such as fast switching and optimum switching.
Note: In order to view the Routing information base (RIB) table, use the "show ip route" command.
To view the Forwarding Information Base (FIB), use the "show ip cef" command. RIB is in Control plane while FIB is in Data plane.

QUESTION NO: 5
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.

Goldmile-Infobiz에는 베터랑의전문가들로 이루어진 연구팀이 잇습니다, 그들은 it지식과 풍부한 경험으로 여러 가지 여러분이Cisco인증Fortinet FCSS_NST_SE-7.4시험을 패스할 수 있을 자료 등을 만들었습니다, Goldmile-Infobiz 에서는 일년무료 업뎃을 제공하며, Goldmile-Infobiz 의 덤프들은 모두 높은 정확도를 자랑합니다. Goldmile-Infobiz의 부지런한 IT전문가들이 자기만의 지식과 끊임없는 노력과 경험으로 최고의Cisco ACMP Global CCMP합습자료로Cisco ACMP Global CCMP인증시험을 응시하실 수 있습니다.Cisco ACMP Global CCMP인증시험은 IT업계에서의 비중은 아주 큽니다. Amazon SAP-C02 - Goldmile-Infobiz의 도움을 받겠다고 하면 우리는 무조건 최선을 다하여 한번에 패스하도록 도와드릴 것입니다. Goldmile-Infobiz를 선택함으로, Goldmile-Infobiz는 여러분Cisco인증Palo Alto Networks XSIAM-Engineer시험을 패스할 수 있도록 보장하고,만약 시험실패시 Goldmile-Infobiz에서는 덤프비용전액환불을 약속합니다. Microsoft SC-401 - Goldmile-Infobiz는 많은 IT인사들의 요구를 만족시켜드릴 수 있는 사이트입니다.

Updated: May 28, 2022