IT전문가들이 자신만의 경험과 끊임없는 노력으로 작성한 Cisco 350-401시험자료덤프에 관심이 있는데 선뜻 구매결정을 내릴수없는 분은Cisco 350-401시험자료덤프 구매 사이트에서 메일주소를 입력한후 DEMO를 다운받아 문제를 풀어보고 구매할수 있습니다. 자격증을 많이 취득하면 좁은 취업문도 넓어집니다. Cisco 350-401시험자료 덤프로Cisco 350-401시험자료시험을 패스하여 자격즉을 쉽게 취득해보지 않으실래요? 여러분은 IT업계에서 또 한층 업그레이드 될것입니다. Goldmile-Infobiz는 여러분이 원하는 최신 최고버전의 Cisco 인증350-401시험자료덤프를 제공합니다. 만일 어떤 이유로 인해 고객이 첫 번째 시도에서 실패를 한다면, Goldmile-Infobiz는 고객에게Cisco 350-401시험자료덤프비용 전액을 환불 해드립니다.환불보상은 다음의 필수적인 정보들을 전제로 합니다.
Cisco 350-401시험자료덤프로Cisco 350-401시험자료시험패스 GO GO GO !
CCNP Enterprise 350-401시험자료 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR) Software 버전은 PDF버전의 보조용이기에 단독 판매하지 않습니다. 만약Goldmile-Infobiz의 제품을 구매하려면, 우리Goldmile-Infobiz에서는 아주 디테일 한 설명과 최신버전 최고품질의자료를 즉적중율이 높은 문제와 답을제공합니다.Cisco 350-401 인기시험덤프자료는 충분한 시험대비자료가 될 것입니다. 안심하시고 Goldmile-Infobiz가 제공하는 상품을 사용하시고, 100%통과 율을 확신합니다.
Goldmile-Infobiz에는 전문적인 업계인사들이Cisco 350-401시험자료시험문제와 답에 대하여 연구하여, 시험준비중인 여러분들한테 유용하고 필요한 시험가이드를 제공합니다. 만약Goldmile-Infobiz의 제품을 구매하려면, 우리Goldmile-Infobiz에서는 아주 디테일 한 설명과 최신버전 최고품질의자료를 즉적중율이 높은 문제와 답을제공합니다.Cisco 350-401시험자료자료는 충분한 시험대비자료가 될 것입니다. 안심하시고 Goldmile-Infobiz가 제공하는 상품을 사용하시고, 100%통과 율을 확신합니다.
Cisco 350-401시험자료 - Goldmile-Infobiz를 선택은 여러분이 최고의 선택입니다.
저희가 알아본 데 의하면 많은it인사들이Cisco인증350-401시험자료시험을 위하여 많은 시간을 투자하고 잇다고 합니다.하지만 특별한 학습 반 혹은 인터넷강이 같은건 선택하지 않으셨습니다.때문에 패스는 아주 어렵습니다.보통은 한번에 패스하시는 분들이 적습니다.우리 Goldmile-Infobiz에서는 아주 믿을만한 학습가이드를 제공합니다.우리 Goldmile-Infobiz에는Cisco인증350-401시험자료테스트버전과Cisco인증350-401시험자료문제와 답 두 가지 버전이 있습니다.우리는 여러분의Cisco인증350-401시험자료시험을 위한 최고의 문제와 답 제공은 물론 여러분이 원하는 모든 it인증시험자료들을 선사할 수 있습니다.
우리Goldmile-Infobiz에는 아주 엘리트 한 전문가들로 구성된 팀입니다 그들은 끈임 없는 연구와 자기자신만의 지식으로 많은 IT관연 덤프자료를 만들어 냄으로 여러분의 꿈을 이루어드립니다, 기존의 시험문제와 답과 시험문제분석 등입니다. Goldmile-Infobiz에서 제공하는Cisco 350-401시험자료시험자료의 문제와 답은 실제시험의 문제와 답과 아주 비슷합니다.
350-401 PDF DEMO:
QUESTION NO: 1
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.
QUESTION NO: 2
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.
QUESTION NO: 3
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.
QUESTION NO: 4
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D
QUESTION NO: 5
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
30분이란 특별학습가이드로 여러분은Cisco Amazon AIF-C01인증시험을 한번에 통과할 수 있습니다, Goldmile-Infobiz에서Cisco Amazon AIF-C01시험자료의 문제와 답이 실제시험의 문제와 답과 아주 비슷한 덤프만 제공합니다. Linux Foundation CKS - Goldmile-Infobiz는 시험에서 불합격성적표를 받으시면 덤프비용을 환불하는 서 Juniper JN0-650 - Goldmile-Infobiz에서는 시험문제가 업데이트되면 덤프도 업데이트 진행하도록 최선을 다하여 업데이트서비스를 제공해드려 고객님께서소유하신 덤프가 시장에서 가장 최신버전덤프로 되도록 보장하여 시험을 맞이할수 있게 도와드립니다. 많은 사이트에서 Cisco인증 Amazon MLA-C01-KR시험대비덤프를 제공해드리는데Goldmile-Infobiz를 최강 추천합니다. Goldmile-Infobiz의 Cisco ISACA CISM-CN덤프가 고객님의 시험패스테 조금이나마 도움이 되신다면 행복으로 느끼겠습니다.
Updated: May 28, 2022