Goldmile-Infobiz에서는 전문Cisco 350-401최신핫덤프인증시험을 겨냥한 덤프 즉 문제와 답을 제공합니다.여러분이 처음Cisco 350-401최신핫덤프인증시험준비라면 아주 좋은 덤프입니다. Goldmile-Infobiz에서 제공되는 덤프는 모두 실제시험과 아주 유사한 덤프들입니다.Cisco 350-401최신핫덤프인증시험패스는 보장합니다. 만약 떨어지셨다면 우리는 덤프비용전액을 환불해드립니다. 다른 사이트에서도Cisco 350-401최신핫덤프인증시험관련 자료를 보셨다고 믿습니다.하지만 우리 Goldmile-Infobiz의 자료는 차원이 다른 완벽한 자료입니다.100%통과 율은 물론Goldmile-Infobiz을 선택으로 여러분의 직장생활에 더 낳은 개변을 가져다 드리며 ,또한Goldmile-Infobiz를 선택으로 여러분은 이미 충분한 시험준비를 하였습니다.우리는 여러분이 한번에 통과하게 도와주고 또 일년무료 업데이트서비스도 드립니다. Goldmile-Infobiz의 Cisco 350-401최신핫덤프덤프를 구매하기전 우선 pdf버전 덤프샘플을 다운받아 덤프문제를 공부해보시면Goldmile-Infobiz덤프품질에 신뢰가 느껴질것입니다.
CCNP Enterprise 350-401 소프트웨어버전은실력테스트용으로 PDF버전공부후 보조용으로 사용가능합니다.
Cisco 350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)최신핫덤프 덤프는Cisco 350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)최신핫덤프시험문제변경에 따라 주기적으로 업데이트를 진행하여 저희 덤프가 항상 가장 최신버전이도록 보장해드립니다. Goldmile-Infobiz는 IT인증자격증을 취득하려는 IT업계 인사들의 검증으로 크나큰 인지도를 가지게 되었습니다. 믿고 애용해주신 분들께 감사의 인사를 드립니다.
Cisco 350-401최신핫덤프 덤프구매전 한국어 온라인상담서비스부터 구매후 덤프 무료 업데이트버전제공 , Cisco 350-401최신핫덤프시험불합격시 덤프비용 전액환불 혹은 다른 과목으로 교환 등 저희는 구매전부터 구매후까지 철저한 서비스를 제공해드립니다. Cisco 350-401최신핫덤프 덤프는 인기덤프인데 지금까지 덤프를 구매한후 환불신청하신 분은 아직 없었습니다.
Cisco 350-401최신핫덤프 - 여러분은 우리.
IT업계 종사자라면 누구나 Cisco 인증350-401최신핫덤프시험을 패스하고 싶어하리라고 믿습니다. 많은 분들이 이렇게 좋은 인증시험은 아주 어렵다고 생각합니다. 네 맞습니다. 패스할 확율은 아주 낮습니다. 노력하지 않고야 당연히 불가능한 일이 아니겠습니까? Cisco 인증350-401최신핫덤프 시험은 기초 지식 그리고 능숙한 전업지식이 필요 합니다. Goldmile-Infobiz는 여러분들한테Cisco 인증350-401최신핫덤프시험을 쉽게 빨리 패스할 수 있도록 도와주는 사이트입니다. Goldmile-Infobiz의Cisco 인증350-401최신핫덤프시험관련 자료로 여러분은 짧은 시간내에 간단하게 시험을 패스할수 있습니다. 시간도 절약하고 돈도 적게 들이는 이런 제안은 여러분들한테 딱 좋은 해결책이라고 봅니다.
비스를 제공해드려 아무런 걱정없이 시험에 도전하도록 힘이 되어드립니다. Goldmile-Infobiz덤프를 사용하여 시험에서 통과하신 분이 전해주신 희소식이 Goldmile-Infobiz 덤프품질을 증명해드립니다.
350-401 PDF DEMO:
QUESTION NO: 1
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.
QUESTION NO: 2
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.
QUESTION NO: 3
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.
QUESTION NO: 4
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D
QUESTION NO: 5
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
Cisco Microsoft MD-102덤프를 구매하려면 먼저Cisco Microsoft MD-102샘플문제를 다운받아 덤프품질을 검증후 주문하시면 믿음이 생길것입니다. SAP C-ARP2P-2508 - IT인증시험문제는 수시로 변경됩니다. 만일Cisco Fortinet NSE7_CDS_AR-7.6인증시험을 첫 번째 시도에서 실패를 한다면 Cisco Fortinet NSE7_CDS_AR-7.6덤프비용 전액을 환불 할 것입니다. Cisco인증 Huawei H19-338-ENU시험을 패스해서 자격증을 취득하려고 하는데 시험비며 학원비며 공부자료비며 비용이 만만치 않다구요? 제일 저렴한 가격으로 제일 효과좋은Goldmile-Infobiz 의 Cisco인증 Huawei H19-338-ENU덤프를 알고 계시는지요? Goldmile-Infobiz 의 Cisco인증 Huawei H19-338-ENU덤프는 최신 시험문제에 근거하여 만들어진 시험준비공부가이드로서 학원공부 필요없이 덤프공부만으로도 시험을 한방에 패스할수 있습니다. Goldmile-Infobiz의 IT전문가들이 자신만의 경험과 끊임없는 노력으로 최고의Cisco VMware 2V0-17.25학습자료를 작성해 여러분들이Cisco VMware 2V0-17.25시험에서 패스하도록 도와드립니다.
Updated: May 28, 2022