최근 IT 업종에 종사하는 분들이 점점 늘어가는 추세하에 경쟁이 점점 치열해지고 있습니다. IT인증시험은 국제에서 인정받는 효력있는 자격증을 취득하는 과정으로서 널리 알려져 있습니다. Goldmile-Infobiz의 Cisco인증 350-401 Dump덤프는IT인증시험의 한 과목인 Cisco인증 350-401 Dump시험에 대비하여 만들어진 시험전 공부자료인데 높은 시험적중율과 친근한 가격으로 많은 사랑을 받고 있습니다. Cisco 350-401 Dump 시험준비를 어떻게 해야할지 고민중이세요? 이 블로그의 이 글을 보는 순간 고민은 버리셔도 됩니다. Goldmile-Infobiz는 IT업계의 많은 분들께Cisco 350-401 Dump시험을 패스하여 자격증을 취득하는 목표를 이루게 도와드렸습니다. Goldmile-Infobiz의Cisco인증 350-401 Dump시험덤프 공부가이드는 시장에서 가장 최신버전이자 최고의 품질을 지닌 시험공부자료입니다.IT업계에 종사중이라면 IT자격증취득을 승진이나 연봉협상의 수단으로 간주하고 자격증취득을 공을 들여야 합니다.회사다니면서 공부까지 하려면 몸이 힘들어 스트레스가 많이 쌓인다는것을 헤아려주는Goldmile-Infobiz가 IT인증자격증에 도전하는데 성공하도록Cisco인증 350-401 Dump시험대비덤프를 제공해드립니다.
CCNP Enterprise 350-401 체험 후 우리의Goldmile-Infobiz에 신뢰감을 느끼게 됩니다.
Cisco 350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR) Dump덤프는Cisco 350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR) Dump시험 최근문제를 해석한 기출문제 모음집으로서 시험패스가 한결 쉬워지도록 도와드리는 최고의 자료입니다. Goldmile-Infobiz 을 선택하면 Goldmile-Infobiz 는 여러분을 빠른시일내에 시험관련지식을 터득하게 할 것이고Cisco 350-401 시험내용인증시험도 고득점으로 패스하게 해드릴 것입니다. Goldmile-Infobiz 의 학습가이드에는Cisco 350-401 시험내용인증시험의 예상문제, 시험문제와 답입니다.
많은 사이트에서도 무료Cisco 350-401 Dump덤프데모를 제공합니다.우리도 마찬가지입니다.여러분은 그러한Cisco 350-401 Dump데모들을 보시고 다시 우리의 덤프와 비교하시면 ,우리의 덤프는 다른 사이트덤프와 차원이 다른 덤프임을 아시될것입니다, 우리Goldmile-Infobiz에서 제공되는 덤프는 100%보장 도를 자랑하며,여러분은 시험패스로 인해 성공과 더 가까워 졌답니다
Cisco 350-401 Dump - 만약 여러분이 시험에서 떨어졌다면 우리는 덤프비용전액을 환불해드립니다.
요즘같이 시간인즉 금이라는 시대에, 우리 Goldmile-Infobiz선택으로Cisco 350-401 Dump인증시험응시는 아주 좋은 딜입니다. 우리는 100%시험패스를 보장하고 또 일년무료 업데이트서비스를 제공합니다. 그리고 시험에서 떨어지셨다고 하시면 우리는 덤프비용전액 환불을 약속 드립니다.
Goldmile-Infobiz는 많은 IT인사들의 요구를 만족시켜드릴 수 있는 사이트입니다. 비록Cisco 350-401 Dump인증시험은 어렵지만 우리Goldmile-Infobiz의 문제집으로 가이드 하면 여러분은 아주 자신만만하게 응시하실 수 있습니다.
350-401 PDF DEMO:
QUESTION NO: 1
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.
QUESTION NO: 2
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.
QUESTION NO: 3
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
QUESTION NO: 4
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.
QUESTION NO: 5
What is the difference between a RIB and a FIB?
A. The FIB is populated based on RIB content
B. The RIB is used to make IP source prefix-based switching decisions
C. The RIB maintains a mirror image of the FIB
D. The FIB is where all IP routing information is stored
Answer: A
Explanation:
CEF uses a Forwarding Information Base (FIB) to make IP destination prefix-based switching decisions.
The FIB is conceptually similar to a routing table or information base. It maintains a mirror image of the forwarding information contained in the IP routing table. When routing or topology changes occur in the network, the IP routing table is updated, and those changes are reflected in the FIB. The
FIB maintains next-hop address information based on the information in the IP routing table. Because there is a one-to-one correlation between FIB entries and routing table entries, the FIB contains all known routes and eliminates the need for route cache maintenance that is associated with earlier switching paths such as fast switching and optimum switching.
Note: In order to view the Routing information base (RIB) table, use the "show ip route" command.
To view the Forwarding Information Base (FIB), use the "show ip cef" command. RIB is in Control plane while FIB is in Data plane.
Cisco인증ACMP Global CCMP시험은 IT인증시험과목중 가장 인기있는 시험입니다. Huawei H28-315_V1.0 - Goldmile-Infobiz시험공부자료를 선택하시면 자격증취득의 소원이 이루어집니다. IIA IIA-CIA-Part2 - 거의 100%의 정확도를 자랑하고 있습니다. Goldmile-Infobiz의Cisco인증 ACAMS CAMS-CN덤프에는 실제시험문제의 기출문제와 예상문제가 수록되어있어 그 품질 하나 끝내줍니다.적중율 좋고 가격저렴한 고품질 덤프는Goldmile-Infobiz에 있습니다. Cisco인증 Workday Workday-Pro-Talent-and-Performance시험을 패스하여 자격증을 취득하면 소원이 이루어집니다.
Updated: May 28, 2022