Cisco인증 350-401 Dump시험을 패스하여 자격증을 취득하시면 찬란한 미래가 찾아올것입니다. Cisco인증 350-401 Dump인증시험을 패스하여 취득한 자격증은 IT인사로서의 능력을 증명해주며 IT업계에 종사하는 일원으로서의 자존심입니다. Goldmile-Infobiz 의 Cisco인증 350-401 Dump덤프는 시험패스에 초점을 맞추어 제일 간단한 방법으로 시험을 패스하도록 밀어주는 시험공부가이드입니다.구매전Cisco인증 350-401 Dump무료샘플을 다운받아 적성에 맞는지 확인하고 구매할지 않할지 선택하시면 됩니다. Goldmile-Infobiz는 많은 IT인사들이Cisco인증시험에 참가하고 완벽한350-401 Dump인증시험자료로 응시하여 안전하게Cisco 350-401 Dump인증시험자격증 취득하게 하는 사이트입니다. Pass4Tes의 자료들은 모두 우리의 전문가들이 연구와 노력 하에 만들어진 것이며.그들은 자기만의 지식과 몇 년간의 연구 경험으로 퍼펙트하게 만들었습니다.우리 덤프들은 품질은 보장하며 갱신 또한 아주 빠릅니다.우리의 덤프는 모두 실제시험과 유사하거나 혹은 같은 문제들임을 약속합니다.Goldmile-Infobiz는 100% 한번에 꼭 고난의도인Cisco인증350-401 Dump시험을 패스하여 여러분의 사업에 많은 도움을 드리겠습니다. 이렇게 착한 가격에 이정도 품질의 덤프자료는 찾기 힘들것입니다.
CCNP Enterprise 350-401 회사, 생활에서는 물론 많은 업그레이드가 있을 것입니다.
Goldmile-Infobiz에서는 여러분이Cisco인증 350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR) Dump시험을 한방에 패스하도록 실제시험문제에 대비한Cisco인증 350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR) Dump덤프를 발췌하여 저렴한 가격에 제공해드립니다.시험패스 못할시 덤프비용은 환불처리 해드리기에 고객님께 아무런 페를 끼치지 않을것입니다. 한번에Cisco인증350-401 시험응시시험을 패스하고 싶으시다면 완전 페펙트한 준비가 필요합니다. 완벽한 관연 지식터득은 물론입니다.
Goldmile-Infobiz의 Cisco인증 350-401 Dump시험덤프자료는 여러분의 시간,돈 ,정력을 아껴드립니다. 몇개월을 거쳐 시험준비공부를 해야만 패스가능한 시험을Goldmile-Infobiz의 Cisco인증 350-401 Dump덤프는 며칠간에도 같은 시험패스 결과를 안겨드릴수 있습니다. Cisco인증 350-401 Dump시험을 통과하여 자격증을 취득하려면Goldmile-Infobiz의 Cisco인증 350-401 Dump덤프로 시험준비공부를 하세요.
Goldmile-Infobiz의Cisco 인증Cisco 350-401 Dump로 시험을 한방에 정복하세요.
Goldmile-Infobiz에서 발췌한 Cisco인증 350-401 Dump덤프는 전문적인 IT인사들이 연구정리한 최신버전 Cisco인증 350-401 Dump시험에 대비한 공부자료입니다. Cisco인증 350-401 Dump 덤프에 있는 문제만 이해하고 공부하신다면Cisco인증 350-401 Dump시험을 한방에 패스하여 자격증을 쉽게 취득할수 있을것입니다.
Cisco 350-401 Dump 시험문제가 변경되면 제일 빠른 시일내에 덤프를 업데이트하여 최신버전 덤프자료를Cisco 350-401 Dump덤프를 구매한 분들께 보내드립니다. 시험탈락시 덤프비용 전액환불을 약속해드리기에 안심하시고 구매하셔도 됩니다.
350-401 PDF DEMO:
QUESTION NO: 1
What is the difference between a RIB and a FIB?
A. The FIB is populated based on RIB content
B. The RIB is used to make IP source prefix-based switching decisions
C. The RIB maintains a mirror image of the FIB
D. The FIB is where all IP routing information is stored
Answer: A
Explanation:
CEF uses a Forwarding Information Base (FIB) to make IP destination prefix-based switching decisions.
The FIB is conceptually similar to a routing table or information base. It maintains a mirror image of the forwarding information contained in the IP routing table. When routing or topology changes occur in the network, the IP routing table is updated, and those changes are reflected in the FIB. The
FIB maintains next-hop address information based on the information in the IP routing table. Because there is a one-to-one correlation between FIB entries and routing table entries, the FIB contains all known routes and eliminates the need for route cache maintenance that is associated with earlier switching paths such as fast switching and optimum switching.
Note: In order to view the Routing information base (RIB) table, use the "show ip route" command.
To view the Forwarding Information Base (FIB), use the "show ip cef" command. RIB is in Control plane while FIB is in Data plane.
QUESTION NO: 2
Which feature does Cisco TrustSec use to provide scalable, secure communication throughout a network?
A. security group tag number assigned to each user on a switch
B. security group tag ACL assigned to each router on a network
C. security group tag ACL assigned to each port on a switch
D. security group tag number assigned to each port on a network
Answer: D
Explanation:
Cisco TrustSec uses tags to represent logical group privilege. This tag, called a Security Group Tag
(SGT), is used in access policies. The SGT is understood and is used to enforce traffic by Cisco switches, routers and firewalls . Cisco TrustSec is defined in three phases: classification, propagation and enforcement.
When users and devices connect to a network, the network assigns a specific security group.
This process is called classification. Classification can be based on the results of the authentication or by associating the SGT with an IP, VLAN, or port-profile (-> Answer A and answer C are not correct as they say "assigned ... on a switch" only. Answer D is not correct either as it says "assigned to each router").
QUESTION NO: 3
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
QUESTION NO: 4
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.
QUESTION NO: 5
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.
Genesys GCP-GCX - Goldmile-Infobiz덤프로 자격증취득의 꿈을 이루세요. SAP C-S4CPR-2508 - 개별 인증사는 불합격성적표를 발급하지 않기에 재시험신청내역을 환불증명으로 제출하시면 됩니다. Cisco인증 Fortinet FCSS_SASE_AD-25덤프가 업데이트되면 업데이트된 최신버전을 무료로 서비스로 드립니다. Pss4Test Cisco Linux Foundation CKS덤프를 결제하면 바로 사이트에서Cisco Linux Foundation CKS덤프를 다운받을수 있고 구매한Cisco Linux Foundation CKS시험이 종료되고 다른 코드로 변경되면 변경된 코드로 된 덤프가 출시되면 비용추가없이 새로운 덤프를 제공해드립니다. Goldmile-Infobiz에서 판매하고 있는 Cisco CISI IFC인증시험자료는 시중에서 가장 최신버전으로서 시험적중율이 100%에 가깝습니다.
Updated: May 28, 2022