Cisco 350-401 Dumps 덤프는 많은 덤프들중에서 구매하는 분이 많은 인기덤프입니다. Cisco 350-401 Dumps시험준비중이신 분이시라면Cisco 350-401 Dumps한번 믿고 시험에 도전해보세요. 좋은 성적으로 시험패스하여 자격증 취득할것입니다. 시험탈락시 덤프비용 전액환불을 약속해드리기에 안심하시고 구매하셔도 됩니다. Cisco 350-401 Dumps인증덤프는 최근 출제된 실제시험문제를 바탕으로 만들어진 공부자료입니다. 경쟁율이 점점 높아지는 IT업계에 살아남으려면 국제적으로 인증해주는 IT자격증 몇개쯤은 취득해야 되지 않을가요? Cisco 350-401 Dumps시험으로부터 자격증 취득을 시작해보세요.
CCNP Enterprise 350-401 그리고 우리 또한 그 많은 덤프판매사이트 중에서도 단연 일등이고 생각합니다.
CCNP Enterprise 350-401 Dumps - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR) Goldmile-Infobiz에서 여러분의 꿈을 이루어 드립니다. 학교공부하랴,회사다니랴 자격증공부까지 하려면 너무 많은 정력과 시간이 필요할것입니다. 그렇다고 자격증공부를 포기하면 자신의 위치를 찾기가 힘들것입니다.
Cisco인증 350-401 Dumps 시험은 최근 제일 인기있는 인증시험입니다. IT업계에 종사하시는 분들은 자격증취득으로 자신의 가치를 업그레이드할수 있습니다. Cisco인증 350-401 Dumps 시험은 유용한 IT자격증을 취득할수 있는 시험중의 한과목입니다.
최근 더욱 많은 분들이Cisco인증Cisco 350-401 Dumps시험에 도전해보려고 합니다.
Goldmile-Infobiz에서 제공해드리는 Cisco인증 350-401 Dumps덤프는 가장 출중한Cisco인증 350-401 Dumps시험전 공부자료입니다. 덤프품질은 수많은 IT인사들로부터 검증받았습니다. Cisco인증 350-401 Dumps덤프뿐만아니라 Goldmile-Infobiz에서는 모든 IT인증시험에 대비한 덤프를 제공해드립니다. IT인증자격증을 취득하려는 분들은Goldmile-Infobiz에 관심을 가져보세요. 구매의향이 있으시면 할인도 가능합니다. 고득점으로 패스하시면 지인분들께 추천도 해주실거죠?
Cisco인증 350-401 Dumps시험이 많이 어렵다는것은 모두 알고 있는 것입니다. Goldmile-Infobiz에서 출시한 Cisco인증 350-401 Dumps덤프는 실제시험을 대비하여 연구제작된 멋진 작품으로서 Cisco인증 350-401 Dumps시험적중율이 최고입니다.
350-401 PDF DEMO:
QUESTION NO: 1
What is the difference between a RIB and a FIB?
A. The FIB is populated based on RIB content
B. The RIB is used to make IP source prefix-based switching decisions
C. The RIB maintains a mirror image of the FIB
D. The FIB is where all IP routing information is stored
Answer: A
Explanation:
CEF uses a Forwarding Information Base (FIB) to make IP destination prefix-based switching decisions.
The FIB is conceptually similar to a routing table or information base. It maintains a mirror image of the forwarding information contained in the IP routing table. When routing or topology changes occur in the network, the IP routing table is updated, and those changes are reflected in the FIB. The
FIB maintains next-hop address information based on the information in the IP routing table. Because there is a one-to-one correlation between FIB entries and routing table entries, the FIB contains all known routes and eliminates the need for route cache maintenance that is associated with earlier switching paths such as fast switching and optimum switching.
Note: In order to view the Routing information base (RIB) table, use the "show ip route" command.
To view the Forwarding Information Base (FIB), use the "show ip cef" command. RIB is in Control plane while FIB is in Data plane.
QUESTION NO: 2
Which feature does Cisco TrustSec use to provide scalable, secure communication throughout a network?
A. security group tag number assigned to each user on a switch
B. security group tag ACL assigned to each router on a network
C. security group tag ACL assigned to each port on a switch
D. security group tag number assigned to each port on a network
Answer: D
Explanation:
Cisco TrustSec uses tags to represent logical group privilege. This tag, called a Security Group Tag
(SGT), is used in access policies. The SGT is understood and is used to enforce traffic by Cisco switches, routers and firewalls . Cisco TrustSec is defined in three phases: classification, propagation and enforcement.
When users and devices connect to a network, the network assigns a specific security group.
This process is called classification. Classification can be based on the results of the authentication or by associating the SGT with an IP, VLAN, or port-profile (-> Answer A and answer C are not correct as they say "assigned ... on a switch" only. Answer D is not correct either as it says "assigned to each router").
QUESTION NO: 3
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
QUESTION NO: 4
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.
QUESTION NO: 5
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.
Workday Workday-Pro-Talent-and-Performance - 성공으로 향하는 길에는 많은 방법과 방식이 있습니다. IT업계에서 살아남으려면Goldmile-Infobiz에서Cisco인증 ServiceNow CIS-RCI덤프를 마련하여 자격증에 도전하여 자기의 자리를 찾아보세요. 아직도Cisco 인증HP HPE7-A01 인증시험으로 고민하시고 계십니까? Cisco 인증HP HPE7-A01인증시험 가이드를 사용하실 생각은 없나요? Goldmile-Infobiz는 여러분께 시험패스의 편리를 드릴 수 있습니다. Goldmile-Infobiz의Cisco인증 Juniper JN0-460덤프는 시험문제에 초점을 두어 제작된 공부자료이기에Cisco인증 Juniper JN0-460패스를 가장 빠른 시일내에 한방에 할수 있도록 도와드립니다. 어떻게 하면 가장 편하고 수월하게 Cisco Microsoft PL-200시험을 패스할수 있을가요? 그 답은 바로 Goldmile-Infobiz에서 찾아볼수 있습니다.
Updated: May 28, 2022