Goldmile-Infobiz덤프들은 모두 보장하는 덤프들이며 여러분은 과감히 Goldmile-Infobiz의 덤프를 장바구니에 넣으세요. Goldmile-Infobiz에서 여러분의 꿈을 이루어 드립니다. 우리Goldmile-Infobiz에는 아주 엘리트 한 전문가들로 구성된 팀입니다 그들은 끈임 없는 연구와 자기자신만의 지식으로 많은 IT관연 덤프자료를 만들어 냄으로 여러분의 꿈을 이루어드립니다, 기존의 시험문제와 답과 시험문제분석 등입니다. 많은 시간과 돈이 필요 없습니다. 30분이란 특별학습가이드로 여러분은Cisco 350-401 Vce인증시험을 한번에 통과할 수 있습니다, Goldmile-Infobiz에서Cisco 350-401 Vce시험자료의 문제와 답이 실제시험의 문제와 답과 아주 비슷한 덤프만 제공합니다. Goldmile-Infobiz는 시험에서 불합격성적표를 받으시면 덤프비용을 환불하는 서
Goldmile-Infobiz의Cisco인증 350-401 Vce덤프로 시험패스를 꿈꿔보세요.
Goldmile-Infobiz의Cisco 350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR) Vce덤프는 레알시험의 모든 유형을 포함하고 있습니다.객관식은 물론 드래그앤드랍,시뮬문제등 실제시험문제의 모든 유형을 포함하고 있습니다. Goldmile-Infobiz Cisco 인증350-401 테스트자료인증시험자료는 100% 패스보장을 드립니다. Goldmile-Infobiz는 여러분이Cisco 인증350-401 테스트자료인증시험 패스와 추후사업에 모두 도움이 되겠습니다.
IT업계에 계속 종사할 의향이 있는 분들께 있어서 국제공인 자격증 몇개를 취득하는건 반드시 해야하는 선택이 아닌가 싶습니다. Cisco 350-401 Vce 시험은 국제공인 자격증시험의 인기과목으로서 많은 분들이 저희Cisco 350-401 Vce덤프를 구매하여 시험을 패스하여 자격증 취득에 성공하셨습니다. Cisco 350-401 Vce 시험의 모든 문제를 커버하고 있는 고품질Cisco 350-401 Vce덤프를 믿고 자격증 취득에 고고싱~!
Cisco 350-401 Vce - 덤프는 구체적인 업데이트주기가 존재하지 않습니다.
인재도 많고 경쟁도 많은 이 사회에, IT업계인재들은 인기가 아주 많습니다.하지만 팽팽한 경쟁률도 무시할 수 없습니다.많은 IT인재들도 어려운 인증시험을 패스하여 자기만의 자리를 지키고 있습니다.우리Goldmile-Infobiz에서는 마침 전문적으로 이러한 IT인사들에게 편리하게 시험을 패스할수 있도록 유용한 자료들을 제공하고 있습니다.
Goldmile-Infobiz의Cisco 350-401 Vce덤프는 레알시험의 모든 유형을 포함하고 있습니다.객관식은 물론 드래그앤드랍,시뮬문제등 실제시험문제의 모든 유형을 포함하고 있습니다. Cisco 350-401 Vce덤프의 문제와 답은 모두 엘리트한 인증강사 및 전문가들에 의하여 만들어져Cisco 350-401 Vce 시험응시용만이 아닌 학습자료용으로도 손색이 없는 덤프입니다.저희 착한Cisco 350-401 Vce덤프 데려가세용~!
350-401 PDF DEMO:
QUESTION NO: 1
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
QUESTION NO: 2
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.
QUESTION NO: 3
What is the difference between a RIB and a FIB?
A. The FIB is populated based on RIB content
B. The RIB is used to make IP source prefix-based switching decisions
C. The RIB maintains a mirror image of the FIB
D. The FIB is where all IP routing information is stored
Answer: A
Explanation:
CEF uses a Forwarding Information Base (FIB) to make IP destination prefix-based switching decisions.
The FIB is conceptually similar to a routing table or information base. It maintains a mirror image of the forwarding information contained in the IP routing table. When routing or topology changes occur in the network, the IP routing table is updated, and those changes are reflected in the FIB. The
FIB maintains next-hop address information based on the information in the IP routing table. Because there is a one-to-one correlation between FIB entries and routing table entries, the FIB contains all known routes and eliminates the need for route cache maintenance that is associated with earlier switching paths such as fast switching and optimum switching.
Note: In order to view the Routing information base (RIB) table, use the "show ip route" command.
To view the Forwarding Information Base (FIB), use the "show ip cef" command. RIB is in Control plane while FIB is in Data plane.
QUESTION NO: 4
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.
QUESTION NO: 5
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.
Cisco 300-815 - 우리사이트가 다른 덤프사이트보다 우수한 점은 바로 자료들이 모두 전면적이고 적중률과 정확입니다. Amazon CLF-C02 - PDF버전외에 온라인버전과 테스트엔버전 Demo도 다운받아 보실수 있습니다. Microsoft AZ-305 - 이렇게 인재가 많은 사회에서 IT관련인사들은 아직도 적은 편입니다. 빨리 성공하고 빨리Cisco Huawei H20-614_V1.0인증시험을 패스하고 싶으시다면 우리 Goldmile-Infobiz를 장바구니에 넣으시죠. SAP C-ABAPD-2507 - Goldmile-Infobiz시험문제와 답이야 말로 퍼펙트한 자료이죠.
Updated: May 28, 2022