通過客戶的完全信任，我們為考生提供真實有效的訓練，幫助大家在第一次Cisco 350-401題庫上線考試中順利通過。Goldmile-Infobiz提供高品質的最佳學習資料，讓通過Cisco 350-401題庫上線考試從未如此快速、便宜、和簡單。有了最新詳細的題庫和答案，為您的350-401題庫上線考試做好充分的準備，我們將保證您在考試中取得成功。 我們都知道，在互聯網普及的時代，需要什麼資訊那是非常簡單的事情，不過缺乏的是品質及適用性的問題。許多人在網路上搜尋Cisco的350-401題庫上線考試認證培訓資料，卻不知道該如何去相信，在這裏，我向大家推薦Goldmile-Infobiz Cisco的350-401題庫上線考試認證培訓資料，它在互聯網上點擊率購買率好評率都是最高的，Goldmile-Infobiz Cisco的350-401題庫上線考試認證培訓資料有部分免費的試用考題及答案，你們可以先試用後決定買不買，這樣就知道Goldmile-Infobiz所有的是不是真實的。 但是通過最新的Cisco 350-401題庫上線認證考試并不簡單，並不是僅僅依靠與350-401題庫上線考試相關的書籍就可以辦到的。
CCNP Enterprise 350-401 使用Goldmile-Infobiz你可以很快獲得你想要的證書。
CCNP Enterprise 350-401題庫上線 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR) IT認證考試有很多種。 Goldmile-Infobiz是能確保你100%的通過Cisco 350-401 認證資料的認證考試。Goldmile-Infobiz是個一直為你提供最新最準確的Cisco 350-401 認證資料認證考試相關資料的網站。
想參加350-401題庫上線認證考試嗎？想取得350-401題庫上線認證資格嗎？沒有充分準備考試的時間的你應該怎麼通過考試呢？其實也並不是沒有辦法，即使只有很短的準備考試的時間你也可以輕鬆通過考試。那麼怎麼才能做到呢？方法其實很簡單，那就是使用Goldmile-Infobiz的350-401題庫上線考古題來準備考試。
Cisco 350-401題庫上線 - 这是可以保证你一次就成功的难得的资料。
對於350-401題庫上線認證考試，你已經準備好了嗎？考試近在眼前，你可以信心滿滿地迎接考試嗎？如果你還沒有通過考試的信心，在這裏向你推薦一個最優秀的參考資料。只需要短時間的學習就可以通過考試的最新的350-401題庫上線考古題出現了。这个考古題是由Goldmile-Infobiz提供的。
不過只要你找對了捷徑，通過考試也就變得容易許多了。這就不得不推薦Goldmile-Infobiz的考試考古題了，它可以讓你少走許多彎路，節省時間幫助你考試合格。
350-401 PDF DEMO:
QUESTION NO: 1
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
QUESTION NO: 2
What is the difference between a RIB and a FIB?
A. The FIB is populated based on RIB content
B. The RIB is used to make IP source prefix-based switching decisions
C. The RIB maintains a mirror image of the FIB
D. The FIB is where all IP routing information is stored
Answer: A
Explanation:
CEF uses a Forwarding Information Base (FIB) to make IP destination prefix-based switching decisions.
The FIB is conceptually similar to a routing table or information base. It maintains a mirror image of the forwarding information contained in the IP routing table. When routing or topology changes occur in the network, the IP routing table is updated, and those changes are reflected in the FIB. The
FIB maintains next-hop address information based on the information in the IP routing table. Because there is a one-to-one correlation between FIB entries and routing table entries, the FIB contains all known routes and eliminates the need for route cache maintenance that is associated with earlier switching paths such as fast switching and optimum switching.
Note: In order to view the Routing information base (RIB) table, use the "show ip route" command.
To view the Forwarding Information Base (FIB), use the "show ip cef" command. RIB is in Control plane while FIB is in Data plane.
QUESTION NO: 3
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.
QUESTION NO: 4
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.
QUESTION NO: 5
Which feature does Cisco TrustSec use to provide scalable, secure communication throughout a network?
A. security group tag number assigned to each user on a switch
B. security group tag ACL assigned to each router on a network
C. security group tag ACL assigned to each port on a switch
D. security group tag number assigned to each port on a network
Answer: D
Explanation:
Cisco TrustSec uses tags to represent logical group privilege. This tag, called a Security Group Tag
(SGT), is used in access policies. The SGT is understood and is used to enforce traffic by Cisco switches, routers and firewalls . Cisco TrustSec is defined in three phases: classification, propagation and enforcement.
When users and devices connect to a network, the network assigns a specific security group.
This process is called classification. Classification can be based on the results of the authentication or by associating the SGT with an IP, VLAN, or port-profile (-> Answer A and answer C are not correct as they say "assigned ... on a switch" only. Answer D is not correct either as it says "assigned to each router").
如果您希望在短時間內獲得Cisco HashiCorp Terraform-Associate-003認證，您將永遠找不到比Goldmile-Infobiz更好的產品了。 擁有高品質的考題資料，能幫助考生通過第一次嘗試的SAP C-BW4H-2505考試。 SAP C-S4CS-2508 - 我們的IT專家團隊將不斷的利用行業經驗來研究出準確詳細的考試練習題來協助您通過考試。 VMware 2V0-13.25認證考試培訓工具的內容是由IT行業專家帶來的最新的考試研究材料組成 Scrum SAFe-Practitioner - 無論你選擇哪種培訓方式，Goldmile-Infobiz都為你提供一年的免費更新服務。
Updated: May 28, 2022