If you are interested in Soft test engine of 350-401 Practice Exams practice questions, you should know below information better. Soft test engine should be downloaded in personal computer first time online, and then install. After installment you can use 350-401 Practice Exams practice questions offline. We must realize our own values and make progress. Do not worry. We will offer you the best preparation materials regarding 350-401 Practice Exams practice exam.
CCNP Enterprise 350-401 Perhaps you do not understand.
They are in fact meant to provide you the opportunity to revise your learning and overcome your 350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR) Practice Exams exam fear by repeating the practice tests as many times as you can. As long as you are convenient, you can choose to use a computer to learn, you can also choose to use mobile phone learning. No matter where you are, you can choose your favorite equipment to study our Test 350-401 Simulator Free learning materials.
There is no another great way to pass the Cisco 350-401 Practice Exams exam in the first attempt only by doing a selective study with valid 350-401 Practice Exams braindumps. If you already have a job and you are searching for the best way to improve your current 350-401 Practice Exams test situation, then you should consider the 350-401 Practice Exams exam dumps. By using our updated 350-401 Practice Exams products, you will be able to get reliable and relative 350-401 Practice Exams exam prep questions, so you can pass the exam easily.
Cisco 350-401 Practice Exams - When we choose job, job are also choosing us.
Our experts have worked hard for several years to formulate 350-401 Practice Exams exam braindumps for all examiners. Our 350-401 Practice Exams study materials not only target but also cover all knowledge points. And our practice materials also have a statistical analysis function to help you find out the deficiency in the learning process of 350-401 Practice Exams practice materials, so that you can strengthen the training for weak links. In this way, you can more confident for your success since you have improved your ability.
Next, I will introduce you to the most representative advantages of 350-401 Practice Exams real exam. You can think about whether these advantages are what you need!
350-401 PDF DEMO:
QUESTION NO: 1
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
QUESTION NO: 2
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.
QUESTION NO: 3
What is the difference between a RIB and a FIB?
A. The FIB is populated based on RIB content
B. The RIB is used to make IP source prefix-based switching decisions
C. The RIB maintains a mirror image of the FIB
D. The FIB is where all IP routing information is stored
Answer: A
Explanation:
CEF uses a Forwarding Information Base (FIB) to make IP destination prefix-based switching decisions.
The FIB is conceptually similar to a routing table or information base. It maintains a mirror image of the forwarding information contained in the IP routing table. When routing or topology changes occur in the network, the IP routing table is updated, and those changes are reflected in the FIB. The
FIB maintains next-hop address information based on the information in the IP routing table. Because there is a one-to-one correlation between FIB entries and routing table entries, the FIB contains all known routes and eliminates the need for route cache maintenance that is associated with earlier switching paths such as fast switching and optimum switching.
Note: In order to view the Routing information base (RIB) table, use the "show ip route" command.
To view the Forwarding Information Base (FIB), use the "show ip cef" command. RIB is in Control plane while FIB is in Data plane.
QUESTION NO: 4
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.
QUESTION NO: 5
Which feature does Cisco TrustSec use to provide scalable, secure communication throughout a network?
A. security group tag number assigned to each user on a switch
B. security group tag ACL assigned to each router on a network
C. security group tag ACL assigned to each port on a switch
D. security group tag number assigned to each port on a network
Answer: D
Explanation:
Cisco TrustSec uses tags to represent logical group privilege. This tag, called a Security Group Tag
(SGT), is used in access policies. The SGT is understood and is used to enforce traffic by Cisco switches, routers and firewalls . Cisco TrustSec is defined in three phases: classification, propagation and enforcement.
When users and devices connect to a network, the network assigns a specific security group.
This process is called classification. Classification can be based on the results of the authentication or by associating the SGT with an IP, VLAN, or port-profile (-> Answer A and answer C are not correct as they say "assigned ... on a switch" only. Answer D is not correct either as it says "assigned to each router").
In fact, you just need spend 20~30h effective learning time if you match Microsoft MS-700-KR guide dumps and listen to our sincere suggestions. We will inform you that the Linux Foundation CNPA study materials should be updated and send you the latest version in a year after your payment. Our experts are working hard on our Amazon AIF-C01-KR exam questions to perfect every detail in our research center. And our Palo Alto Networks NetSec-Analyst study materials always contain the latest exam Q&A. Our Real Estate Licensing Virginia-Real-Estate-Salesperson exam questions own a lot of advantages that you can't imagine.
Updated: May 28, 2022