短い時間に最も小さな努力で一番効果的にCiscoの200-301科目対策試験の準備をしたいのなら、Goldmile-InfobizのCiscoの200-301科目対策試験トレーニング資料を利用することができます。Goldmile-Infobizのトレーニング資料は実践の検証に合格すたもので、多くの受験生に証明された１００パーセントの成功率を持っている資料です。Goldmile-Infobizを利用したら、あなたは自分の目標を達成することができ、最良の結果を得ます。 弊社のCiscoの200-301科目対策真題によって、資格認定証明書を受け取れて、仕事の昇進を実現できます。Ciscoの200-301科目対策資格認定証明書を持つ人は会社のリーダーからご格別のお引き立てを賜ったり、仕事の昇進をたやすくなったりしています。 このトレーニング方法は受験生の皆さんに短い時間で予期の成果を取らせます。
CCNA 200-301 Goldmile-Infobizはあなたに援助を提供します。
多くの人にとって、短い時間で200-301 - Cisco Certified Network Associate Exam科目対策試験に合格できることは難しいです。 受験生の皆さんをもっと効率的な参考資料を勉強させるように、Goldmile-InfobizのIT技術者はずっとさまざまなIT認定試験の研究に取り組んでいますから、もっと多くの素晴らしい資料を開発し出します。一度Goldmile-Infobizの200-301 模擬試験問題集を使用すると、きっと二度目を使用したいです。
Goldmile-Infobizは認定で優秀なIT資料のウエブサイトで、ここでCisco 200-301科目対策認定試験の先輩の経験と暦年の試験の材料を見つけることができるとともに部分の最新の試験の題目と詳しい回答を無料にダウンロードこともできますよ。弊社のIT技術専門家たち は質が高い問題集と答えを提供し、お客様が合格できるように努めています。
Cisco 200-301科目対策 - Goldmile-Infobizというサイトです。
試験を怖く感じるのはかなり正常です。特にCiscoの200-301科目対策のような難しい試験です。励ましだけであなたの試験への自信を高めるのは不可能だと知っていますから、我々は効果的なソフトを提供してあなたにCiscoの200-301科目対策試験に合格させます。あなたはデモで我々のソフトの効果を体験することができます。あなたはデモから我々のCiscoの200-301科目対策ソフトを開発する意図とプロを感じることができます。
Goldmile-InfobizのCiscoの200-301科目対策試験トレーニング資料は必要とするすべての人に成功をもたらすことができます。Ciscoの200-301科目対策試験は挑戦がある認定試験です。
200-301 PDF DEMO:
QUESTION NO: 1
Which statement about Link Aggregation when implemented on a Cisco Wireless LAN
Controller is true?
A. One functional physical port is needed to pass client traffic
B. The EtherChannel must be configured in "mode active"
C. When enabled the WLC bandwidth drops to 500 Mbps
D. To pass client traffic two or more ports must be configured.
Answer: A
Explanation:
Link aggregation (LAG) is a partial implementation of the 802.3ad port aggregation standard. It bundles all of the controller's distribution system ports into a single 802.3ad port channel.
Restriction for Link aggregation:
- LAG requires the EtherChannel to be configured for `mode on' on both the controller and the
Catalyst switch -> Answer B is not correct.
- If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller -> Answer A is not correct while answer D is correct.
Reference: https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/ b_cg75_chapter_0100010.html
QUESTION NO: 2
Drag and Drop Question
Drag and drop the WLAN components from the left onto the correct descriptions on the right.
Answer:
Explanation:
The service port can be used management purposes, primarily for out-of-band management.
However, AP management traffic is not possible across the service port. In most cases, the service port is used as a "last resort" means of accessing the controller GUI for management purposes. For example, in the case where the system distribution ports on the controller are down or their communication to the wired network is otherwise degraded.
A dynamic interface with the Dynamic AP Management option enabled is used as the tunnel source for packets from the controller to the access point and as the destination for CAPWAP packets from the access point to the controller.
The virtual interface is used to support mobility management, Dynamic Host Configuration Protocol
(DHCP) relay, and embedded Layer 3 security such as guest web authentication. It also maintains the
DNS gateway host name used by Layer 3 security and mobility managers to verify the source of certificates when Layer 3 web authorization is enabled.
Reference: https://www.cisco.com/c/en/us/td/docs/wireless/controller/8-5/config- guide/b_cg85/ports_and_interfaces.html
QUESTION NO: 3
Refer to the exhibit. C-router is to be used as a "router-on-a-stick" to route between the
VLANs.
All the interfaces have been properly configured and IP routing is operational. The hosts in the VLANs have been configured with the appropriate default gateway.
What is true about this configuration?
A. These commands need to be added to the configuration:
C-router(config)# router rip
C-router(config-router)# network 172.19.0.0
B. These commands need to be added to the configuration:
C-router(config)# router ospf 1
C-router(config-router)# network 172.19.0.0 0.0.3.255 area 0
C. These commands need to be added to the configuration:
C-router(config)# router eigrp 123
C-router(config-router)# network 172.19.0.0
D. No further routing configuration is required.
Answer: D
Explanation:
Since all the same router (C-router) is the default gateway for all three VLANs, all traffic destined to a different VLAN will be sent to the C-router. The C-router will have knowledge of all three networks since they will appear as directly connected in the routing table. Since the C-router already knows how to get to all three networks, no routing protocols need to be configured.
QUESTION NO: 4
Which two tasks must be performed to configure NTP to a trusted server in client mode on a single network device? (Choose two)
A. Verify the time zone.
B. Disable NTP broadcasts
C. Set the NTP server private key
D. Specify the IP address of the NTP server
E. Enable NTP authentication.
Answer: D,E
Explanation:
To configure authentication, perform this task in privileged mode:
Step 1: Configure an authentication key pair for NTP and specify whether the key will be trusted or untrusted.
Step 2: Set the IP address of the NTP server and the public key.
Step 3: Enable NTP client mode.
Step 4: Enable NTP authentication.
Step 5: Verify the NTP configuration.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst4000/8-
2glx/configuration/guide/ ntp.html
QUESTION NO: 5
A router running EIGRP has learned the same route from two different paths. Which parameter does the router use to select the best path?
A. administrative distance
B. as-path
C. metric
D. cost
Answer: C
Explanation:
If a router learns two different paths for the same network from the same routing protocol, it has to decide which route is better and will be placed in the routing table. Metric is the measure used to decide which route is better (lower number is better). Each routing protocol uses its own metric.
For example, RIP uses hop counts as a metric, while OSPF uses cost.
https://study-ccna.com/administrative-distance-metric/
SAP C_TS422_2504 - この試験に合格したいなら、よく準備する必要があります。 Salesforce Analytics-Admn-201 - もちろんです。 弊社のCiscoのVMware 2V0-17.25真題によって、資格認定証明書を受け取れて、仕事の昇進を実現できます。 Juniper JN0-650 - もっと大切なのは、あなたもより多くの仕事のスキルをマスターしたことを証明することができます。 最近、Cisco Amazon Data-Engineer-Associate-KR試験に合格するのは重要な課題になっています。
Updated: May 28, 2022