短い時間に最も小さな努力で一番効果的にCiscoの350-401ウェブトレーニング試験の準備をしたいのなら、Goldmile-InfobizのCiscoの350-401ウェブトレーニング試験トレーニング資料を利用することができます。Goldmile-Infobizのトレーニング資料は実践の検証に合格すたもので、多くの受験生に証明された１００パーセントの成功率を持っている資料です。Goldmile-Infobizを利用したら、あなたは自分の目標を達成することができ、最良の結果を得ます。 我々の知名度はとても高いです。これは受験生の皆さんが資料を利用した後の結果です。 Goldmile-Infobizのトレーニング資料を手に入れたら、あなたは成功への鍵を握るようになります。
CCNP Enterprise 350-401 皆さんからいろいろな好評をもらいました。
しかし、もし350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)ウェブトレーニング認証資格を取りたいなら、Goldmile-Infobizの350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)ウェブトレーニング問題集はあなたを願望を達成させることができます。 うちのCiscoの350-401 対応問題集問題集を購入したら、私たちは一年間で無料更新サービスを提供することができます。もし学習教材は問題があれば、或いは試験に不合格になる場合は、全額返金することを保証いたします。
こんな保障がありますから、心配する必要は全然ないですよ。Goldmile-Infobizの350-401ウェブトレーニング問題集は多くの受験生に検証されたものですから、高い成功率を保証できます。もしこの問題集を利用してからやはり試験に不合格になってしまえば、Goldmile-Infobizは全額で返金することができます。
Cisco 350-401ウェブトレーニング - このサービスは無料なのです。
最も早い時間で気楽にCiscoの350-401ウェブトレーニング認定試験に合格したいなら、Goldmile-Infobizを選んだ方が良いです。あなたはGoldmile-Infobizの学習教材を購入した後、私たちは一年間で無料更新サービスを提供することができます。あなたは最新のCiscoの350-401ウェブトレーニング試験トレーニング資料を手に入れることが保証します。もしうちの学習教材を購入した後、試験に不合格になる場合は、私たちが全額返金することを保証いたします。
これなので、今から我々社Goldmile-Infobizの350-401ウェブトレーニング試験に合格するのに努力していきます。弊社のCiscoの350-401ウェブトレーニング真題によって、資格認定証明書を受け取れて、仕事の昇進を実現できます。
350-401 PDF DEMO:
QUESTION NO: 1
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.
QUESTION NO: 2
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.
QUESTION NO: 3
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.
QUESTION NO: 4
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D
QUESTION NO: 5
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
CiscoのSAP C-TS4FI-2023-JPN試験に合格することができます。 どのようにCisco APICS CSCP-KR試験に準備すると悩んでいますか。 しかし、我々Goldmile-Infobizチームは力を尽くしてあなたのCiscoのCompTIA PK0-005J試験を準備する圧力を減少して規範的な模擬問題と理解しやすい解答分析はあなたにCiscoのCompTIA PK0-005J試験に合格するコツを把握させます。 しかし、幸いにして、ServiceNow CSAの練習問題の専門会社として、弊社の最も正確な質問と回答を含むServiceNow CSA試験の資料は、ServiceNow CSA試験対する問題を効果的に解決できます。 CiscoのFortinet FCSS_EFW_AD-7.6試験のほかの認証試験も大切なのです。
Updated: May 28, 2022