多くの人々は高い難度のIT認証試験に合格するのは専門の知識が必要だと思います。それは確かにそうですが、その知識を身につけることは難しくないとといわれています。IT業界ではさらに強くなるために強い専門知識が必要です。 もっと重要のことは、リアルな模擬練習はあなたがCiscoの350-401的中率試験に受かることに大きな助けになれます。Goldmile-Infobiz のCiscoの350-401的中率試験資料はあなたに時間を節約させることができるだけではなく、あなたに首尾よく試験に合格させることもできますから、Goldmile-Infobizを選ばない理由はないです。 Goldmile-Infobizが提供したCiscoの350-401的中率「Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)」試験問題と解答が真実の試験の練習問題と解答は最高の相似性があり、一年の無料オンラインの更新のサービスがあり、100%のパス率を保証して、もし試験に合格しないと、弊社は全額で返金いたします。
CCNP Enterprise 350-401 試験に良いの準備と自信がとても必要だと思います。
CCNP Enterprise 350-401的中率 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR) あなたは勇敢な人ですか。 Goldmile-Infobizの商品は100%の合格率を保証いたします。Goldmile-InfobizはITに対応性研究続けて、高品質で低価格な問題集が開発いたしました。
もちろん、IT業界で働いているあなたはIT認定試験を受けて資格を取得することは一番良い選択です。それはより良く自分自身を向上させることができますから。もっと大切なのは、あなたもより多くの仕事のスキルをマスターしたことを証明することができます。
彼らにCiscoのCisco 350-401的中率試験に合格させました。
Goldmile-Infobiz はプロなウェブサイトで、受験生の皆さんに質の高いサービスを提供します。プリセールス.サービスとアフターサービスに含まれているのです。Goldmile-InfobizのCiscoの350-401的中率試験トレーニング資料を必要としたら、まず我々の無料な試用版の問題と解答を使ってみることができます。そうしたら、この資料があなたに適用するかどうかを確かめてから購入することができます。Goldmile-InfobizのCiscoの350-401的中率試験トレーニング資料を利用してから失敗になりましたら、当社は全額で返金します。それに、一年間の無料更新サービスを提供することができます。
試験に合格してからあなたがよりよい仕事と給料がもらえるかもしれません。Ciscoの350-401的中率試験は国際的に認可られます。
350-401 PDF DEMO:
QUESTION NO: 1
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.
QUESTION NO: 2
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.
QUESTION NO: 3
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.
QUESTION NO: 4
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D
QUESTION NO: 5
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
安心にMicrosoft SC-401試験を申し込みましょう。 我々社は最高のCisco SAP C-TS462-2023試験問題集を開発し提供して、一番なさービスを与えて努力しています。 テストエンジンとして、ソフトウェア版のACAMS CAMS問題集はあなたの試験の準備についての進捗状況をテストするために利用することができます。 あなたの取得したCisco Microsoft PL-200J資格認定は、仕事中に核心技術知識を同僚に認可されるし、あなたの技術信頼度を増強できます。 Juniper JN0-105 - そのほか、もし試験に関連する知識をより多く知りたいなら、それもあなたの望みを満たすことができます。
Updated: May 28, 2022