でも大丈夫です。Goldmile-InfobizのCiscoの350-401受験準備試験トレーニング資料を購入しましたから。すると、Ciscoの350-401受験準備試験に合格する実力を持つようになりました。 その理由でこの試験はますます重視されるになります。Goldmile-Infobiz Ciscoの350-401受験準備試験トレーニング資料はあなたが上記の念願を実現することを助けられるのです。 この問題集には実際の試験に出る可能性のあるすべての問題が含まれています。
350-401受験準備練習資料が最も全面的な参考書です。
だから、あなたの使用しているCiscoの350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)受験準備試験のソフトウェアは、最新かつ最も全面的な問題集を確認することができます。 Cisco 350-401 受験内容認証試験に合格することが簡単ではなくて、Cisco 350-401 受験内容証明書は君にとってはIT業界に入るの一つの手づるになるかもしれません。しかし必ずしも大量の時間とエネルギーで復習しなくて、弊社が丹精にできあがった問題集を使って、試験なんて問題ではありません。
多くの受験生は我々のソフトでCiscoの350-401受験準備試験に合格したので、我々は自信を持って我々のソフトを利用してあなたはCiscoの350-401受験準備試験に合格する保障があります。IT業界の発展とともに、IT業界で働いている人への要求がますます高くなります。競争の中で排除されないように、あなたはCiscoの350-401受験準備試験に合格しなければなりません。
Cisco 350-401受験準備 - どんな困難にあっても、諦めないです。
Goldmile-InfobizのCiscoの350-401受験準備試験トレーニング資料は全てのオンラインのトレーニング資料で一番よいものです。我々の知名度はとても高いです。これは受験生の皆さんが資料を利用した後の結果です。Goldmile-InfobizのCiscoの350-401受験準備試験トレーニング資料を選んだら、１００パーセントの成功率を保証します。もし失敗だったら、我々は全額で返金します。受験生の皆さんの重要な利益が保障できるようにGoldmile-Infobizは絶対信頼できるものです。
そのデモは350-401受験準備試験資料の一部を含めています。私たちは本当にお客様の貴重な意見を350-401受験準備試験資料の作りの考慮に入れます。
350-401 PDF DEMO:
QUESTION NO: 1
Which description of an SD-Access wireless network infrastructure deployment is true?
A. The wireless client is part of the fabric overlay.
B. The access point is part of the fabric underlay.
C. The WLC is part of the fabric underlay.
D. The access point is part the fabric overlay.
Answer: B
QUESTION NO: 2
Which statement about a fabric access point is true?
A. It is in local mode an must connected directly to the fabric edge switch.
B. It is in FlexConnect mode and must be connected directly to the fabric edge switch.
C. It is in FlexConnect mode and must be connected directly to the fabric border node.
D. It is in local mode an must be connected directly to the fabric border node.
Answer: A
Explanation:
Fabric mode APs continue to support the same wireless media services that traditional APs support; apply AVC, quality of service (QoS), and other wireless policies; and establish the CAPWAP control plane to the fabric WLC. Fabric APs join as local-mode APs and must be directly connected to the fabric edge node switch to enable fabric registration events, including RLOC assignment via the fabric
WLC. The fabric edge nodes use CDP to recognize APs as special wired hosts, applying special port configurations and assigning the APs to a unique overlay network within a common EID space across a fabric. The assignment allows management simplification by using a single subnet to cover the AP infrastructure at a fabric site.
Reference: https://www.cisco.com/c/en/us/td/docs/solutions/CVD/Campus/sda-sdg-2019oct.html
QUESTION NO: 3
Which feature does Cisco TrustSec use to provide scalable, secure communication throughout a network?
A. security group tag number assigned to each user on a switch
B. security group tag ACL assigned to each router on a network
C. security group tag ACL assigned to each port on a switch
D. security group tag number assigned to each port on a network
Answer: D
Explanation:
Cisco TrustSec uses tags to represent logical group privilege. This tag, called a Security Group Tag
(SGT), is used in access policies. The SGT is understood and is used to enforce traffic by Cisco switches, routers and firewalls . Cisco TrustSec is defined in three phases: classification, propagation and enforcement.
When users and devices connect to a network, the network assigns a specific security group.
This process is called classification. Classification can be based on the results of the authentication or by associating the SGT with an IP, VLAN, or port-profile (-> Answer A and answer C are not correct as they say "assigned ... on a switch" only. Answer D is not correct either as it says "assigned to each router").
QUESTION NO: 4
What is the difference between a RIB and a FIB?
A. The FIB is populated based on RIB content
B. The RIB is used to make IP source prefix-based switching decisions
C. The RIB maintains a mirror image of the FIB
D. The FIB is where all IP routing information is stored
Answer: A
Explanation:
CEF uses a Forwarding Information Base (FIB) to make IP destination prefix-based switching decisions.
The FIB is conceptually similar to a routing table or information base. It maintains a mirror image of the forwarding information contained in the IP routing table. When routing or topology changes occur in the network, the IP routing table is updated, and those changes are reflected in the FIB. The
FIB maintains next-hop address information based on the information in the IP routing table. Because there is a one-to-one correlation between FIB entries and routing table entries, the FIB contains all known routes and eliminates the need for route cache maintenance that is associated with earlier switching paths such as fast switching and optimum switching.
Note: In order to view the Routing information base (RIB) table, use the "show ip route" command.
To view the Forwarding Information Base (FIB), use the "show ip cef" command. RIB is in Control plane while FIB is in Data plane.
QUESTION NO: 5
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
Adobe AD0-E137 - 人生には様々な選択があります。 Goldmile-InfobizはCiscoのSalesforce Advanced-Administratorの認定試験の受験生にとっても適合するサイトで、受験生に試験に関する情報を提供するだけでなく、試験の問題と解答をはっきり解説いたします。 Linux Foundation CNPA - また、Goldmile-Infobizは数え切れない受験生を助け、皆さんの信頼と称賛を得ました。 Workday Workday-Pro-Compensation - Goldmile-Infobizが提供した問題集を使用してIT業界の頂点の第一歩としてとても重要な地位になります。 Microsoft AZ-104J認定試験はたいへん難しい試験ですね。
Updated: May 28, 2022