我々の商品はあなたの認可を得られると希望します。ご購入の後、我々はタイムリーにあなたにCiscoの350-401合格対策ソフトの更新情報を提供して、あなたの備考過程をリラクスにします。Goldmile-Infobizの発展は弊社の商品を利用してIT認証試験に合格した人々から得た動力です。 Goldmile-Infobizが提供したCiscoの350-401合格対策試験問題と解答が真実の試験の練習問題と解答は最高の相似性があり、一年の無料オンラインの更新のサービスがあり、100%のパス率を保証して、もし試験に合格しないと、弊社は全額で返金いたします。Goldmile-Infobizはたくさんの方がIT者になる夢を実現させるサイトでございます。 これがあったら、よい高い職位の通行証を持っているようです。
CCNP Enterprise 350-401 Goldmile-Infobizを選択したら、成功をとりましょう。
我々社は最高のCisco 350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)合格対策試験問題集を開発し提供して、一番なさービスを与えて努力しています。 Goldmile-Infobizの勉強資料を手に入れたら、指示に従えば 350-401 専門知識内容認定試験に受かることはたやすくなります。受験生の皆様にもっと多くの助けを差し上げるために、Goldmile-Infobiz のCiscoの350-401 専門知識内容トレーニング資料はインターネットであなたの緊張を解消することができます。
Cisco 350-401合格対策資格認定はIT技術領域に従事する人に必要があります。我々社のCisco 350-401合格対策試験練習問題はあなたに試験うま合格できるのを支援します。あなたの取得したCisco 350-401合格対策資格認定は、仕事中に核心技術知識を同僚に認可されるし、あなたの技術信頼度を増強できます。
Cisco 350-401合格対策 - Goldmile-Infobizが提供した商品をご利用してください。
350-401合格対策認定試験はずっと人気があるのです。最近IT試験を受けて認証資格を取ることは一層重要になりました。たとえばCisco、IBM、Cisco、VMware、SAPなどのいろいろな試験は今では全部非常に重要な試験です。より多くの人々は複数の資格を取得するために多くの350-401合格対策試験を受験したいと思っています。もちろん、このようにすればあなたがすごい技能を身につけていることが証明されることができます。しかし、仕事しながら試験の準備をすることはもともと大変で、複数の試験を受験すれば非常に多くの時間が必要です。いまこのようなことで悩んいるのでしょうか。それは問題ではないですよ。Goldmile-Infobizあなたを時間を節約させことができますから。Goldmile-InfobizのさまざまなIT試験の問題集はあなたを受験したい任意の試験に合格させることができます。350-401合格対策認定試験などの様々な認定試験で、受験したいなら躊躇わずに申し込んでください。心配する必要はないです。
Ciscoの350-401合格対策のオンラインサービスのスタディガイドを買いたかったら、Goldmile-Infobizを買うのを薦めています。Goldmile-Infobizは同じ作用がある多くのサイトでリーダーとしているサイトで、最も良い品質と最新のトレーニング資料を提供しています。
350-401 PDF DEMO:
QUESTION NO: 1
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.
QUESTION NO: 2
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.
QUESTION NO: 3
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.
QUESTION NO: 4
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
QUESTION NO: 5
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D
CompTIA CAS-005 - これはあなたが一回で楽に成功できるを保証するめぼしい参考書です。 CiscoのMicrosoft DP-900J認定試験に受かったら、あなたの仕事はより良い保証を得て、将来のキャリアで、少なくともIT領域であなたの技能と知識は国際的に認知され、受け入れられるです。 CiscoのMicrosoft MB-700の認証試験の高品質の資料を提供しているユニークなサイトはGoldmile-Infobizです。 CiscoのServiceNow CSA-JPN試験に受かることを通じて現在の激しい競争があるIT業種で昇進したくて、IT領域で専門的な技能を強化したいのなら、豊富なプロ知識と長年の努力が必要です。 多くの受験生がCiscoのCompTIA CAS-005認定試験に良い成績を取らせるために、Goldmile-Infobizはより良い結果までずっと努力しています。
Updated: May 28, 2022