購入前にネットで部分な問題集を無料にダウンロードしてあとで弊社の商品を判断してください。Goldmile-Infobizは君の試験に100%の合格率を保証いたします。迷ってないください。 Goldmile-Infobizが提供した商品をご利用してください。もし失敗したら、全額で返金を保証いたします。 Goldmile-Infobizは合格率が100パーセントということを保証します。
CCNP Enterprise 350-401 Goldmile-Infobizがありますから。
すると、Ciscoの350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)技術問題試験に合格する実力を持つようになりました。 そのとき、あなたはまだ悲しいですか。いいえ、あなたはきっと非常に誇りに思うでしょう。
いまCiscoの350-401技術問題認定試験に関連する優れた資料を探すのに苦悩しているのですか。もうこれ以上悩む必要がないですよ。ここにはあなたが最も欲しいものがありますから。
Cisco 350-401技術問題 - あなたの気に入る版を選ぶことができます。
他の人はあちこちでCisco 350-401技術問題試験資料を探しているとき、あなたはすでに勉強中で、準備階段でライバルに先立ちます。また、我々Goldmile-Infobizは量豊かのCisco 350-401技術問題試験資料を提供しますし、ソフト版であなたにCisco 350-401技術問題試験の最も現実的な環境をシミュレートさせます。勉強中で、何の質問があると、メールで我々はあなたのためにすぐ解決します。心配はありませんし、一心不乱に試験復習に取り組んでいます。
試験が更新されているうちに、我々はCiscoの350-401技術問題試験の資料を更新し続けています。できるだけ100%の通過率を保証使用にしています。
350-401 PDF DEMO:
QUESTION NO: 1
Which standard access control entry permits from odd-numbered hosts in the 10.0.0.0/24 subnet?
A. Permit 10.0.0.0.255.255.255.254
B. Permit 10.0.0.1.0.0.0.254
C. Permit 10.0.0.1.0.0.0.0
D. Permit 10.0.0.0.0.0.0.1
Answer: B
Explanation:
Remember, for the wildcard mask, 1's are I DON'T CARE, and 0's are I CARE. So now let's analyze a simple ACL:
access-list 1 permit 172.23.16.0 0.0.15.255
Two first octets are all 0's meaning that we care about the network 172.23.x.x. The third octet of the wildcard mask, 15 (0000 1111 in binary), means that we care about first 4 bits but don't care about last 4 bits so we allow the third octet in the form of 0001xxxx (minimum:00010000 = 16; maximum:
0001111 = 31).
The fourth octet is 255 (all 1 bits) that means I don't care.
Therefore network 172.23.16.0 0.0.15.255 ranges from 172.23.16.0 to 172.23.31.255.
Now let's consider the wildcard mask of 0.0.0.254 (four octet: 254 = 1111 1110) which means we only care the last bit. Therefore if the last bit of the IP address is a "1" (0000 0001) then only odd numbers are allowed. If the last bit of the IP address is a "0" (0000 0000) then only even numbers are allowed.
Note: In binary, odd numbers are always end with a "1" while even numbers are always end with a
"0".
Therefore in this question, only the statement "permit 10.0.0.1 0.0.0.254" will allow all odd- numbered hosts in the 10.0.0.0/24 subnet.
QUESTION NO: 2
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D
QUESTION NO: 3
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.
QUESTION NO: 4
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.
QUESTION NO: 5
What is the correct EBGP path attribute list, ordered from most preferred to the least preferred, that the BGP best-path algorithm uses?
A. weight, local preference, AS path, MED
B. weight, AS path, local preference, MED
C. local preference, weight MED, AS path
D. local preference, weight, AS path, MED
Answer: A
Explanation:
Path Selection Attributes: Weight > Local Preference > Originate > AS Path > Origin > MED > External
> IGP Cost > eBGP Peering > Router ID
だから、弊社のMicrosoft PL-300練習資料を早く購入しましょう! あなたにCiscoのMicrosoft MB-500J試験に自信を持たせます。 今競争の激しいIT業界で地位を固めたいですが、Cisco ISACA CISA-JPN認証試験に合格しなければなりません。 成功を受けたいあなたはすぐに行動しませんでしょうか?Fortinet FCP_GCS_AD-7.6試験に興味があると、我々社Goldmile-Infobizをご覧になってください。 Amazon AIF-C01-JPN - Goldmile-Infobizは受験者に向かって試験について問題を解決する受験資源を提供するサービスのサイトで、さまざまな受験生によって別のトレーニングコースを提供いたします。
Updated: May 28, 2022