これは完全に実際の試験雰囲気とフォーマットをシミュレートするソフトウェアですから。このソフトで、あなたは事前に実際の試験を感じることができます。そうすれば、実際の350-401日本語受験教科書試験を受けるときに緊張をすることはないです。 350-401日本語受験教科書試験はCiscoのひとつの認証試験でIT業界でとても歓迎があって、ますます多くの人が350-401日本語受験教科書「Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)」認証試験に申し込んですがその認証試験が簡単に合格できません。準備することが時間と労力がかかります。 Ciscoの350-401日本語受験教科書の認証試験の高品質の資料を提供しているユニークなサイトはGoldmile-Infobizです。
350-401日本語受験教科書認定試験の真実の問題に会うかもしれません。
ご客様は350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)日本語受験教科書問題集を購入してから、勉強中で何の質問があると、行き届いたサービスを得られています。 あなたが試験に合格することにヘルプをあげられますから。それにGoldmile-Infobizは１００パーセント合格率を保証します。
多くの人々はCiscoの350-401日本語受験教科書試験に合格できるのは難しいことであると思っています。この悩みに対して、我々社Goldmile-InfobizはCiscoの350-401日本語受験教科書試験に準備するあなたに専門的なヘルプを与えられます。弊社のCiscoの350-401日本語受験教科書練習問題を利用したら、あなたは気楽に勉強するだけではなく、順調に試験に合格します。
Cisco 350-401日本語受験教科書 - あなた自身のために、証明書をもらいます。
他の人はあちこちでCisco 350-401日本語受験教科書試験資料を探しているとき、あなたはすでに勉強中で、準備階段でライバルに先立ちます。また、我々Goldmile-Infobizは量豊かのCisco 350-401日本語受験教科書試験資料を提供しますし、ソフト版であなたにCisco 350-401日本語受験教科書試験の最も現実的な環境をシミュレートさせます。勉強中で、何の質問があると、メールで我々はあなたのためにすぐ解決します。心配はありませんし、一心不乱に試験復習に取り組んでいます。
それを手に入れてから私は試験に合格する自信を持つようになります。Goldmile-InfobizのCiscoの350-401日本語受験教科書試験トレーニング資料のカバー率がとても高いですから、自分で勉強するよりずっと効率が高いです。
350-401 PDF DEMO:
QUESTION NO: 1
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.
QUESTION NO: 2
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.
QUESTION NO: 3
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.
QUESTION NO: 4
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D
QUESTION NO: 5
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
私たちのACAMS CAMS7-JP練習資料を利用したら、ACAMS CAMS7-JP試験に合格した人がかなり多いです。 ISTQB ISTQB-CTFL - どんなに難しい試験でも、Goldmile-Infobizがいるのなら、大丈夫になります。 今競争の激しいIT業界で地位を固めたいですが、Cisco CIPS L4M4認証試験に合格しなければなりません。 HP HPE7-J02 - それに、Goldmile-Infobizの教材を購入すれば、Goldmile-Infobizは一年間の無料アップデート・サービスを提供してあげます。 Cisco 300-415 - Goldmile-Infobizは受験者に向かって試験について問題を解決する受験資源を提供するサービスのサイトで、さまざまな受験生によって別のトレーニングコースを提供いたします。
Updated: May 28, 2022