あなたはまだ何を心配しているのですか。Goldmile-InfobizのCiscoの350-401日本語版試験解答トレーニング資料はあなたのニーズを満たすことができますから、躊躇わずにGoldmile-Infobizを選んでください。Goldmile-Infobizはあなたと苦楽を共にして、一緒に挑戦に直面します。 Goldmile-Infobizは君に対して特別の訓練を提供しています。Ciscoの350-401日本語版試験解答は専門知識と情報技術の検査として認証試験で、Goldmile-Infobizはあなたに一日早くCiscoの認証試験に合格させて、多くの人が大量の時間とエネルギーを費やしても無駄になりました。 Goldmile-InfobizのCiscoの350-401日本語版試験解答試験トレーニング資料はよい選択で、あなたが首尾よく試験に合格することを助けられます。
CCNP Enterprise 350-401 あなたもこの試験の認定資格を取得したいのですか。
CCNP Enterprise 350-401日本語版試験解答 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR) その理由でこの試験はますます重視されるになります。 どちらを受験したいですか。ここで言いたいのは350-401 難易度受験料試験です。
でも、試験に合格するために大量な時間とエネルギーを費やすことはなく、Goldmile-InfobizのCiscoの350-401日本語版試験解答試験トレーニング資料を選んだらいいです。Goldmile-Infobizのトレーニング資料はIT認証試験に受かるために特別に研究されたものですから、この資料を手に入れたら難しいCiscoの350-401日本語版試験解答認定試験に気楽に合格することができるようになります。Ciscoの350-401日本語版試験解答試験に受かることを通じて現在の激しい競争があるIT業種で昇進したくて、IT領域で専門的な技能を強化したいのなら、豊富なプロ知識と長年の努力が必要です。
Cisco 350-401日本語版試験解答 - ここにはあなたが最も欲しいものがありますから。
ITエリートになるという夢は現実の世界で叶えやすくありません。しかし、Ciscoの350-401日本語版試験解答認定試験に合格するという夢は、Goldmile-Infobizに対して、絶対に掴められます。Goldmile-Infobizは親切なサービスで、Ciscoの350-401日本語版試験解答問題集が質の良くて、Ciscoの350-401日本語版試験解答認定試験に合格する率も１００パッセントになっています。Goldmile-Infobizを選ぶなら、私たちは君の認定試験に合格するのを保証します。
そうすれば、実際の350-401日本語版試験解答試験を受けるときに緊張をすることはないです。ですから、心のリラックスした状態で試験に出る問題を対応することができ、あなたの正常なレベルをプレイすることもできます。
350-401 PDF DEMO:
QUESTION NO: 1
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.
QUESTION NO: 2
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.
QUESTION NO: 3
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.
QUESTION NO: 4
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
QUESTION NO: 5
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D
Cisco 200-901J - もしうちの学習教材を購入した後、試験に不合格になる場合は、私たちが全額返金することを保証いたします。 CiscoのSalesforce Sales-101試験に関する権威のある学習教材を見つけないで、悩んでいますか？世界中での各地の人々はほとんどCiscoのSalesforce Sales-101試験を受験しています。 知られているのはCiscoのCisco 300-815試験に合格すればITという職業でよく発展しています。 あなたはGoldmile-InfobizのCiscoのAmazon AWS-Developer-KR問題集を購入した後、私たちは一年間で無料更新サービスを提供することができます。 Microsoft SC-401J - 弊社のホームページでソフトのデモをダウンロードして利用してみます。
Updated: May 28, 2022