Goldmile-Infobizを利用したら、あなたはぜひ自信に満ちているようになり、これこそは試験の準備をするということを感じます。なぜ受験生はほとんどGoldmile-Infobizを選んだのですか。Goldmile-Infobizは実践の検査に合格したもので、Goldmile-Infobizの広がりがみんなに大きな利便性と適用性をもたらしたからです。 Goldmile-Infobizは受験者に向かって試験について問題を解決する受験資源を提供するサービスのサイトで、さまざまな受験生によって別のトレーニングコースを提供いたします。受験者はGoldmile-Infobizを通って順調に試験に合格する人がとても多くなのでGoldmile-InfobizがIT業界の中で高い名声を得ました。 全てのIT人員がそんなにられるとしたら、国はぜひ強くなります。
CCNP Enterprise 350-401 給料を倍増させることも不可能ではないです。
350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)模擬資料試験がユニバーサルになりましたから、あなたはGoldmile-Infobiz のCiscoの350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)模擬資料試験問題と解答￥を利用したらきっと試験に合格するができます。 この資格は皆さんに大きな利益をもたらすことができます。あなたはいまCiscoの350-401 トレーニング費用認定試験にどうやって合格できるかということで首を傾けているのですか。
近年、IT業種の発展はますます速くなることにつれて、ITを勉強する人は急激に多くなりました。人々は自分が将来何か成績を作るようにずっと努力しています。Ciscoの350-401模擬資料試験はIT業種に欠くことができない認証ですから、試験に合格することに困っている人々はたくさんいます。
Cisco 350-401模擬資料 - 人生には様々な選択があります。
Goldmile-InfobizのCiscoの350-401模擬資料試験トレーニング資料はPDF形式とソフトウェアの形式で提供します。それはGoldmile-InfobizのCiscoの350-401模擬資料試験の問題と解答を含まれます。そして、その学習教材の内容はカバー率が高くて、正確率も高いです。それはきっと君のCiscoの350-401模擬資料試験に合格することの良い参考資料です。もし不合格になる場合は、ご心配なく、私たちは資料の費用を全部返金します。
このような保証があれば、Goldmile-Infobizの350-401模擬資料問題集を購入しようか購入するまいかと躊躇する必要は全くないです。この問題集をミスすればあなたの大きな損失ですよ。
350-401 PDF DEMO:
QUESTION NO: 1
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.
QUESTION NO: 2
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.
QUESTION NO: 3
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.
QUESTION NO: 4
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D
QUESTION NO: 5
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
２１世紀の情報時代の到着に伴い、CiscoのSAP C_TS4FI_2023-JPN試験の認定はIT業種で不可欠な認定になっています。 IT職員の皆さんにとって、この試験のSAP C_CPI_2506認証資格を持っていないならちょっと大変ですね。 Goldmile-Infobizの CiscoのLinux Foundation CGOA試験トレーニング資料は高度に認証されたIT領域の専門家の経験と創造を含めているものです。 認証専門家や技術者及び全面的な言語天才がずっと最新のCiscoのISTQB ISTQB-CTFL試験を研究していて、最新のCiscoのISTQB ISTQB-CTFL問題集を提供します。 購入した前にCiscoのEMC D-SF-A-01ソフトのような商品の適用性をあなたに感じさせるために、我々はCiscoのEMC D-SF-A-01ソフトのデモを提供して、あなたはGoldmile-Infobizで無料でダウンロードして体験できます。
Updated: May 28, 2022