350-401試験合格攻略 & 350-401受験資格 - 350-401基礎訓練 - Goldmile-Infobiz

Goldmile-Infobizは受験者に向かって試験について問題を解決する受験資源を提供するサービスのサイトで、さまざまな受験生によって別のトレーニングコースを提供いたします。受験者はGoldmile-Infobizを通って順調に試験に合格する人がとても多くなのでGoldmile-InfobizがIT業界の中で高い名声を得ました。 350-401試験合格攻略参考書についてもっと具体的な情報を得るために、Goldmile-Infobiz会社のウエブサイトを訪問していただきます。そうすれば、実際の350-401試験合格攻略試験についての情報と特徴を得ることができます。 Ciscoの350-401試験合格攻略認定試験の最新教育資料はGoldmile-Infobizの専門チームが研究し続けてついに登場し、多くの人の夢が実現させることができます。

CCNP Enterprise 350-401 何の問題があったらお気軽に聞いてください。

CCNP Enterprise 350-401試験合格攻略 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR) 君はオンラインで無料な練習問題をダウンロードできて、100%で試験に合格しましょう。 350-401 模擬試験問題集試験がユニバーサルになりましたから、あなたはGoldmile-Infobiz のCiscoの350-401 模擬試験問題集試験問題と解答¥を利用したらきっと試験に合格するができます。それに、あなたに極大な便利と快適をもたらせます。

そしてあなたに350-401試験合格攻略試験に関するテスト問題と解答が分析して差し上げるうちにあなたのIT専門知識を固めています。350-401試験合格攻略「Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)」試験は簡単ではありません。専門的な知識が必要で、もしあなたはまだこの方面の知識を欠かれば、Goldmile-Infobizは君に向ける知識を提供いたします。

Cisco 350-401試験合格攻略 - 人生には様々な選択があります。

Ciscoの350-401試験合格攻略の認定試験の受験生は試験に合格することが難しいというのをよく知っています。しかし、試験に合格することが成功への唯一の道ですから、試験を受けることを選ばなければなりません。職業価値を高めるために、あなたは認定試験に合格する必要があります。Goldmile-Infobizが開発された試験の問題と解答は異なるターゲットに含まれていますし、カバー率が高いですから、それを超える書籍や資料が絶対ありません。大勢の人たちの利用結果によると、Goldmile-Infobizの合格率は100パーセントに達したのですから、絶対あなたが試験を受かることに重要な助けになれます。Goldmile-Infobizは唯一のあなたの向いている試験に合格する方法で、Goldmile-Infobizを選んだら、美しい未来を選んだということになります。

このような保証があれば、Goldmile-Infobizの350-401試験合格攻略問題集を購入しようか購入するまいかと躊躇する必要は全くないです。この問題集をミスすればあなたの大きな損失ですよ。

350-401 PDF DEMO:

QUESTION NO: 1
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html

QUESTION NO: 2
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.

QUESTION NO: 3
What is the difference between a RIB and a FIB?
A. The FIB is populated based on RIB content
B. The RIB is used to make IP source prefix-based switching decisions
C. The RIB maintains a mirror image of the FIB
D. The FIB is where all IP routing information is stored
Answer: A
Explanation:
CEF uses a Forwarding Information Base (FIB) to make IP destination prefix-based switching decisions.
The FIB is conceptually similar to a routing table or information base. It maintains a mirror image of the forwarding information contained in the IP routing table. When routing or topology changes occur in the network, the IP routing table is updated, and those changes are reflected in the FIB. The
FIB maintains next-hop address information based on the information in the IP routing table. Because there is a one-to-one correlation between FIB entries and routing table entries, the FIB contains all known routes and eliminates the need for route cache maintenance that is associated with earlier switching paths such as fast switching and optimum switching.
Note: In order to view the Routing information base (RIB) table, use the "show ip route" command.
To view the Forwarding Information Base (FIB), use the "show ip cef" command. RIB is in Control plane while FIB is in Data plane.

QUESTION NO: 4
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.

QUESTION NO: 5
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.

ACFE CFE-Financial-Transactions-and-Fraud-Schemes - Goldmile-Infobizの模擬テストを利用したら、これはあなたがずっと全力を尽くてもらいたいもののことが分かって、しかもそれは正に試験の準備をすることを意識します。 IT職員の皆さんにとって、この試験のAmazon AIF-C01-JPN認証資格を持っていないならちょっと大変ですね。 このような受験生はWorkday Workday-Pro-HCM-Reporting認定試験で高い点数を取得して、自分の構成ファイルは市場の需要と互換性があるように充分な準備をするのは必要です。 認証専門家や技術者及び全面的な言語天才がずっと最新のCiscoのCIPS L4M6試験を研究していて、最新のCiscoのCIPS L4M6問題集を提供します。 Goldmile-Infobiz はCiscoのMicrosoft AZ-204-KR試験に関連する知識が全部含まれていますから、あなたにとって難しい問題を全て解決して差し上げます。

Updated: May 28, 2022