それはGoldmile-InfobizのCiscoの350-401受験方法試験トレーニング資料を利用することです。これは全てのIT認証試験を受ける受験生のアドバイスです。Goldmile-Infobizのトレーニング資料を手に入れたら、あなたは成功への鍵を握るようになります。 受験生が最も早い時間で、一回だけでCiscoの350-401受験方法認定試験に合格できるために、Goldmile-Infobizはずっとがんばります。Goldmile-InfobizのCiscoの350-401受験方法試験トレーニング資料は高度に認証されたIT領域の専門家の経験と創造を含めているものです。 もしGoldmile-Infobizの350-401受験方法問題集を利用してからやはり350-401受験方法認定試験に失敗すれば、あなたは問題集を購入する費用を全部取り返すことができます。
CCNP Enterprise 350-401 我々Goldmile-Infobizはこの3つを提供します。
IT業界で発展したいなら、Ciscoの350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)受験方法試験のような国際的な試験に合格するのは重要です。 あなたの購入してから、我々はあなたにCiscoの350-401 試験解説資料の更新情況をつど提供します。このサービスは無料なのです。
それで、「就職難」の場合には、他の人々と比べて、あなたはずっと優位に立つことができます。このほど、卒業生であれば、社会人であれば、ずっと「就職難」問題が存在し、毎年、「就職氷河期」といった言葉が聞こえてくる。ブームになるIT技術業界でも、多くの人はこういう悩みがあるんですから、Ciscoの350-401受験方法の能力を把握できるのは欠かさせないない技能であると考えられます。
Cisco 350-401受験方法 - ローマは一日に建てられませんでした。
350-401受験方法問題集は唯一無にな参考資料です。350-401受験方法問題集の内容は専門的かつ全面的で、覚えやすいです。また、350-401受験方法問題集は的中率が高いです。そのいくつの点で、350-401受験方法試験に合格することを保障できます。もし、お客様は350-401受験方法問題集を買うとき、自分に適するかどうかという心配があります。その心配に対して、弊社はお客様に無料で350-401受験方法問題集のデモを提供します。そうしたら、お客様は350-401受験方法問題集を購入する前にデモをダウンロードしてやってみることができます。
Goldmile-Infobizは認定で優秀なIT資料のウエブサイトで、ここでCisco 350-401受験方法認定試験の先輩の経験と暦年の試験の材料を見つけることができるとともに部分の最新の試験の題目と詳しい回答を無料にダウンロードこともできますよ。弊社のIT技術専門家たち は質が高い問題集と答えを提供し、お客様が合格できるように努めています。
350-401 PDF DEMO:
QUESTION NO: 1
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.
QUESTION NO: 2
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
QUESTION NO: 3
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.
QUESTION NO: 4
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.
QUESTION NO: 5
What is the difference between a RIB and a FIB?
A. The FIB is populated based on RIB content
B. The RIB is used to make IP source prefix-based switching decisions
C. The RIB maintains a mirror image of the FIB
D. The FIB is where all IP routing information is stored
Answer: A
Explanation:
CEF uses a Forwarding Information Base (FIB) to make IP destination prefix-based switching decisions.
The FIB is conceptually similar to a routing table or information base. It maintains a mirror image of the forwarding information contained in the IP routing table. When routing or topology changes occur in the network, the IP routing table is updated, and those changes are reflected in the FIB. The
FIB maintains next-hop address information based on the information in the IP routing table. Because there is a one-to-one correlation between FIB entries and routing table entries, the FIB contains all known routes and eliminates the need for route cache maintenance that is associated with earlier switching paths such as fast switching and optimum switching.
Note: In order to view the Routing information base (RIB) table, use the "show ip route" command.
To view the Forwarding Information Base (FIB), use the "show ip cef" command. RIB is in Control plane while FIB is in Data plane.
ITIL ITIL-4-Foundation-JPN - Goldmile-Infobizを選られば、成功しましょう。 Workday Workday-Pro-HCM-Reporting - Goldmile-InfobizはIT試験問題集を提供するウエブダイトで、ここによく分かります。 Microsoft AZ-500J - 弊社の勉強の商品を選んで、多くの時間とエネルギーを節約こともできます。 Goldmile-Infobizが提供したCiscoのSalesforce Plat-101「Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)」試験問題と解答が真実の試験の練習問題と解答は最高の相似性があり、一年の無料オンラインの更新のサービスがあり、100%のパス率を保証して、もし試験に合格しないと、弊社は全額で返金いたします。 Goldmile-Infobizは全面的な最高のCisco EMC D-VXR-DS-00試験の資料を含め、きっとあなたの最良の選択だと思います。
Updated: May 28, 2022