多くの人々はCiscoの350-401試験解説試験に合格できるのは難しいことであると思っています。この悩みに対して、我々社Goldmile-InfobizはCiscoの350-401試験解説試験に準備するあなたに専門的なヘルプを与えられます。弊社のCiscoの350-401試験解説練習問題を利用したら、あなたは気楽に勉強するだけではなく、順調に試験に合格します。 でも、その試験はITの専門知識と経験が必要なので、合格するために一般的にも大量の時間とエネルギーをかからなければならなくて、助簡単ではありません。Goldmile-Infobizは素早く君のCisco試験に関する知識を補充できて、君の時間とエネルギーが節約させるウェブサイトでございます。 勉強中で、何の質問があると、メールで我々はあなたのためにすぐ解決します。
CCNP Enterprise 350-401 何の問題があったらお気軽に聞いてください。
CCNP Enterprise 350-401試験解説 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR) Goldmile-Infobizはあなたの最高のトレーニング資料を提供して、１００パーセントの合格率を保証します。 それに、あなたに極大な便利と快適をもたらせます。実践の検査に何度も合格したこのサイトは試験問題と解答を提供しています。
この資格は皆さんに大きな利益をもたらすことができます。あなたはいまCiscoの350-401試験解説認定試験にどうやって合格できるかということで首を傾けているのですか。Ciscoの350-401試験解説認定試験は現在のいろいろなIT認定試験における最も価値のある資格の一つです。
Cisco 350-401試験解説 - 今はそのようにしていますか。
Goldmile-InfobizのCiscoの350-401試験解説試験トレーニング資料は全てのオンラインのトレーニング資料で一番よいものです。我々の知名度はとても高いです。これは受験生の皆さんが資料を利用した後の結果です。Goldmile-InfobizのCiscoの350-401試験解説試験トレーニング資料を選んだら、１００パーセントの成功率を保証します。もし失敗だったら、我々は全額で返金します。受験生の皆さんの重要な利益が保障できるようにGoldmile-Infobizは絶対信頼できるものです。
でも、利用したことがありますか。「Goldmile-Infobizの350-401試験解説問題集は本当に良い教材です。
350-401 PDF DEMO:
QUESTION NO: 1
Which description of an SD-Access wireless network infrastructure deployment is true?
A. The wireless client is part of the fabric overlay.
B. The access point is part of the fabric underlay.
C. The WLC is part of the fabric underlay.
D. The access point is part the fabric overlay.
Answer: B
QUESTION NO: 2
Which statement about a fabric access point is true?
A. It is in local mode an must connected directly to the fabric edge switch.
B. It is in FlexConnect mode and must be connected directly to the fabric edge switch.
C. It is in FlexConnect mode and must be connected directly to the fabric border node.
D. It is in local mode an must be connected directly to the fabric border node.
Answer: A
Explanation:
Fabric mode APs continue to support the same wireless media services that traditional APs support; apply AVC, quality of service (QoS), and other wireless policies; and establish the CAPWAP control plane to the fabric WLC. Fabric APs join as local-mode APs and must be directly connected to the fabric edge node switch to enable fabric registration events, including RLOC assignment via the fabric
WLC. The fabric edge nodes use CDP to recognize APs as special wired hosts, applying special port configurations and assigning the APs to a unique overlay network within a common EID space across a fabric. The assignment allows management simplification by using a single subnet to cover the AP infrastructure at a fabric site.
Reference: https://www.cisco.com/c/en/us/td/docs/solutions/CVD/Campus/sda-sdg-2019oct.html
QUESTION NO: 3
Which feature does Cisco TrustSec use to provide scalable, secure communication throughout a network?
A. security group tag number assigned to each user on a switch
B. security group tag ACL assigned to each router on a network
C. security group tag ACL assigned to each port on a switch
D. security group tag number assigned to each port on a network
Answer: D
Explanation:
Cisco TrustSec uses tags to represent logical group privilege. This tag, called a Security Group Tag
(SGT), is used in access policies. The SGT is understood and is used to enforce traffic by Cisco switches, routers and firewalls . Cisco TrustSec is defined in three phases: classification, propagation and enforcement.
When users and devices connect to a network, the network assigns a specific security group.
This process is called classification. Classification can be based on the results of the authentication or by associating the SGT with an IP, VLAN, or port-profile (-> Answer A and answer C are not correct as they say "assigned ... on a switch" only. Answer D is not correct either as it says "assigned to each router").
QUESTION NO: 4
What is the difference between a RIB and a FIB?
A. The FIB is populated based on RIB content
B. The RIB is used to make IP source prefix-based switching decisions
C. The RIB maintains a mirror image of the FIB
D. The FIB is where all IP routing information is stored
Answer: A
Explanation:
CEF uses a Forwarding Information Base (FIB) to make IP destination prefix-based switching decisions.
The FIB is conceptually similar to a routing table or information base. It maintains a mirror image of the forwarding information contained in the IP routing table. When routing or topology changes occur in the network, the IP routing table is updated, and those changes are reflected in the FIB. The
FIB maintains next-hop address information based on the information in the IP routing table. Because there is a one-to-one correlation between FIB entries and routing table entries, the FIB contains all known routes and eliminates the need for route cache maintenance that is associated with earlier switching paths such as fast switching and optimum switching.
Note: In order to view the Routing information base (RIB) table, use the "show ip route" command.
To view the Forwarding Information Base (FIB), use the "show ip cef" command. RIB is in Control plane while FIB is in Data plane.
QUESTION NO: 5
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
ISACA CRISC - 人生には様々な選択があります。 Google Associate-Cloud-Engineer - もし不合格になる場合は、ご心配なく、私たちは資料の費用を全部返金します。 このような保証があれば、Goldmile-InfobizのHuawei H19-338-ENU問題集を購入しようか購入するまいかと躊躇する必要は全くないです。 初心者にしても、サラリーマンにしても、Goldmile-Infobizは君のために特別なCiscoのCisco 300-620問題集を提供します。 Microsoft MB-800 - こんなに重要な試験ですから、あなたも受験したいでしょう。
Updated: May 28, 2022