Goldmile-Infobizの提供するCiscoの350-401試験問題集試験の資料とソフトは経験が豊富なITエリートに開発されて、何回も更新されています。何十ユーロだけでこのような頼もしいCiscoの350-401試験問題集試験の資料を得ることができます。試験に合格してからあなたがよりよい仕事と給料がもらえるかもしれません。 安心に350-401試験問題集試験を申し込みましょう。Goldmile-Infobizの試験参考書を使用する限り、どんなに難しい試験でも問題にならないです。 我々社は最高のCisco 350-401試験問題集試験問題集を開発し提供して、一番なさービスを与えて努力しています。
CCNP Enterprise 350-401 Goldmile-Infobizが提供した商品をご利用してください。
CCNP Enterprise 350-401試験問題集 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR) あなたの試験準備にヘルプを提供するのは常にあります。 Ciscoの350-401 日本語認定のオンラインサービスのスタディガイドを買いたかったら、Goldmile-Infobizを買うのを薦めています。Goldmile-Infobizは同じ作用がある多くのサイトでリーダーとしているサイトで、最も良い品質と最新のトレーニング資料を提供しています。
初心者にとって、350-401試験問題集試験に合格するのはそんなに難しいことですか？実は、我々Goldmile-Infobizの350-401試験問題集問題集を選んで利用し、お客様は力の限りまで勉強して、合格しやすいです。万が一パースしない場合には、弊社は全額返金を承諾いたします。返金を願うのに対して、お客様は350-401試験問題集に合格しない成績書を弊社に送付して、弊社は確認の後、支払い金額を全部返済します。
Cisco 350-401試験問題集 - これは本当に素晴らしいことです。
私たちは、このキャリアの中で、10年以上にわたりプロとして350-401試験問題集練習資料を作りました。350-401試験問題集練習資料が最も全面的な参考書です。 そして、私たちは十分な耐久力を持って、ずっと350-401試験問題集練習資料の研究に取り組んでいます。私たちの350-401試験問題集練習資料を利用したら、350-401試験問題集試験に合格した人がかなり多いです。だから、弊社の350-401試験問題集練習資料を早く購入しましょう！
Goldmile-Infobizの値段よりそれが創造する価値ははるかに大きいです。あなたの予算が限られている場合に完全な問題集を必要としたら、Goldmile-InfobizのCiscoの350-401試験問題集試験トレーニング資料を試してみてください。
350-401 PDF DEMO:
QUESTION NO: 1
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
QUESTION NO: 2
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.
QUESTION NO: 3
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.
QUESTION NO: 4
What is the difference between a RIB and a FIB?
A. The FIB is populated based on RIB content
B. The RIB is used to make IP source prefix-based switching decisions
C. The RIB maintains a mirror image of the FIB
D. The FIB is where all IP routing information is stored
Answer: A
Explanation:
CEF uses a Forwarding Information Base (FIB) to make IP destination prefix-based switching decisions.
The FIB is conceptually similar to a routing table or information base. It maintains a mirror image of the forwarding information contained in the IP routing table. When routing or topology changes occur in the network, the IP routing table is updated, and those changes are reflected in the FIB. The
FIB maintains next-hop address information based on the information in the IP routing table. Because there is a one-to-one correlation between FIB entries and routing table entries, the FIB contains all known routes and eliminates the need for route cache maintenance that is associated with earlier switching paths such as fast switching and optimum switching.
Note: In order to view the Routing information base (RIB) table, use the "show ip route" command.
To view the Forwarding Information Base (FIB), use the "show ip cef" command. RIB is in Control plane while FIB is in Data plane.
QUESTION NO: 5
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.
今競争の激しいIT業界で地位を固めたいですが、Cisco EXIN CDCS認証試験に合格しなければなりません。 Goldmile-InfobizのCiscoのHuawei H31-311_V2.5試験トレーニング資料は成功したいIT職員のために作成されたのです。 PMI PMP-KR - Goldmile-Infobizは受験者に向かって試験について問題を解決する受験資源を提供するサービスのサイトで、さまざまな受験生によって別のトレーニングコースを提供いたします。 Goldmile-InfobizのCiscoのICF ICF-ACC試験トレーニング資料の値段は手頃で、IT認証の受験生のみなさんによく適用します。 今のIT業界の中で、自分の地位を固めたくて知識と情報技術を証明したいのもっとも良い方法がCiscoのVMware 2V0-13.25認定試験でございます。
Updated: May 28, 2022