あなたは350-401認定試験トレーリング資格認定証明書を取得するために350-401認定試験トレーリング試験に合格しようとしていますか？ 私たちが知っているように、350-401認定試験トレーリング資格認定証明書は高い給与、より良い職位などの利点があります。 おそらく、この時点では、私たちの350-401認定試験トレーリング学習教材の助けが必要です。350-401認定試験トレーリング学習教材は弊社の主力製品として、たくさんの受験者からいい評判をもらいました。 しかし、神様はずっと私を向上させることを要求します。Ciscoの350-401認定試験トレーリング試験を受けることは私の人生の挑戦の一つです。 弊社の商品が好きなのは弊社のたのしいです。
CCNP Enterprise 350-401 あなた自身のために、証明書をもらいます。
他の人はあちこちでCisco 350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)認定試験トレーリング試験資料を探しているとき、あなたはすでに勉強中で、準備階段でライバルに先立ちます。 現在のIT領域で競争が激しくなっていることは皆は良く知っていますから、みんなはIT認証を通じて自分の価値を高めたいです。私もそう思いますが、IT認証は私にとって大変難しいです。
350-401認定試験トレーリング練習資料が最も全面的な参考書です。そして、私たちは十分な耐久力を持って、ずっと350-401認定試験トレーリング練習資料の研究に取り組んでいます。私たちの350-401認定試験トレーリング練習資料を利用したら、350-401認定試験トレーリング試験に合格した人がかなり多いです。
Cisco 350-401認定試験トレーリング - 何の問題があったらお気軽に聞いてください。
Goldmile-InfobizのCiscoの350-401認定試験トレーリング試験トレーニング資料は豊富な経験を持っているIT専門家が研究したもので、問題と解答が緊密に結んでいるものです。Ciscoの350-401認定試験トレーリング試験トレーニング資料は現在、市場上で一番質のいい学習教材です。Goldmile-Infobizは無料でサンプルを提供することができる。うちの学習教材は君の認定試験に合格することに大変役に立ちます。
350-401認定試験トレーリング試験がユニバーサルになりましたから、あなたはGoldmile-Infobiz のCiscoの350-401認定試験トレーリング試験問題と解答￥を利用したらきっと試験に合格するができます。それに、あなたに極大な便利と快適をもたらせます。
350-401 PDF DEMO:
QUESTION NO: 1
Which feature does Cisco TrustSec use to provide scalable, secure communication throughout a network?
A. security group tag number assigned to each user on a switch
B. security group tag ACL assigned to each router on a network
C. security group tag ACL assigned to each port on a switch
D. security group tag number assigned to each port on a network
Answer: D
Explanation:
Cisco TrustSec uses tags to represent logical group privilege. This tag, called a Security Group Tag
(SGT), is used in access policies. The SGT is understood and is used to enforce traffic by Cisco switches, routers and firewalls . Cisco TrustSec is defined in three phases: classification, propagation and enforcement.
When users and devices connect to a network, the network assigns a specific security group.
This process is called classification. Classification can be based on the results of the authentication or by associating the SGT with an IP, VLAN, or port-profile (-> Answer A and answer C are not correct as they say "assigned ... on a switch" only. Answer D is not correct either as it says "assigned to each router").
QUESTION NO: 2
What is the difference between a RIB and a FIB?
A. The FIB is populated based on RIB content
B. The RIB is used to make IP source prefix-based switching decisions
C. The RIB maintains a mirror image of the FIB
D. The FIB is where all IP routing information is stored
Answer: A
Explanation:
CEF uses a Forwarding Information Base (FIB) to make IP destination prefix-based switching decisions.
The FIB is conceptually similar to a routing table or information base. It maintains a mirror image of the forwarding information contained in the IP routing table. When routing or topology changes occur in the network, the IP routing table is updated, and those changes are reflected in the FIB. The
FIB maintains next-hop address information based on the information in the IP routing table. Because there is a one-to-one correlation between FIB entries and routing table entries, the FIB contains all known routes and eliminates the need for route cache maintenance that is associated with earlier switching paths such as fast switching and optimum switching.
Note: In order to view the Routing information base (RIB) table, use the "show ip route" command.
To view the Forwarding Information Base (FIB), use the "show ip cef" command. RIB is in Control plane while FIB is in Data plane.
QUESTION NO: 3
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
QUESTION NO: 4
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.
QUESTION NO: 5
Which statement about a fabric access point is true?
A. It is in local mode an must connected directly to the fabric edge switch.
B. It is in FlexConnect mode and must be connected directly to the fabric edge switch.
C. It is in FlexConnect mode and must be connected directly to the fabric border node.
D. It is in local mode an must be connected directly to the fabric border node.
Answer: A
Explanation:
Fabric mode APs continue to support the same wireless media services that traditional APs support; apply AVC, quality of service (QoS), and other wireless policies; and establish the CAPWAP control plane to the fabric WLC. Fabric APs join as local-mode APs and must be directly connected to the fabric edge node switch to enable fabric registration events, including RLOC assignment via the fabric
WLC. The fabric edge nodes use CDP to recognize APs as special wired hosts, applying special port configurations and assigning the APs to a unique overlay network within a common EID space across a fabric. The assignment allows management simplification by using a single subnet to cover the AP infrastructure at a fabric site.
Reference: https://www.cisco.com/c/en/us/td/docs/solutions/CVD/Campus/sda-sdg-2019oct.html
長年の努力を通じて、Goldmile-InfobizのCiscoのMicrosoft DP-600J認定試験の合格率が１００パーセントになっていました。 CiscoのMicrosoft AZ-900-KR試験はIT業種に欠くことができない認証ですから、試験に合格することに困っている人々はたくさんいます。 SAP C-BCBAI-2509 - 我々係員は全日24時間で待っていますから、何か疑問があれば、お問い合わせを期待しています。 SAP C_CPI_2506 - これは受験生の皆さんが資料を利用した後の結果です。 あなたはこの重要な試験を準備するのは時間とお金がかかると聞いたことがあるかもしれませんが、それは我々提供するCiscoのAmazon SAP-C02-KRソフトを利用しなかったからです。
Updated: May 28, 2022